RIDGID WD1451 Bedienungsanleitung

ASSEMBLY

Assemblage

Montaje

Unpacking and Checking Carton Contents

Introduction

Remove entire contents of carton. Check

each item against the Carton Contents List.

Contact 1-800-4-RIDGID from the US and

Canada, 01-800-701-9811 from Mexico, or

E-mail us at [email protected] if any

parts are damaged or missing.

Phillips Screwdriver

Tools Required

Carton Contents List

Key Description Qty

A Wet/Dry Vac Assembly.................1

B Tug-A-Long Hose.........................1

C Utility Nozzle ................................1

D Wet Nozzle...................................1

E Car Nozzle ...................................1

F Extension Wands .........................2

G Owner’s Manual...........................1

This Wet/Dry Vac is intended for house-

hold use. It may be used for vacuuming

wet or dry media and may be used as a

blower.

Read this owner’s manual to familiarize

yourself with the product features and to

understand the specific usage of your

new Vac.

SP6735 RIDGID 5/31/11 2:13 PM Page 4

RID

Unpacking and Checking Carton Contents

(continued)

Carton containing the following parts:

Key Description Qty

H Accessory Storage Bag ...............1

J Caster Foot, Front........................2

K Caster Foot, Rear ........................2

Bag of Loose Parts -

Containing the following:

Key Description Qty

L 2” Caster ......................................4

M Screw, Type AB #10 x 1-3/4 ........4

SP6735 RIDGID 5/31/11 2:13 PM Page 5

To install a new filter you must first

determine which filter attachment system

is used on your Vac.

The filter cage has a stud on the end with

either screw threads to receive a filter

nut, or the Qwik Lock™ ball end which

will allow the filter to snap into place

without a filter nut or other attachment

hardware.

The stud type will determine which of the

following sets of instructions should be

used.

IMPORTANT: To avoid damage to the

blower wheel, always reinstall the filter

before using the Vac for dry material

pick-up.

Filter Removal and Installation

WARNING: Do not operate

without filter cage and float, as they

prevent liquid from entering the

impeller and damaging the motor.

— OR —

Threaded

Stud

Lid

Filter

Qwik

Lock™

Stud

Filter

Lid

SP6735 RIDGID 5/31/11 2:13 PM Page 6

Filter Removal and Installation (con’t.)

Removal and Installation

When Using the Qwik Lock™

Stud

Filter Removal:

1. Hold the filter tabs of the Qwik Lock™

filter in each hand.

2. With one thumb on the Qwik Lock™

stud, which protrudes through the

integrated filter plate, lift up on the filter

tabs while pushing down on the stud.

3. This action will cause the filter to

release from the filter cage. Slide filter

off cage.

Filter Installation:

1. Carefully slide the Qwik Lock™ filter

over the filter cage and press down on

the outside edge of the filter until the

rubber gasket on the bottom of the filter

seats securely around the base of the

filter cage and against the lid.

2. Align the small center hole in the top of

the filter over the Qwik Lock™ stud on

the filter cage. Press firmly on top of

the filter near the stud to allow the filter

to snap over the ball on the end of the

stud. The filter is now attached.

Removal and Installation When

Using the Threaded Stud

Filter Removal:

1. Unscrew nut from threaded stud.

2. Pull up on filter to remove.

Filter Installation:

1. Carefully slide the filter over the filter

cage until the threaded stud protrudes

through the small center hole in the top

of the filter. Press down on the outside

edges of the filter until the rubber

gasket on the bottom of the filter seats

securely around the base of the filter

cage and against the lid.

2. Place the filter nut onto the threaded

stud and tighten down. Finger tighten

only.

Filter

Cage

Qwik

Lock™

Stud

Filter

Tabs (2)

Integrated Filter

Plate with Center

Hole

PUSH

DOWN

PULL

Rubber

Gasket at

Bottom of

Filter

(cutaway

view)

Lid

Filter Cage

Threaded

Stud

Filter

Tabs (2)

Integrated Filter

Plate with

Center Hole Filter Nut

Rubber

Gasket at

Bottom of

Filter

(cutaway

view)

Lid

NOTE: Failure to properly seat the

bottom gasket could result in debris

bypassing the filter.

SP6735 RIDGID 5/31/11 2:13 PM Page 7

If any parts are missing or damaged

contact Customer Service.

Do not assemble until you have all the

parts.

1. Insert the front and rear caster feet into

the bottom of drum as shown. Light

taps with a mallet or hammer may be

needed to fully seat both caster feet.

2. Install (4) #10 x 1-3/4” screws into

matching holes on both front and rear

caster feet, securing them to the

bottom of the drum. Tighten screws

until just snug. Do not over tighten as

this may tend to deform the caster feet.

3. Insert the caster stem into each of the

caster feet, as shown.

4. Push on the caster until the ball on the

caster stem is inserted all the way into

the socket. You will be able to hear the

ball snap into the socket and the caster

will swivel easily when positioning is

correct.

Drum/Caster Foot Assembly

Rear

Caster

Foot

Drain

Front

Caster

Foot

Drum

Front

Caster

Foot

Drain

#10 x 1-3/4"

Screw (4)

Rear

Caster

Foot

Socket

Caster Stem

Caster Ball

SP6735 RIDGID 5/31/11 2:13 PM Page 8

Accessory

Rod

Receptacles

Accessory

Storage Bag

Rods

RID

Powerhead

Accessory

Storage Rod

Pull

Straight

Installing Accessory Storage Bag

1. Position rods of accessory storage bag

directly over accessory rod receptacles

in dust drum.

2. Slide rods of accessory storage bag

into accessory rod receptacles until

fully seated.

Accessory Storage Bag

Removing Accessory Storage

Bag

1. Pull straight up on rods of accessory

storage bag until bag is loose.

NOTE: Powerhead will need to be

removed before accessory storage bag

can be removed.

Push/Pull Handle

Cord Wrap

Power

Cord

Accessory Storage

Your accessories may be stored in the

accessory storage bag, or in the two

locations on the rear caster feet.

NOTE: Insert female end of extension

wand into the holder sleeve as shown.

Hose Storage

Areas

Accessory

Storage Bag

Female End

of Extension

Wand

RID

Cord Wrap

When vacuuming is complete, unplug the

cord and wrap it around the power

assembly as shown. The cord should wrap

under the pull handle (above the inlet) and

around and under the cord wrap of the

motor cover.

SP6735 RIDGID 5/31/11 2:13 PM Page 9

Wet/Dry Vac Assembly

1. Position the powerhead assembly on

the drum/caster foot assembly as

shown (assembled earlier).

2. Rotate both latches down and press

until you hear them snap over the

flanges on the drum.

Drum

Latch

Drum

Latch

Drum

Flange

Latch

Drum

Powerhead

Assembly

Insert Hose

Insert the push button end of the “Tug-A-

Long” hose into the inlet of the Vac. The

hose should snap into place. To remove

the hose from the Vac, press the release

button in the hose assembly and pull the

hose out of the Vac inlet, as shown.

Press

and

Pull

Release

Button

SP6735 RIDGID 5/31/11 2:13 PM Page 10

Saque todo el contenido de la caja de cartón.

Asegúrese de que no falte ningún artículo utilizando

la lista del contenido de la caja. Llame al

1-800-4-RIDGID (1-800-474-3443) desde los

EE.UU. y Canadá, y al 01-800-701-9811 desde

México, o envíenos un correo electrónico a

[email protected] si cualquier pieza está

dañada o falta.

Lista del contenido de la caja de cartón

Clave Descripción Cant.

A Ensamblaje de la aspiradora

para mojado/seco ..............................1

B Manguera arrastrable ............................1

C Boquilla de uso general..........................1

D Boquilla para mojado ............................1

E Boquilla para auto .................................1

F Tubos extensores ..................................2

G Manual del operador ..............................1

Introducción

Esta aspiradora para mojado/seco está diseñada

solamente para uso doméstico. Se puede utilizar

para recoger materiales mojados o secos y se

puede usar como soplador.

Lea este manual del usuario para familiarizarse con

las características del producto y para entender la

utilización específica de su nueva aspiradora.

Desempaquetado y comprobación del contenido

de la caja de cartón

Destornillador Phillips

Herramientas necesarias

SP6735 RIDGID 5/31/11 2:13 PM Page 22

RID

Desempaquetado y comprobación del contenido

de la caja de cartón (continuación)

Caja de cartón que contiene las piezas siguientes:

Clave Descripción Cant.

H Bolsa de almacenamiento de accesorios1

J Pie de ruedecilla delantero ....................2

K Pie de ruedecilla trasero.........................2

Bolsa de piezas sueltas que contiene lo siguiente:

Clave Descripción Cant.

L Ruedecilla de 2 pulgadas .......................4

M Tornillo de tipo AB No. 10 x 1-3/4..........4

SP6735 RIDGID 5/31/11 2:13 PM Page 23

Andere Handbücher für WD1451

Inhaltsverzeichnis

Sprachen:

Andere RIDGID Staubsauger Handbücher

RIDGID

RIDGID HDB6000 Bedienungsanleitung

RIDGID

RIDGID WD19560 Bedienungsanleitung

RIDGID

RIDGID HD0600M0 Bedienungsanleitung

RIDGID

RIDGID WD1250 Bedienungsanleitung

RIDGID

RIDGID HD1614 Bedienungsanleitung

RIDGID

RIDGID WD40500 Bedienungsanleitung

RIDGID

RIDGID wd7000 Bedienungsanleitung

RIDGID

RIDGID WD40701 Bedienungsanleitung

RIDGID

RIDGID 1000RV0 Bedienungsanleitung

RIDGID

RIDGID WD12701 Bedienungsanleitung

RIDGID

RIDGID RV24000 Bedienungsanleitung

RIDGID

RIDGID 4500RV0 Bedienungsanleitung

RIDGID

RIDGID WD1450 Bedienungsanleitung

RIDGID

RIDGID WD14500 Bedienungsanleitung

RIDGID

RIDGID WD1855BR0 Bedienungsanleitung

RIDGID

RIDGID WD16400 Bedienungsanleitung

RIDGID

RIDGID V-1225 Bedienungsanleitung

RIDGID

RIDGID R86090 Bedienungsanleitung

RIDGID

RIDGID 4000RVM0 Bedienungsanleitung

RIDGID

RIDGID RT1200M0 Bedienungsanleitung

RIDGID

RIDGID WD30500 Bedienungsanleitung

RIDGID

RIDGID HD06000 Bedienungsanleitung

RIDGID

RIDGID VAC11000 Bedienungsanleitung

RIDGID

RIDGID 6 U.S. GALLON/22.5 LITER Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch

Craftsman

Craftsman CMCVS001D1 Bedienungsanleitung