Rollease acmeda KUMO Bedienungsanleitung

KUMO

Installation manual

INDEX

1 - INTRODUCTION page 2

1.1 - Symbols used in the manual page 2

1.2 - Personnel requirements page 2

1.3 - Assembly and installation equipment page 3

1.4 - Before starting installation page 3

2 - SAFETY page 4

2.1 - General safety information page 4

3 - KUMO COMPONENTS AND DIAGRAMS page 6

3.1 - Tilting diagrams page 6

4 - KUMO TECHNICAL SHEET page 7

4.1 - Tilting diagrams page 7

5 - INTALLATION KUMO page 8

2IKUMOI INSTALLATION –REV 00

1 –INTRODUCTION

This “assembly manual” for KUMO awnings has been produced by ROLLEASE ACMEDA to supply the

indications necessary for the operations of assembling the components that make up the product.

Assembly must be carried out by personnel with suitable technical and professional qualifications, in

accordance with the respective national laws or regulations (see Par. 1.2 “Personnel requirements”).

It is forbidden to eliminate, rewrite or alter the pages in the manual and their content.

This manual must be kept intact in all its parts, in an easily accessible place.

ROLLEASE ACMEDA reserves the right to update the production and the respective manuals, without

being obliged to update the previous production andmanuals.

ROLLEASE ACMEDA reserves all rights to this manual: no total or partial reproduction is allowed without

authorisation in writing.

1.1 - Symbols used in the manual

Shown below are the WARNING symbols used in this manual:

Indications and advice to be observed to ensure a correct use of the awning. Failure to follow these

indications may endanger the integrity and/or resistance of the product.

DANGER FOR THE OPERATOR! Instructions and indications to be assessed and followed with care.

Failure to follow these indications may endanger personal safety.

1.2 - Personnel requirements

The personnel appointed to perform this operation must possess a technical knowledge of the product,

acquired by assembling similar products for at least one year or after having followed a suitable technical

training course.

IMPORTANT

ATTENTION

3I KUMO I INSTALLATION –REV 00

1.2- Assembly and installation equipment

To ensure the correct assembly of the mechanical part, of the textile part, and consequently the optimum

operation of the finished product, it is necessary to be in possession of the following equipment:

»»complete set of tools;

»»equipment for working at heights (trestles, ladders, scaffolding, overhead platforms, etc.) complying with

current occupational safety regulations;

»»rawlplugs;

»»spirit level;

»»string.

1.3- Before starting

Some components must be cut to suit the dimensions of the awning that is to be obtained (see Par.

3.3 “Table of cutting dimensions”).

IMPORTANT

4IKUMOI INSTALLATION –REV 00

2 –SAFETY

2.1 - General safety information

Follow these safety precautions:

Wear the garments and personal protection equipment contemplated by the safety regulations in force

for the workplace (protective helmet, gloves, etc.).

It is forbidden to use the awning to support yourself: risk of serious personal injury and of damage to

the awning itself.

Do not lay objects on the awning.

This manual is an integral part of the product. Before assembly, carefully read all the instructions given

in this manual.

ROLLEASE ACMEDA guarantees the EC marking only for products supplied by the company itself. If

any parts have to be replaced with other components not guaranteed by ROLLEASE ACMEDA, the

product guarantee will automatically become void and ROLLEASE ACMEDA shall not answer for any

malfunctions of the product.

Some awning components are constantly subject to strong pressure (arms) and, if the instructions in

this manual are not carefully followed, these components may cause serious harm to persons, animals

and things.

Make sure that the temporary equipment used (trestles, scaffolding, ladders, etc.) and all the personal

protective equipment (harnesses, safety belts, etc.) are regulatory and in good condition before using

them.

If the awning must be mounted on a floor higher than the ground floor, cordon off the area and make

sure no-one remains under the awning when lifting it.

ATTENTION

IMPORTANT

ATTENTION

5I KUMO I INSTALLATION –REV 00

All handling and lifting operations must be carried out with the greatest of care, making sure that all

personnel not involved keep at a safe distance; no-one must remain under suspended loads, whether

still or moving.

As regards personal safety, installation must be performed in observance of Decree of the President of

the Republic 164/56 and Legislative Decree 494/96.

During the operations described in this manual, make sure that ONLY qualified personnel enter the

work area (see Para. 1.2 “Personnel requirements”).

If the awning is installed on a floor higher than the ground floor, the person cleaning the awning must

pay greater attention to the risk of falling.

If a ladder is required during installation, make sure that it is firmly placed on the ground in order to

prevent it from tipping and causing serious injury to the people involved in installation operations.

Make sure there are no people, animals and objects nearby when the awning opens and closes.

ATTENTION

IMPORTANT

ATTENTION

6IKUMOI INSTALLATION –REV 00

3 - KUMO COMPONENTS AND DIAGRAMS

3.1 Tilting diagrams

Awning dimensions with arms folded

Wall mounting

Awning dimensions with arms folded

Roof mounting

7I KUMO I INSTALLATION –REV 00

4 - KUMO Technical sheet

Fixing bracket

8IKUMOI INSTALLATION –REV 00

5 –Intallation Kumo

Brackets position for Kumo on the wall

Brackets position for Kumo on the ceiling

Define the distance of the brackets and position them on the awning assembly frame.

L is the with of the awning

Use anchors M10, or at most M12

Define the distance of the brackets and position them on the awning assembly frame.

L is the with of the awning

Use anchors M10, or at most M12

Andere Handbücher für KUMO

Inhaltsverzeichnis

Andere rollease acmeda Zubehör Handbücher

rollease acmeda

rollease acmeda ZIPSCREEN Bedienungsanleitung

rollease acmeda

rollease acmeda KLIP Bedienungsanleitung

rollease acmeda

rollease acmeda PIUMA Bedienungsanleitung

rollease acmeda

rollease acmeda KLIP POD Bedienungsanleitung

rollease acmeda

rollease acmeda Automate Internal Sun Sensor Bedienungsanleitung

rollease acmeda

rollease acmeda AUTOMATE Installationshandbuch

rollease acmeda

rollease acmeda VEUE Bedienungsanleitung

rollease acmeda

rollease acmeda AUTOMATE Bedienungsanleitung

rollease acmeda

rollease acmeda AUTOMATE Installationshandbuch

rollease acmeda

rollease acmeda AUTOMATE Installationshandbuch

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung

rollease acmeda KUMO Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken