EN – 7
SETTING UP THE METEOROLOGICAL SERVER CONNECTION
Please enter the following information in the web interface “SETUP” page shown below.
If you decide to use neither Wunderground.com nor Weathercloud.net, please leave the
checkboxesblank.
Presstodisplaytheextendedsettings.
Enter the longitude value.
Press to enable adding
a router manually.
Press to search for
a router.
Enter the latitude value.
Changing the UI interface language settings
Select the (Wi-Fi network / SSID) you wish to connect to.
Enter SSID manually if it’s not listed.
Select the router safeguarding type (usually WPA2).
Router password (leave blank if unsecured).
Enter the new Station ID and Station key assigned by the
Wundeground service.
Enter the new Station ID and Station key assigned by the
Weathercloud service.
Reservedforaveriedmeteorologicalserver,fordetails,please
contact your dealer.
Enter the new Station ID and Station key assigned to the
corresponding meteorological servers.
Select a time server
SelectthetimezonetoplaceyourWeatherstation.
Select the direction of your Weather station placement.
Selecttheplacedsensor’shemisphere(forexample,USA
and EU countries are also “N”, Australia is “S”).
Presstonishthesettings.
NOTE:
• Your default WI-FI connection will be restored when the Weather station’s WI-FI setup
has been completed.
• To stop the AP mode and restore previous settings in the AP mode, you can hold
down the [SENSOR / WI-FI] button for 6 seconds.
Timezone:Todisplayyourtimezonecurrenttime,changethetimezoneinthetimesetup
modefrom“00”(default)toyourtimezone(suchas08forHongKong).
Thetimewillbesynchronizedautomaticallyfromtheinternettimeserver,eachday
at12:00and24:00.Togettheinternettimemanuallyin1minute,youcanalsopress
[REFRESH] button.
TIME SERVER CONNECTION STATUS
When the device has been connected to the internet, it will attempt to connect to the
internet time server and get the UTC time. If this connection is successful and the device
clock is updated, the LCD display will show “SYNC“(synchronization)icon.
