Cat. No. 9.900.900.730
CopyRight © 2013
1 Precautions
Before using, read this instruction manual to ensure correct usage and thorough understanding of
the instrument. Incorrect handling could possibly result in personal injury or physical damage of the
unit or its accessories. The manufacturer accepts no responsibility for any damage caused by
mishandling that is beyond normal usage as defined in this manual. The manufacturer is only
responsible for the security, reliability and performance of the instrument, if the unit is operated in
accordance with the operating instructions. The installation, adjustments, changes or repairs must
be performed by authorized personnel.
For your own safety, please review the following precautions:
NEVER use a power source other than that designated for the instrument.
NEVER operate the instrument, if it has not been installed or repaired properly. Repairs must
be performed only by qualified personnel authorized by LaboGene.
NEVER use unapproved rotors and associated components. Contact the manufacturer prior
to such use to prevent possible damage to the instrument.
NEVER attempt to open the lid or move the instrument unless the rotor is completely
stopped.
NEVER operate the instrument without a rotor installed correctly and secured to the motor
shaft.
NEVER centrifuge flammable, toxic, radioactive, explosive, or corrosive materials.
When it is required to handle the Risk Group II materials that are known to be toxic,
radioactive materials or pathogenic micro-organisms, as identified in the World
recommended by WHO should be followed to ensure the safety.
(http://www.who.int/csr/resources/publications/biosafety/Labbiosafety.pdf)
NEVER exceed the rated speed or specific gravity. Samples whose density is greater than
1.2 g/mL must have reduced maximum rotational speed to avoid rotor failure.
ALWAYS load the rotor symmetrically with evenly weighted samples to avoid rotor
imbalance. If necessary, use the water blank to counterbalance the unpaired sample.
ALWAYS locate the instrument on a flat, level, rigid, and vibration free surface.
ALWAYS mark a safety zone of 30 cm around the centrifuge to indicate that neither
hazardous materials nor persons should be permitted within the area during operation, as
safety regulations required.
ALWAYS position the instrument with additional free space on each side of instrument to
ensure proper ventilation.
ALWAYS install the instrument within a temperature and humidity controlled environment.
(Permissible ambient temperature: +5 °C
ALWAYS disconnect the power supply prior to maintenance and servicing to avoid electrical
shock. Do not immerse.
ALWAYS use proven disinfection procedures when centrifuging bio-hazardous materials.
2 Introduction
The Mini centrifuge is a bench top high-speed, multi-purpose micro-centrifuge designed to be used
in medical, industrial, and scientific applications. Its user-friendly control features and compact,
space-saving design delivers maximum solid performance for your daily centrifugation needs. The
Mini is supplied with easily interchangeable rotors to accommodate micro-tubes and PCR strips.
