Sanyo SC-150 Bedienungsanleitung

VACUUM CLEANER

INSTRUCTION MANUAL SC-150

SC-180

Contents

IMPORTANT SAFETY

INSTRUCTIONS

FEATURES

NAMES OF PARTS

ASSEMBLING THE VACUUM

CLEANER

USING THE VACUUM CLEANER

REPLACING THE PAPER BAG

PRODUCT MAINTENANCE

TROUBLESHOOTING

REPLACEMENT PARTS

1,2

6,7

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be

followed, including the following.

READ ALL INSTRUCTIONS

BEFORE USING THIS VACUUM CLEANER

WARNING -To reduce the risk of fire, electric shock or injury:

Do not leave appliance when plugged in. Unplug from outlet when not in use

and before servicing.

Do not use outdoors or on wet surfaces.

Do not allow to be used as a toy. Close attention is necessary when used by or

near children.

Use only as described in this manual. Use only the manufacturer's recommended

attachments.

Do not use with a damaged cord or plug. If appliance is not working as it should,

has been dropped, damaged, left outdoors, or dropped into water, return it to a

service center.

Do not pull or carry by the cord, use cord as a handle, close a door on cord, or

pull cord around sharp edges or corners. Do not run appliance over cord. Keep

cleaner over the cord. Keep the cord away from heated surfaces.

Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

Do not handle plug or appliance with wet hands.

Do not put any object into the openings. Do not use with any opening blocked;

keep free of dust, lint, hair and anything that may reduce air flow.

Keep hair, loose clothing, fingers and all parts of body away from openings and

moving parts.

Do not pick up anything that is burning or smoking, such as cigarettes,

matches or hot ashes.

Do not use without filters in place.

Turn off all controls before unplugging.

Use extra care when cleaning on stairs.

Do not use to pick up flammable or combustible liquids such as gasoline, or

use in areas where they may be present.

111

Unplug before connecting any hose attachment accessory.

Do not touch the agitator while it is spinning.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade

is wider than the other). This plug will fit in a polarized outlet only one way. If the

plug dose not fit fully in the outlet, reverse the plug. If it still does not fit, contact a

qualified electrician to install the proper outlet. Do not change the plug in any way.

SAVE THESE INSTRUCTIONS

This vacuum cleaner is intended for household use only.

FEATURES

CLEANS CARPETS AND OTHER FLOORING

CLEANING IN NARROW SPACES AND HARD-TO-REACH

PLACES, SUCH AS UNDER BEDS, ETC.

TABLETOP CLEANING AND CLEANING OF SLIDING WINDOW

OR DOOR GROOVES, ETC.

WALL-MOUNTABLE STORAGE

Crevice tool

Crevice

tool

Upholstery tool &

Dusting brush

Upholstery tool &

Dusting brush

Upholstery tool &

Dusting brush

NAMES OF PARTS

WARNING:

Operate vacuum cleaner only at the voltage specified on nameplate.

FRONT

Hole for

wall-mountable

storage

Grip

Hose holder

Hose

Button

Holding latch

ON/OFF switch

Floor nozzle

SC-150 SC-180

REAR

Hose holder

Hose

Button

Holding latch

ON/OFF switch

Hole for

wall-mountable

storage

Lever

Turbine brush

Grip

Clip

Crevice tool

Power cord

Cord storage

hook

Extension pipe

Upholstery tool &

Dusting brush

ASSEMBLING THE VACUUM CLEANER

Caution: Do not connect the power plug to the wall socket until assembly is

completed.

Caution: Do not lift or carry the vacuum cleaner by the hose or extension pipes. There is a hazard if

the hose or extension pipes become detached.

Be careful not to sandwich the electrical cord between the pipe and the main unit when

inserting the holding latch into the latch slot.

Insert the hose into the main

unit.

Click into place

Button

Ring

Floor nozzle slot

Floor nozzle

mount

Floor nozzle

mount

Hose holder

Button

Holding

latch

Latch slot

Button

Pull while pressing button.

Fit the floor nozzle slot onto the

floor nozzle mount.

Hook the hose holder onto the

hose holder mount

Attach the extension pipes and the

floor nozzle as shown.

Match the imprinted numbers as

shown.

Rotate the rings in the direction shown by

the arrows and pull pipes apart.

Set the holding latch into the

latch slot.

Slide the button in

the direction shown

by the arrow.

REMOVAL

USING THE VACUUM CLEANER

Set the ON/OFF switch to " "to

operate the vacuum cleaner.

Set the ON/OFF switch to " "

to stop the vacuum cleaner.

WINDING THE POWER CORD

UNWINDING THE POWER CORD

Hook the power cord

over the clip which is

located on the upper

cord storage hook as

shown.

Wind the power cord around the cord

storage hooks.

Secure the power

cord plug on the

power cord.

Return the hook to

the upright position

before attempting

to rewind the

power cord.

Rotate the upper

cord storage hook

downward.

First, attach the main unit to the

extension pipes.

When the crevice tool is not in use

place it in the storage area

between the cord storage hooks.

ON/OFF SWITCH

POWER CORD

CREVICE TOOL

Clip

Plug side

Upper cord

storage hook

Crevice tool

USING THE VACUUM CLENER

UPHOLSTERY TOOL & DUSTING BRUSH(SC-180 only)

TURBINE BRUSH (SC-180 only)

The turbine brush has a lever with two

positions.

This rug attachment has a small, built-in

turbine that is driven by the suction force

of the unit. The turbine drives a brush

inside the attachment to pick up fine

particles more efficiently.

Caution:

Do not touch the agitator while it is spinning.

Do not vacuum bare floors with lever in "rug" position. Doing so may damage the floor.

Do not leave the brush rotating for long periods over the same spot. Doing so may

damage the carpet.

RUG

FLOOR

Lever

RUG FLOOR

Turbine

Brush

Tabs

Press the tabs downward to remove the dusting brush from the

upholstery tool.

Insert the front portion of the dusting brush into the groove located

inside the front of the upholstery tool.

Pull up on the tabs to reattach the dusting brush to the upholstery tool.

After use, fix to the extension pipe for storage as shown in the illustration.

REPLACING THE PAPER BAG

Caution: Be sure to turn the ON/OFF switch to the " "position and disconnect

the power cord from the wall outlet when replacing the paper bag.

Always make sure the paper bag is installed properly before using.

Pull the dust cover to remove it.

Throw away the used paper bag.

Slide the bag collar of the new bag into

track completely.

Remove the paper bag.

Fold down both sides of the new bag.

Return the dust cover to its original

position.

Caution:

Be careful not to clamp the paper bag with the edge of the dust cover.

Always use genuine Sanyo paper bags to assure maximum performance.

Never use your vacuum cleaner without a paper bag.

Never use a broken bag or attempt to reuse old paper bags.

Obtaining new paper bags

You can obtain new paper bags form your nearest Sanyo dealer.

Be sure to specify only genuine Sanyo vacuum cleaner bags. If bags from

any other manufacturer are used, it may have adverse effects on vacuum

cleaner performance.

SC-P11

Dust cover

Bag collar

Track

PRODUCT MAINTENANCE

Caution: Be sure to turn the ON/OFF switch to the " "position and disconnect

the power cord from the wall outlet before cleaning.

Caution: Do not use organic solvents, including thinner, or other strong cleaning liquids

such as alkaline detergents. Use of such substances may cause discoloration or

deterioration of materials resulting in deformation or cracking.

MAIN UNIT

CLEANING THE AGITATOR ASSEMBLY

When threads get caught in the agitator assembly, clean the assembly. (SC-180 only )

ELECTROSTATIC MICRON FILTER

Wet a soft cloth with neutral

detergent solution and wring

out excess liquid.

Wipe the external surfaces

of the unit.

Wipe with a dry cloth.

Remove threads caught in the agitor assembly

by cutting them with scissors.

The electrostatic micron filter should be replaced at least once every 8 months in order

to maintain cleaning performance. Only use genuine Sanyo replacement filters.

Remove the dust cover and replace

the electrostatic micron filter.

Replace the dust cover.

Caution: The electrostatic micron filter cannot be reused.

NEUTRAL

DETERGENT

Threads

Agitator assembly

Electrostatic micron filter

Dust cover

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sanyo Staubsauger Handbücher

Sanyo

Sanyo SC-X80 Bedienungsanleitung

Sanyo

Sanyo SC-840 Bedienungsanleitung

Sanyo

Sanyo VW-VF10BG Handbuch

Sanyo

Sanyo SC 53 series Bedienungsanleitung

Sanyo

Sanyo 505 SERIES Bedienungsanleitung

Sanyo

Sanyo SC-30L Bedienungsanleitung

Sanyo

Sanyo PowerBoy SC-Y130 Bedienungsanleitung

Sanyo

Sanyo SC-S700P - Powerhead Canister Vacuum Cleaner Bedienungsanleitung

Sanyo

Sanyo SC-27Y Bedienungsanleitung

Sanyo

Sanyo SC-163R Bedienungsanleitung

Sanyo

Sanyo SC-35A Bedienungsanleitung

Sanyo

Sanyo SC-B1210 Bedienungsanleitung

Sanyo

Sanyo SC-75A Bedienungsanleitung

Sanyo

Sanyo SC-183L Bedienungsanleitung

Sanyo

Sanyo SC 25 Bedienungsanleitung

Sanyo

Sanyo SC-15(M) Bedienungsanleitung

Sanyo

Sanyo SC-WP100 Bedienungsanleitung

Sanyo

Sanyo SC-270 Bedienungsanleitung

Sanyo

Sanyo SC-34A Bedienungsanleitung

Sanyo

Sanyo SC-5006 Bedienungsanleitung

Sanyo

Sanyo SC-18(L) Bedienungsanleitung

Sanyo

Sanyo SC-296T Bedienungsanleitung

Sanyo

Sanyo SC Tc4000 Bedienungsanleitung

Sanyo

Sanyo SC-5006 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung