Page 5 of 6
Ironing Board Removal
On IC100 and IC200 models
Undo the screws on both spacers.
Lift the board retainer and hold the Ironing board with a slight angle to its vertical
position.
Slide the pivot rod to one side.
ilt one end of the pivot rod away from the cabinet until there is enough clearance to
slide the pivot rod out.
Slide the pivot rod out of the cabinet, remove board assembly, and replace the
board.
Reassemble the board, pivot rod and spacers in reverse order.
Lift the board to slight angle from its vertical position.
ilt one end of the board and insert one end of the pivot rod into the cabinet until
there is enough clearance to slide the other end of pivot rod into the other side of
cabinet
Adjust the pivot rod to obtain full engagement on both sides.
Ensure spacer locking tabs are correctly located under the board, tighten screws.
Care should be takes not to over tighten the screws.
ON IC300
Undo the M8 nut under the Ironing board.
Replace the Ironing board.
Replace flat washer and locknut; tighten to achieve correct locking when rotated.
