Reliable SWC Handbuch

Model SWC

Model SWC Sprinkler Summary

Sprinkler

Model

K-Factor gpm/psi1/2

(lpm/bar1/2)Orientation Listings & Approvals Max. Working Pressure

psi (bar)

Sprinkler

Identication

Number (SIN)

SWC 8.0 (115) Concealed Horizontal

Sidewall cULus 300 (20.7) R5962

Table A

Features

• Extended coverage quick-response sprinkler

• 300 psi (20.7 bar) rated

• Utilizes EC-9 horizontal sidewall deflector

• Convenient push-on/thread-off cover plate

• Cover plate available in a wide variety of nishes

Product Description

The Reliable Model SWC is a 300 psi (20.7 bar) rated quick-

response extended coverage concealed horizontal sidewall

sprinkler utilizing a sensitive 3.0 mm glass bulb thermal element

for use in light hazard occupancies.

The Model SWC is specically listed with and may only be

installed with the listed Reliable SWC cover plate. Refer to the

technical information on page two for specic listings and refer to

Figure 1 for dimensional information.

Table A below provides a summary of the key data and approvals

for the Model SWC. Please see page 4 for minimum flow and

pressure requirements for various coverage areas.

Additional K-factor 8.0 (115) extended coverage quick response

sprinklers can be found on Technical Bulletin 148 and 159.

www.reliablesprinkler.com

Model SWC Extended Coverage

Concealed Horizontal Sidewall Sprinkler

Bulletin 163 January 2022

Note: Do not install the Model SWC sprinkler in locations where there is positive pressure in the cavity behind the sprinkler relative to the

pressure in the protected space.

Model SWC EC Horizontal Sidewall Sprinkler SIN R5962

Technical Specications

Style: Concealed Horizontal Sidewall

Threads: 3/4” NPT or ISO 7-R3/4

Nominal K-Factor: 8.0 (115)

Max. Working Pressure: 300 psi (20.7 bar)

Material Specications

Thermal Sensor: 3 mm Glass Bulb

Sprinkler Frame: Brass Alloy

Cap: Bronze Alloy

Sealing Washer: Nickel with PTFE

Load Screw: Copper Alloy

Deflector: Brass Alloy

Sprinkler Finishes

(See Table C)

Sensitivity

Quick response

Temperature Ratings(1)

135°F (57°C)

155°F (68°C)

Cover Plate(2)

Model SWC

Sprinkler Wrenches

Model W4

Listings and Approvals

cULus for light hazard

Notes:

1. Temperature rating approval may vary depending on coverage area selected. See Table B.

2. Cover plate is rated for 135°F (57°C) and intended for use in areas where the ambient temperature does not exceed 100°F (38°C).

Model SWC Sprinkler Components and Dimensions Figure 1

Bulletin 163

January 2022

Page 2 of 4

www.reliablesprinkler.com

Note: Please refer to Table B (page 3) for minimum flow and pressure requirements.

Bulletin 163

January 2022

Page 3 of 4

www.reliablesprinkler.com

Coverage Area

ft x ft (m x m)

Deflector Distance

Inches (mm) Temperature Rating Flow

gpm (L/min)

Pressure

psi (bar)

14 x 26 (4.3 x 7.9) 4 – 6 (100 – 150) 135°F (57°C) 39 (147.6) 23.8 (1.6)

14 x 26 (4.3 x 7.9) 6 – 12 (150 – 300) 135°F (57°C)

155°F (68°C) 46 (174.1) 33.1 (2.3)

16 x 14 (4.9 x 4.3) 4 – 12 (100 – 300) 135°F (57°C)

155°F (68°C) 29 (109.8) 13.1 (0.9)

16 x 16 (4.9 x 4.9) 4 – 12 (100 – 300) 135°F (57°C)

155°F (68°C) 29 (109.8) 13.1 (0.9)

16 x 18 (4.9 x 5.5) 4 – 12 (100 – 300) 135°F (57°C)

155°F (68°C) 29 (109.8) 13.1 (0.9)

16 x 20 (4.9 x 6.0) 4 – 12 (100 – 300) 135°F (57°C) 37 (140.1) 21.4 (1.5)

16 x 22 (4.9 x 6.7) 4 – 12 (100 – 300) 135°F (57°C) 37 (140.1) 21.4 (1.5)

18 x 18 (5.5 x 5.5) 4 – 12 (100 – 300) 135°F (57°C)

155°F (68°C) 33 (124.9) 17.0 (1.2)

18 x 22 (5.5 x 6.7) 4 – 12 (100 – 300) 155°F (68°C) 40 (151.4) 25.0 (1.7)

SWC Extended Coverage Horizontal Sidewall Required Minimum Flow and Pressure Table B

Standard Finishes Special Application

Finishes

Sprinkler SWC Cover Plate Sprinkler SWC Cover Plate

Bronze(2) Chrome Plated None(2) Euro White

White Paint Off White

Black

Custom Color

Stain Chrome

Bright Brass

Notes:

1. Paint or any other coating applied over the factory nish will void all approvals and warranties.

2. The Model SWC consists of a bronze sprinkler mounted in galvanized steel cup with a nished cover plate.

Finishes(1) Table C

P/N 9999970167

Bulletin 163

January 2022

Page 4 of 4

www.reliablesprinkler.com

Installation

Reliable Model SWC sprinklers must be installed in accordance

with NFPA13 and the requirements of all applicable authorities

having jurisdiction. The sprinkler must be installed with the

Reliable sprinkler installation wrench identied in this bulletin. Any

other wrench may damage the sprinkler. The Model W4 wrench

has two sets of jaws. Use the smallest set of jaws that t on the

wrench flats of the sprinkler.

A leak free 3/4” (R3/4) sprinkler joint can be obtained with a

torque of 14 - 20 lb-ft (19 - 27 N.m) after applying a thread

sealant to the male threads of the sprinkler. Do not tighten

sprinklers over the maximum recommended installation torque.

Exceeding the maximum recommended installation torque may

cause leakage or impairment of the sprinkler.

Note: Do not install the Model SWC sprinkler in locations where

there is positive pressure in the cavity behind the sprinkler relative

to the pressure in the protected space.

Glass bulb sprinklers have orange bulb protectors or protective

caps to minimize bulb damage during shipping, handling an

installation. Reliable sprinkler installation wrenches are designed

to install sprinklers with bulb protectors in place. Remove the

bulb protector at the time when the sprinkler system is placed in

service for re protection. Removal of the bulb protector before

this time may leave the bulb vulnerable to damage. Remove bulb

protectors by undoing the clasp by hand. Do not use tools to

remove bulb protectors.

Guarantee

For the guarantee, terms, and conditions, visit www.

reliablesprinkler.com.

Ordering Information

Specify the following when ordering:

Model

• SWC Extended Coverage Horizontal

Sidewall Sprinkler

Temperature Rating

• 135°F (57°C)

• 155°F (68°C)

Sprinkler Finish

• Bronze

Pendent Cover Plate

• SWC (Conical, 135°F [57°C] only)

Cover Plate Finish

• See Table C

Sprinkler Wrench

• Model W4

Model W4 Wrench

Maintenance

Reliable Model SWC sprinklers should be inspected and the

sprinkler system maintained in accordance with NFPA 25, as well

as the requirements of any Authorities Having Jurisdiction.

Prior to installation, sprinklers should remain in the original

cartons and packaging until used. This will minimize the potential

for damage to sprinklers that could cause improper operation or

non-operation.

Do not clean sprinklers with soap and water, ammonia liquid or

any other cleaning fluids. Remove dust by gentle vacuuming

without touching the sprinkler.

Replace any sprinkler which has been painted (other than factory

applied). A stock of spare sprinklers should be maintained to allow

quick replacement of damaged or operated sprinklers. Failure to

properly maintain sprinklers may result in inadvertent operation or

non-operation during a re event.

Andere Reliable Bewässerungssystem Handbücher

Reliable

Reliable G Bedienungsanleitung

Reliable

Reliable DH80 Bedienungsanleitung

Reliable

Reliable F1FR-300 Bedienungsanleitung

Reliable

Reliable F1 LO Handbuch

Reliable

Reliable F1FR-SS Series Bedienungsanleitung

Reliable

Reliable F1FR-FS56 Bedienungsanleitung

Reliable

Reliable N252 EC Bedienungsanleitung

Reliable

Reliable DH80 Handbuch

Reliable

Reliable F1FR – 300 Bedienungsanleitung

Reliable

Reliable GFR Series Bedienungsanleitung

Reliable

Reliable N25 Bedienungsanleitung

Reliable

Reliable F3QR56 Bedienungsanleitung

Reliable

Reliable RFC Series Handbuch

Reliable

Reliable XL Bedienungsanleitung

Reliable

Reliable HL22 Bedienungsanleitung

Reliable

Reliable F4FR-NF Handbuch

Reliable

Reliable DH56 HSW-PL Bedienungsanleitung

Reliable

Reliable Pantman F1 Bedienungsanleitung

Reliable

Reliable F1FR-FS Series Bedienungsanleitung

Reliable

Reliable N252 EC Bedienungsanleitung

Reliable

Reliable G5-56 Dry Bedienungsanleitung

Reliable

Reliable G6-80 Bedienungsanleitung

Reliable

Reliable F1XLH Series Bedienungsanleitung

Reliable

Reliable DDX PrePaK Wartungshandbuch

Beliebte Bewässerungssystem Handbücher anderer Marken

Hunter

Hunter Institutional Series Bedienungsanleitung

Cellfast

Cellfast 52-305 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star Galaxy SGQR Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL A Bedienungsanleitung

Oral Care Technologies

Oral Care Technologies Hydro Floss Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem F892 Bedienungsanleitung

Netafim

Netafim NETBEAT Bedienungsanleitung

Irrigation-Mart

Irrigation-Mart KIT-GK100-RV-B Bedienungsanleitung

Tyco

Tyco CC3 Bedienungsanleitung

OpenSprinkler

OpenSprinkler OSPi Bedienungsanleitung

EINHELL

EINHELL GE-WW 5537 E Bedienungsanleitung

Valley

Valley Bender160 Bedienungsanleitung

Toro

Toro 730 Series Kurzanleitung

Eden

Eden 97063-EDAMZ Bedienungsanleitung

Tyco

Tyco TY-L Series Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL ELO-231 Bedienungsanleitung

Johnson Controls

Johnson Controls tyco ESFR-17 Bedienungsanleitung

Victaulic

Victaulic VicFlex I-VICFLEX.AQC-U Bedienungsanleitung