RedWing RC Wilga 100cc Bedienungsanleitung
Wilga 100cc
Assembly Manual
Caution!
You should not regard this plane as a toy!
To ensure safety, please read this instruction manual thoroughly
before assembly.
Building and operating a model plane requires diligent practice and
correct guidance. An inexperienced flyer can cause serious injury
and property damage.
Seek the assistance of an experienced RC pilot or model airplane
club for help with assembly, operation and maintenance to ensure
your flying experience is both enjoyable and safe.
Fly only in AMA (Academy of Model Aeronautics) approved areas.
Approved areas or areas approved by the Model Association of
your country.
Main Landing Gear Installation
Gather the main landing gear, gear cover, and the wheels
Take off the braces and insert the landing gear into the gear cover
Fix on the wheels
Install the landing gear into the fuselage by screws as shown.
Stick the gear cover onto the fuselage by tapes.
The distance to the upper screw (gear cover screw) is 130mm.
The distance of the two screws is 14mm.
This is the information for your to drill the holes (3mm) for the gear
cover screws. And also the information for the gear braces hole
that you need to drill on the gear cover.
Use 3mm taps to lock the landing gear cover
Drill another two holes on the fuselage for the gear braces.
The gear braces is for scale look. So you just need to insert the gear
braces into the fuselage
LED light
Find out the LED light system.
Insert the LED light into the holder as shown.
Find out the holes for the LED light in the wings and rudder.
The voltage for the light is 6V.
Find out the hole for the LED light on the top of the rudder and cut it
out.
Insert the LED light wire from the top of rudder, and glue it onto the
rudder.
Rudder and tail wheel Installation
Find out the steel as shown, insert it into the rudder and glue it.
Connect the rudder onto the fuselage by two pcs of carbon fiber tubes.
Connect it as shown, totally four pcs of wires.
Always do the wire insert the metal tube twice and scrimp the tube.
Insert the steel into the arm, and use screw to lock the steel with the
arms.
Findout the parts bag for the tail landing gear
Assembly it as shown
Install the tail landing gear into the fuselage tail with screws
Connect one side of the wire with the rudder and tail servo in the
fuselage.
And another side to the arm to steel the tail wheel as shown.
Inhaltsverzeichnis
Andere RedWing RC Spielzeug Handbücher
RedWing RC
RedWing RC Sbach Bedienungsanleitung
RedWing RC
RedWing RC Yak55 Bedienungsanleitung
RedWing RC
RedWing RC 30cc MXS-Bach - Red - FUSION CONCEPT Bedienungsanleitung
RedWing RC
RedWing RC Edge 540 v3 Bedienungsanleitung
RedWing RC
RedWing RC Slick Bedienungsanleitung
RedWing RC
RedWing RC EXTRA 330 50CC Bedienungsanleitung
