Shark EP4535C Bedienungsanleitung

EP4535C

www.sharkclean.com

Owner’s Guide

Manuel du

propriétaire

TOLL FREE: 1-800-798-7398

This manual covers model:

EP4535C 31

TECHNICAL SPECIFICATIONS

Voltage: 120V.

Watts: 1400W

Amps: 12 Amps

Hertz: 60Hz

Ce manuel couvre le numéro de modèle :

EP4535C 31

SPÉCIFICATIONS TECHNIQUES

Tension : 120 V

Puissance nominale : 1 400 W

Intensité : 12 A

Hertz: 60 Hz

1www.sharkclean.com

English

Contents

Important Safety Instructions 2

Getting Started 4

Assembly 4

Using the Vacuum 5

Using the Accessories 7

Maintenance 8

Troubleshooting 10

Replacement parts 10

Warranty and Registration 11

Mesures de sécurité importantes 12

À faire au début 14

Assemblage 14

Utilisation de l’aspirateur 15

Nettoyer avec les accessoires 17

Entretien 18

Guide de dépannage 20

Pièces de rechange 20

Garantie et enregistrement 21

Merci d’avoir

fait l’achat de

l’aspirateur-

traîneau

Professionnel de

SharkMD.

Table des matières

Thank you for

purchasing

the Shark®

Professional

Canister

Vacuum

2TOLL FREE: 1-800-798-7398

GENERAL ELECTRICAL SAFETY:

1. Unplug from electrical outlet when not in use

and before servicing.

2. DO NOT use vacuum with a damaged cord or

plug.

3. DO NOT pull or carry vacuum by the cord.

4. DO NOT unplug by pulling on cord; to unplug,

grasp the plug, not the cord.

5. DO NOT handle plug or vacuum cleaner with

wet hands.

6. DO NOT run the vacuum over the power cord.

7. DO NOT close a door on the cord.

8. DO NOT pull cord around sharp corners.

9. DO NOT leave appliance unattended while

plugged in.

10. Keep power cord away from heated surfaces.

11. Turn off all controls before plugging or

unplugging vacuum cleaner.

HOSE ATTACHMENTS:

12. DO NOT use if air ﬂow is restricted; if the air

paths or the hose become blocked, turn the

vacuum cleaner off. Remove all obstructions

before you turn on the unit again.

13. Keep the end of the hose and other openings

away from face and body.

14. Keep all suction openings away from hair, face,

ﬁngers, uncovered feet or loose clothing.

15. Only use manufacturer’s recommended

attachments.

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR INJURY:

WHEN USING YOUR SHARK®

PROFESSIONAL CANISTER VACUUM,

BASIC SAFETY PRECAUTIONS SHOULD

ALWAYS BE FOLLOWED, INCLUDING THE

FOLLOWING:

READ ALL INSTRUCTIONS BEFORE USING

YOUR SHARK®PROFESSIONAL CANISTER

VACUUM.

POLARIZED PLUG:

To reduce the risk of electric shock, this appliance

has a polarized plug (one blade is wider than the

other). As a safety feature, this plug will ﬁt into

a polarized outlet only one way. If the plug does

not ﬁt fully in the outlet, reverse the plug. If it

still does not ﬁt, contact a qualiﬁed electrician

to install the proper outlet. Do not force into

the outlet or try to modify the plug to

ﬁt.

IMPORTANT SAFETY INSTRUCTIONS

For Household Use Only

3www.sharkclean.com

English

GENERAL USE:

16. Use only as described in this manual.

17. DO NOT put any objects into openings.

18. Keep your work area well lit.

19. Keep the vacuum moving over the carpet

surface at all times to avoid damaging the

carpet ﬁbers.

20. DO NOT place vacuum on unstable surfaces

such as chairs or tables.

21. DO NOT allow young children to operate

the vacuum or use as a toy. Close attention

is necessary when used near children, pets or

plants.

22. DO NOT use vacuum cleaner if it has been

dropped, damaged, left outdoors or submerged

in water. To avoid the risk of electric shock,

do not disassemble or attempt to repair the

vacuum. Return to EURO-PRO Operating LLC

for examination, repair or adjustment. Incorrect

re-assembly can cause a risk of electric shock or

injury to persons when the vacuum is used.

23. Always hold the plug and DO NOT allow to

whip when rewinding.

DUST BAGS / FILTERS:

24. Before turning on the vacuum:

• Make sure that the ﬁlter and the dust bag,

are in place after routine maintenance.

• Make sure that all components and ﬁlters are

thoroughly dry after routine cleaning.

• Only use ﬁlters and accessories provided by

EURO-PRO Operating LLC [Failure to do so

will void the warranty].

GENERAL CLEANING:

25. DO NOT run the vacuum over large-sized

objects.

26. DO NOT pick up hard or sharp objects such as

glass, nails, screws or coins that could damage

the vacuum cleaner.

27. DO NOT pick up smoking or burning objects

such as hot coals, cigarette butts or matches.

28. DO NOT pick up ﬂammable or combustible

materials such as lighter ﬂuid, gasoline,

kerosene or use in areas where they may be

present.

29. DO NOT pick up toxic solutions such as

chlorine bleach, ammonia or drain cleaner.

30. DO NOT use in an enclosed space where

vapors are present from paint, paint thinner,

moth-prooﬁng substances, ﬂammable dust or

other explosive or toxic materials.

31. DO NOT vacuum up any liquids.

32. DO NOT immerse vacuum cleaner in water or

other liquids.

33. DO NOT use outdoors or on wet surfaces; use

only on dry surfaces.

34. Use extra care when cleaning on stairs.

35. Store your appliance indoors in a cool, dry area.

SAVE THESE

INSTRUCTIONS

4TOLL FREE: 1-800-798-7398

FIRST THING’S FIRST, YOU NEED TO KNOW

WHAT’S IN THE BOX YOU JUST OPENED:

aCanister Vacuum

bFlexible Hose with Handle

cTelescoping Extension Tube

dFloor Brush

eAir Turbine Floor Nozzle

fDusting Brush

gCrevice Tool

hUpholstery Tool

iPet Power Brush

Getting Started

YOUR SHARK®PROFESSIONAL CANISTER IS EASY

TO ASSEMBLE

1Place your vacuum canister on a level surface.

DO NOT plug in the vacuum until it is fully

assembled.

2Insert the ﬂexible hose (A) into the air intake duct.

Push it in until you hear it “click“, indicating that it

is locked in place (Fig. 1).

3Insert the telescoping extension tube (B) onto the

handle end of the ﬂexible hose (Fig. 1).

4Push the end of the extension tube into the air

turbine ﬂoor nozzle (C) or the ﬂoor brush (D)

(Fig. 1).

5The crevice and upholstery tools are stored on the

top of the vacuum behind the air intake duct

(Fig. 2).

Assembly

Fig. 1

Fig. 2

5www.sharkclean.com

English

1To extend the power cord, pull it from the rear

of the vacuum to the desired length (Fig. 3). A

yellow mark on the power cord shows the ideal

cable length.

CAUTION: DO NOT pull the power cord beyond

the red mark on the power cord as this will

damage the cord.

2Plug the vacuum into an electrical wall outlet.

3Press the On/Off Button to the “On” position to

begin. (Fig. 4)

4Press the On/Off Button to the “Off” position

when ﬁnished using the vacuum.

Using the Vacuum

5To retract the power cord, press the cord rewind

button. (Fig. 5) If the cord does not fully retract,

pull it out a little and then press the rewind button

again.

WARNING: Always hold the plug and DO NOT

allow to whip when rewinding.

6To store the canister vacuum, insert the clip that is

on the back of the air turbine ﬂoor nozzle or ﬂoor

brush into the slot on the back of the vacuum.

(Fig. 6)

Fig. 3

Fig. 4

Fig. 6

Fig. 5

6TOLL FREE: 1-800-798-7398

Manual Suction Control

7The Shark®Professional Canister Vacuum includes

a quick manual suction control on the handle of

the hose. The suction power can be adjusted by

moving the slide regulator to the desired position.

(Fig. 7) By opening the slide regulator, the suction

will be reduced for vacuuming upholstery and

draperies easily. With the slide regulator closed,

you get maximum suction for vacuuming carpets.

Variable Suction Control

8For bigger cleaning jobs across all surfaces, the

Shark® Professional Canister also features a

variable suction control located on the canister.

Slide the knob from side to side to change the

level of suction. An indicator light displays the

amount of suction while in use (Fig. 8).

Using the Vacuum - cont.

OPEN

(low suction)

CLOSED

(high suction) Fig. 7

Fig. 9

Fig. 10

Fig. 8

Using the Floor Brush

9The ﬂoor brush can be used to vacuum both

carpets and bare ﬂoors. To vacuum carpets, press

the pedal down towards the front of the ﬂoor

brush (Fig. 9). This will lift the bristles on the ﬂoor

brush. If the suction is too strong, you can reduce

it by adjusting the manual suction control on the

handle of the hose. To vacuum bare ﬂoors, press

the pedal down towards the back of the ﬂoor

brush (Fig. 10).

7www.sharkclean.com

English

Using the Accessories

Using the Accessories:

The accessories can be attached to the telescoping

wand for greater reach or directly on to the handle.

1Remove the air turbine ﬂoor nozzle or ﬂoor brush

from the extension wand and then depending on

the length that you desire, just push it into the end

of the extension wand or the handle. (Fig. 11)

Fig. 11

8TOLL FREE: 1-800-798-7398

Maintenance

Replacing the Dust Bag:

1Press the On/Off Button to the “Off” position.

2Remove the ﬂexible hose from the vacuum by

squeezing the locking tabs on the neck of the hose

and pulling it out. (Fig. 14)

3Place your ﬁngers underneath the opening

indentation behind the vacuum handle and lift the

top cover up. (Fig. 15)

4Hold the cardboard collar of the dust bag and

gently pull the dust bag out. (Fig. 16)

5Holding the cardboard collar, insert a new dust bag

into the slots of the dust bag holder. (Fig. 17)

Make sure that the dust bag is inserted FULLY into

the slots of the dust bag holder.

6Close the top cover of the vacuum.

Cleaning Air Turbine Floor Nozzle:

1Detach the air turbine ﬂoor nozzle from the end

of the telescopic tube. Turn it over and using your

thumb and index ﬁnger, squeeze the locking tabs

on either side of the turbine cover and lift off.

Remove any debris found inside (Fig. 12)

2Inspect the rotating brush and carefully remove,

without damaging the bristles, any build-up of hair

or string wrapped around the rotating bristle brush

with scissors (Fig. 13).

Fig. 12

Fig. 14

Fig. 15

Fig. 16

Fig. 13

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Shark Staubsauger Handbücher

Shark

Shark Pursuit UV209 Bedienungsanleitung

Shark

Shark Navigator NV20 Series Bedienungsanleitung

Shark

Shark Navigator NV581 Bedienungsanleitung

Shark

Shark Rocket HV308Q Series Bedienungsanleitung

Shark

Shark Navigator Swivel Pro Complete NV150 Series Bedienungsanleitung

Shark

Shark ZD550 Series Bedienungsanleitung

Shark

Shark LIFT-AWAY SPEED NV771Q Series Bedienungsanleitung

Shark

Shark SV780_N 14 Installationsanleitung

Shark

Shark Rocket HV292CB Bedienungsanleitung

Shark

Shark Rotator Bedienungsanleitung

Shark

Shark SV1100 Bedienungsanleitung

Shark

Shark TURBO STCIK VAC EP600 Bedienungsanleitung

Shark

Shark NV612UK Series Bedienungsanleitung

Shark

Shark NINJA STRATOS IZ400UK Series Bedienungsanleitung

Shark

Shark DUO clean ZERO-M Lift-Away ZU700C Bedienungsanleitung

Shark

Shark Vertex DuoClean PowerFins IZ462H Bedienungsanleitung

Shark

Shark VAC-THEN-STEAM MV2010WM Bedienungsanleitung

Shark

Shark NV360K Bedienungsanleitung

Shark

Shark UV204 Kurzanleitung

Shark

Shark Rocket HV292UK Bedienungsanleitung

Shark

Shark V1828GW Bedienungsanleitung

Shark

Shark UV650 Bedienungsanleitung

Shark

Shark NV350UKS Series Bedienungsanleitung

Shark

Shark UV440 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch