Sangean SG-110 Bedienungsanleitung

Version 1

SG-110

POWER / BAND button

LCD display

DBB/● STEP button

Mono/Stereo button/Time setting button

Tuning up/down button

Volume button

Lock switch

Battery compartment

Strap holder

Earphone jack

Memory button

Selected band

Battery power indicator

Signal level indicator

FM stereo indicator

90 minutes auto shut off

Memory presets

Key lock function

DBB on

Frequency

Controls

Display

For United States:

Cautions to the user

The changes or modifications not expressly

approved by the party responsible for compliance

could void the users authority to operate the

equipment.

The equipment has been tested and found

to comply with the limits for a Class B Digital

Device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy

and, if not installed and used in accordance with

the instruction, may cause harmful interference

to radio communication. However, there is no

guaranty that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to

try to correct the interference by one or more of

the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment

and receiver.

– Connect the equipment into an outlet on a

circuit different from that to which the receiver is

connected.

– Consult the dealer or an experienced radio / TV

technician for help.

Battery Installation

Battery cover is located on the back of the unit. Slide

the cover downwards to gain access to the battery

compartment. Insert two AAA (UM-4) batteries into

the compartment. Make sure that the battery is

positioned in accordance with the indicated diagram.

Replace cover.

Note:

1. You can always monitor the battery power from LCD

display battery icon. When battery power becomes

very low and unable to operate the radio, low

battery indicator will ash together with an “E“

appears on the LCD display. The radio will shut off.

2. Make sure to replace the batteries within 3 minutes.

This will prevent any memory presets from being

lost during the battery replacement.

Time setting

Press and hold the Time setting button for 2 seconds.

Hour will ash, press the Tuning up/down button to

choose your desired time and then press the Time

setting button to select the digit. After completion of

hour setting, minutes digit will then flash, following

above setting steps to set minute.

Antenna / Earphone

Insert the earphone into the earphone jack. The cord

connecting the earphone to the receiver acts as

an antenna during FM audio reception and should

be extended as much as possible to increase the

sensitivity.

A built-in ferrite bar antenna is provided for AM

reception and it is only necessary to rotate the radio

for maximum signal strength during AM listening.

Important:

Excessive sound pressure from earphones

and headphones can cause hearing loss.

To prevent possible hearing damage, do

not listen at high volume levels for long periods.

Volume Control

Use the volume control to adjust volume level.

Display will show the changes when you operate the

volume control.

Tuning the radio

Band AM

Frequency 522-1710 kHz (9kHz)

Antenna

520-1710 kHz (10kHz)

Internal/rotate radio for best reception

Band FM

Frequency 87.50-108 MHz

Antenna External/Make sure the earphone in

plugged into earphone jack

90 Minutes auto shut off device

For saving battery power, this radio is designed to

auto shut off after 90 minutes operation, LCD display

shows For continuous listening if necessary,

pressing POWER/BAND button for more than 2

seconds to turn on the radio.

Scan Tuning

Turn on the radio, select required band by pressing

POWER/BAND button. Press and hold the Tuning

up/down button for more than half a second and

release the button to commence Scan Tuning. The

radio will scan and stop automatically when a station

is found.

Manual Tuning

Turn on the radio, select desired band by pressing

POWER/BAND button. Desired station may be

selected by pressing the Tuning up/down button

repeatedly until the desired station is reached.

Memory Tuning (Station preset)

Turn on the radio by pressing and holding POWER/

BAND button. Select required band by pressing

POWER/ BAND button. Tune to the desired station

using the Scan or Manual tuning steps described

above. When the desired station is reached, press

and hold Memory button (1-5) for more than 2

seconds until display M x stops flashing followed

with a beep (via earphone). You may store 5 memory

stations in each band (AM, FMI, FMII). Stations

which are already stored in the presets may be over

written by following the above procedure.

Recall memory stations

Turn on the radio, select required band then

simply press and release Memory station button.

LCD display will show Memory preset and radio

frequency.

Stereo / Mono switch

The radio is designed to receive FM stereo

broadcastings. For weak FM station, press MO./ST.

button to switch Stereo/Mono to Mono position. LCD

display Stereo icon will disappear.

DBB (Dynamic Bass Boost)

Press and release DBB/● STEP button to activate

the Deep Bass Boost function to have stronger bass

sound, display will appear DBB symbol. Press again

will cancel the DBB.

Note:

Suggest to activate the DBB when using earphones.

Software version

The software display cannot be altered and is just for

your reference.

1. Press and hold DBB/● STEP button when your

radio is in power off mode, the screen will show

the software version (e.g. A03)

2. Continue pressing and holding the DBB/● STEP

and the radio will enter FM/AM step setting.

FM / AM step setting

3. The screen will show FM tuning step (i.e. FM1 50

or 100). Press the Tuning up/down button to choose

between 50kHz or 100kHz and then press the Time

setting button to conrm your setting.

4. After your completion of FM tuning step, the screen

will show AM tuning step (i.e. 9 or 10). Press the

Tuning up/down button to choose between 9kHz

or 10kHz and press the Time setting button to

conrm your selection.

Important:

Reset of frequency range and tuning step will erase

all the preset stations stored in your radio.

Key Lock Function

The key lock function is used to prevent unintentional

operation of the radio. Key lock switch is located

on the rear of the radio. When the key lock is set

to LOCK, every button will be disabled and a key

lock icon will appear on the screen. To disable the

key lock function, switch the key lock button to off

position. The key lock function will be disabled.

Reset the radio

If your radio fails to operate correctly or some digits

on the display are missing or incomplete, reset

the product as described below to resume normal

operation. The system reset can be carried out while

the unit is powered off.

1. Make sure your radio is switched off.

2. Press and hold the Mono/Stereo button rst, then

press and hold the Power button right after. Please

hold down these two buttons jointly until all the

icons shows on the display. Now all conguration

settings will be stored to their defaults, preset

stations will be erased and the clock will be reset.

Inhaltsverzeichnis

Andere Sangean Tragbares Radio Handbücher

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Benutzerhandbuch

Sangean

Sangean WR-3 Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean SG-102 Bedienungsanleitung

Sangean

Sangean ATS-818ACS Bedienungsanleitung

Sangean

Sangean DT-110 Betriebsanleitung

Sangean

Sangean U-3 Bedienungsanleitung

Sangean

Sangean PR-D8 Bedienungsanleitung

Sangean

Sangean DT-120CL Bedienungsanleitung

Sangean

Sangean DT-110 Bedienungsanleitung

Sangean

Sangean DT-180 Bedienungsanleitung

Sangean

Sangean PR-D1 Bedienungsanleitung

Sangean

Sangean PR-D7 Bedienungsanleitung

Sangean

Sangean U-1 Bedienungsanleitung

Sangean

Sangean DT-210 Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean ATS-606AP Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean MMR-77 Bedienungsanleitung

Sangean

Sangean WFR-32 Bedienungsanleitung

Sangean

Sangean ATS-505P Bedienungsanleitung

Sangean

Sangean PR-D4W Bedienungsanleitung

Sangean

Sangean VOCAL 170 PR-D17 Bedienungsanleitung

Sangean

Sangean WR-1 Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung