SPECIFICATIONS
Shred
No. of
Speed
Throat
Power
Voltage: 115V/1/60Hz
Controls: Manual or automatic start, stop and
reverse by electronic sensors
Dimensions: 35-1/2- H x 27-1/2-W x 19-1/2- D
Weight: 300 Ibs.
.7mm x 4.2mm
Up to 16 Sheets
40 FPM
13-3/4-
1-1/2 H.P.,@ 20Amps
OnlyuseoriginalSEMsparepartreplacements
Weguaranteetheirqualityandfunctionalreliability
Warrantyclaimson partsand/orservicemustbeapprovedbySEM'sCustomerServiceManager
HINTS FOR ORDERING SPARE PARTS
The spare parts shown on the following pages have part numbers. This spare parts list shows
the following information with respect to the spare parts to be ordered.
. PartNo . Dimensions . Item No.Quantity . Designation
In order to avoid errors and the delivery of wrong parts, each parts order should contain the
following information.
. Machine No. (See nameplate) . Machine Type
. Part No. and designation of desired spare parts . Quantity of desired spare parts
. Desired mode of shipment (e.g. post, freight) . Full address of purchaser
RECOMMENDED SPAREs/OPTIONAL ITEMS AVAILABLE
Replacement Plastic Waste Bags Part No. 640SB130
Shredder Lubricating Oil, Case of 8 pints, Part No. 6490IL8 (manual oiling)
Shredder Lubricating Oil, Case of 16 pints, Part No. 6490IL 16 (manual oiling)
Shredder Lubricating Oil, Case of4 gallons, Part No. 64701L 16 (automatic oiling)
MICROGRAPHICS"TIP"
YourSEM Model 266 Shredder is capable of destroying Micrographic material as well as paper
documents. When shredding Micrographics, follow these tips for best results:
1. Shred Micrographics ONLYwhen machine is cool, such as early in the day.
2. Always oil cutters well before shredding micrographics.Always reverse cutters after shredding
, is completeto cleanthe cuttingunit.Shreddingpaperwith micrographicswill helpto keep
machine clean and also prevent sticking of the micrographics to the cutting unit.
3. After 10 minutes of continuous shredding, stop and allow the machine to cool before
continuing. Avoid shredding for more than 10 continuous minutes at a time. If they are fed into a
hot cutting unit, the micrographics will melt to the cutting head causing severe damage.
4. Feed Rates: Microfiche 1-10 Sheets per Feed
View-Graphs 1-4 Sheets per Feed
Microfilm on Reels 1-12 Film Strips per Feed
Paper Documents 1-12 Sheets Per Feed
5. Useof SafetyGlassesis recommendedwhenshreddingmicrographics.
A
Size:
Sheets
Width: