6POMX010000SE 034389 010420
2.0 SAFETY
2.1 Safety check
Use the product according to what is described in chapter “Intended purpose”.
During the instrument operation, follow what stated in the current standards.
Do not use the instrument if damaged on the outer cover, on the power supply plug or on the cables.
Do not take measures on non-isolated components / voltage conductors.
Keep the instrument away from solvents.
For the maintenance of the instrument, strictly comply with what’s described in this manual at the
“Maintenance” chapter.
All the interventions not specified in this manual, may be performed exclusively by Seitron assistance centres.
Otherwise, Seitron declines every responsibility about the normal operation of the instrument and on the
validity of the several homologations.
2.2 Intended purpose
This chapter describes the areas of application for which this tightness test kit is intended.
The instrument allows to verify the gas distribution lines according to what is stated on the UNI7129 and
UNI11137 standards and for the temperature and pressure measurement.
2.3 Improper use of the product
GAS T ONE should not be used:
As safety alarm instrument
In classified zones with explosion risk (ATEX or equivalent)
2.4 Precautions for the usage of the Li-Ion battery package
Pay attention while handling the battery package inside the instrument; a wrong or improper usage may lead to
heavy physical injuries and/or damages:
•Do not create a short circuit: make sure that the terminals are not in contact with metal or other conductive
materials during transportation or storage.
•Do not apply with inverted polarities.
• Do not make the batteries come in contact with liquid substances.
• Do not burn the batteries nor expose to temperature higher than 140 °F (60°C).
• Do not try to disassemble the battery.
•Do not hit or pierce the batteries. Improper use can cause damages and internal short circuits not always
externally visible. If the battery package has fallen or has been hit with an hard surface, regardless the external
shell condition:
• Stop operation;
• Dispose of the battery in compliance with the disposal instructions;
•Do not use batteries with leaks or damages.
•Charge the batteries only inside the instrument.
•If a malfunction occurs or if over heating signs occur, immediately remove the battery package from the
instrument. Warning: the battery may be hot.
