Satel INT-TSG Bedienungsanleitung

Andere Handbücher für INT-TSG

5

Inhaltsverzeichnis

Andere Satel Tastenfeld Handbücher

Satel

Satel abax2 Bedienungsanleitung

Satel

Satel INT-TSG Bedienungsanleitung

Satel

Satel INT-KWRL2 Bedienungsanleitung

Satel

Satel INT-TSG Bedienungsanleitung

Satel

Satel INT-SF Bedienungsanleitung

Satel

Satel INT-S-GR Bedienungsanleitung

Satel

Satel INT-TSI Bedienungsanleitung

Satel

Satel INT-SF Bedienungsanleitung

Satel

Satel INT-SCR Bedienungsanleitung

Satel

Satel INT-TSG2 Bedienungsanleitung

Satel

Satel INT-TS Bedienungsanleitung

Satel

Satel CA-6 KLED Bedienungsanleitung

Satel

Satel INT-TSG2 Bedienungsanleitung

Satel

Satel CR-MF5 Bedienungsanleitung

Satel

Satel VERSA INT-TSH2 Bedienungsanleitung

Satel

Satel VERSA INT-TSH2 Benutzerhandbuch

Satel

Satel Integra INT-KSG2R Bedienungsanleitung

Satel

Satel INT-KWRL Bedienungsanleitung

Satel

Satel PERFECTA Bedienungsanleitung

Satel

Satel INT-TSG Benutzerhandbuch

Satel

Satel INT-S Series Bedienungsanleitung

Satel

Satel INT-SCR-BL Bedienungsanleitung

Satel

Satel INT-TSG Benutzerhandbuch

Satel

Satel INT-KLCDK-GR Bedienungsanleitung

Beliebte Tastenfeld Handbücher anderer Marken

ACT

ACT ACT PRO 1030 Bedienungsanleitung

Cardin

Cardin SSB Series Bedienungsanleitung

Harman Kardon

Harman Kardon KP 1 Bedienungsanleitung

Chamberlain

Chamberlain KPR2000 Benutzerhandbuch

CYP

CYP CR-KP1 Bedienungsanleitung

Aeware

Aeware k-35 Series Referenzhandbuch

Aritech

Aritech CS-175 Series Bedienungsanleitung

GE

GE NetworX NX-1600E Series Bedienungsanleitung

Lenze AC Tech

Lenze AC Tech MC SERIES Bedienungsanleitung

Burg Wächter

Burg Wächter secuENTRY 7711 Bedienungsanleitung

Aeware

Aeware in.k450 Bedienungsanleitung

Lenze

Lenze EPM-H410 Bedienungsanleitung

Toshiba

Toshiba RKP007Z Bedienungsanleitung

Gemini

Gemini GEM-DXK1 KEYPAD Bedienungsanleitung

Russound

Russound MDK-C5 Betriebsanleitung

Bosch

Bosch D1260 Series Bedienungsanleitung

Elmes Electronic

Elmes Electronic KB1 Bedienungsanleitung

Clare Controls

Clare Controls ClareOne CLR-C1-PNC Montageanleitung

®

INT-TSG

KEYPAD

int-tsg_sii_en 06/15

Quick installation guide

Full installation manual is available on www.satel.eu

The alarm system should be installed by qualified personnel.

Disconnect power before making any electrical connections.

The INT-TSG keypad is designed for indoor installation. The place of installation should be

readily accessible to the system users.

1. Open the keypad enclosure (Fig. 1). The enclosure opening tool, shown in the illustration,

is included in the keypad delivery set.

2. Place the enclosure base on the wall and mark the location of mounting holes. Be sure to

take into account the tamper element mounting hole.

3. Drill the holes for wall plugs (screw anchors).

4. Pass the cables through the opening in the enclosure base.

5. Using wall plugs (screw anchors) and screws, fasten the enclosure base to the wall.

6. Connect the DTM, CKM and COM keypad terminals to the appropriate terminals of the

control panel communication bus (Fig. 2). It is recommended that the unshielded non-

twisted cable be used for making the connection. If you use the twisted-pair type of cable,

remember that CKM (clock) and DTM (data) signals must not be sent through one

twisted-pair cable. The wires must be run in one cable. The length of cables must not

exceed 300 m.

2 SATEL

7. Connect the wires to the terminals of additional zones, if any detectors are to be

connected to them (the detectors are to be connected in the same way as to the control

panel onboard zones). The zones are supported when the keypad is connected to

INTEGRA / INTEGRA Plus control panel.

8. Connect the supply wires to the KPD and COM terminals. The keypad can be powered

directly from the control panel, from expander with power supply or from a power supply

unit.

9. Place the front panel onto the catches, snap close the enclosure.

Description of terminals

KPD - power supply input.

COM - common ground.

DTM - data.

CKM - clock.

A RS485 B - unused terminals.

Z1, Z2 - zones.

The declaration of conformity may be consulted at www.satel.eu/ce

SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND

tel. 58 320 94 00

www.satel.eu