SnowEx SP-65 Betriebsanleitung

CUSTOMER COPY

Madison Heights, Michigan 48071

800-725-8377

www.snowexproducts.com

Owner / Operator’s Manual

SP-65

Serial # PA-201033 and higher

This Manual Must Be Read Before Operating The Equipment

(REV B) F50753

Table of Contents

Have a question or need assistance?

SnowEx Customer Care

1-800-SALTERS

or (248) 586-3500

Monday through Friday 8:00 AM to 4:30 PM EST

Fax: (248) 691-8378

E-mail: customercare@trynexfactory.com

Website: www.snowexproducts.com

General Information ..................................................................................................................................................................................... 3

Introduction ................................................................................................................................................................................................. 4

Safety .......................................................................................................................................................................................................... 5

Operation ..................................................................................................................................................................................................... 6

Assembly Instructions ........................................................................................................................................................................... 7 - 10

Troubleshooting ......................................................................................................................................................................................... 11

Warranty .................................................................................................................................................................................................... 12

Key to Parts ............................................................................................................................................................................................... 13

Hopper Assembly Parts Breakdown

Model # SP-65 ..................................................................................................................................................................... 14 - 15

Axle Assembly Parts Breakdown

Model # SP-65 ..................................................................................................................................................................... 16 - 17

Handle Assembly Parts Breakdown

Model # SP-65 ..................................................................................................................................................................... 18 - 19

Notes .................................................................................................................................................................................................. 20 - 23

General Information

CONGRATULATIONS!

The SnowEx product you have purchased is an example of snow and ice management product at its nest! Your SnowEx product’s self

contained design is a trademark of all SnowEx products. Here’s why...

SIMPLICITY: Fewer moving parts manufactured of higher quality means minimal maintenance for your SnowEx product.

RELIABILITY: High impact linear low density polyethylene hopper, custom engineered powder coated frame.

VERSATILITY: Multi-use capability allows spreading of a variety of materials.

WARRANTY: Two years parts and labor from date of installation.

The benets you are about to recognize are that of time, money and effort.

We welcome you to the world of SnowEx Performance.

Registration

Record the following information in this manual for quick reference.

Model Number

Serial Number

Date of Purchase

Dealer Where Purchased

When ordering parts, the above information is necessary. This will help to ensure

that you receive the correct parts.

At the right is a diagram of the ID tag. This tag is located on the frame.

Please ll out the warranty card with all the necessary information to validate it. This will

also give us a record so that any safety or service information can be communicated to

you.

PA-201033

Introduction

This manual has been designed for your help. It will assist you and instruct you on the proper set-up, installation and use of this product.

Refer to the table of contents for an outline of this manual.

We require that you read and understand the contents of this manual completely (especially all safety information) before attempting any

procedure contained in this manual. Extra copies of Owner / Operator Manuals can be purchased at your SnowEx Dealer.

THIS SIGN SHOULD ALERT YOU:

The Society of Automotive Engineers has adopted this Safety Alert Symbol to pinpoint characteristics that,

if not carefully followed, can create a safety hazard. When you see this symbol in this manual or on the

machine itself, be alert! Your personal safety and the safety of others is involved.

Dened below are the Safety Alert Messages and how they will appear in this manual:

(RED)

Information that, if not carefully followed,

can cause death!

(ORANGE)

Information that, if not carefully followed,

can cause serious personal injury or death!

(YELLOW)

Information that, if not carefully followed,

can cause minor injury or damage to equipment

Safety

Before attempting any procedure in this book, these safety instructions must be read and understood by all workers who have any part in the

preparation or use of this equipment.

For your safety warning and information decals have been placed on this product to remind the operator of safety precautions . If anything

happens to mark or destroy the decals, please request new ones from SnowEx.

Remember, most accidents are preventable and caused by human error. Exercising of care and precautions

must be observed to prevent the possibility of injury to operator or others!

Never operate equipment when under the inuence of alcohol, drugs, or medications that might alter your

judgment and/or reaction time.

Before working with the spreader, secure all loose tting clothing and unrestrained hair.

Always wear safety glasses with side shields when servicing spreader. Failure to do this could result in serious

injury to the eyes.

Never attempt to lift a unit with material in it.

Never allow children to operate or climb on equipment.

Always check areas to be spread to be sure no hazardous conditions or substances are in the area.

Always inspect unit for defects: broken, worn or bent parts, weakened areas on spreader.

Remember it is the owner’s responsibility to communicate information on safe usage and proper maintenance

of all equipment.

Always make sure personnel are clear of areas of danger when using equipment.

Never weld or grind on equipment without having a re extinguisher available.

Inspect the unit periodically for defects. Parts that are broken, missing or worn out must be replaced

immediately. The unit or any part of it can not be altered without prior written permission from the

manufacturer.

Never use wet materials or materials with foreign debris with any of these spreaders. These units are designed

to handle dry, clean, free owing material.

Never leave material in hopper for long periods of time. Be aware that all salt is hygroscopic and will attract

atmospheric moisture and harden up.

SPREADER LOADING

Capacity: 1.5 Cubic Foot Hopper

Do not overload spreader. Weights of material are an average for dry materials.

Never remove spreader from vehicle with material in it as this could cause damage to the frame assembly.

Never leave materials in hopper for long periods of time, salt is hygroscopic and will attract atmospheric

moisture and harden up.

SPREADING TIPS

For a heavier pass:

Walk Slower

Increase Gate Opening

For a lighter pass:

Walk Faster

Restrict Gate Opening

For a wider pass:

Walk Faster

Spread ice melters with the storm to prevent unmanageable levels of ice.

Calculate spread pattern when near vegetation and vehicles

Gate Stop can be used to set how much salt is put down at your normal walking speed.

Material Weight Per Cubic Ft.

Rock Salt 80-90 lbs.

Sand/Salt Mix 95-120 lbs.

Spreader Operation

Model # SP-65

Assembly Instructions

Model # SP-65

STEP 1

Open Box. Remove the Axle/Spinner Assembly. Slide the Shaft Collars

from the hardware kit onto the axle - one on each side of the Gearbox

STEP 2

Slide the Hopper Frame Assemblies over the Axle – one on each side

of the Gearbox.

STEP 3

Install Drive Wheel. Slide the 2” Cotter Pin through both the wheel and

axle.

One Hole in Axle – Left.

Assembly Instructions

Model # SP-65

STEP 4

Install the other Wheel. Slide the 1.5” Cotter Pin through the Axle,

outside the Wheel.

STEP 6

Install Hopper. Put Bolts with Washers through all four holes in Hopper

and Frame. Thread on the Nuts.

STEP 5

Install Frame Stand. Attach to the Hopper Supports.

STEP 7

Put Agitator Pin through Spinner Shaft inside hopper.

STEP 8

Bolt Cable to both handles. It should be positioned so the cable points

toward the base of the handle and will be to the operator’s left. Hand-

tighten only.

Assembly Instructions

Model # SP-65

STEP 9

Put bolt through both handles at the base. Hand-Tighten only.

STEP 10

Put Handle Assembly onto frame. Insert Bolts. Hand-Tighten.

STEP 11

Tighten Bolts holding the handle together, then tighten the bolts

holding the handle to the frame.

STEP 12

Put Cable Lever into Off position. Pull Gate as far back as possible.

Attach Cable to Gate.

Assembly Instructions

Model # SP-65

STEP 13

Install Cable Clip to cable bracket.

COMPLETE.

Andere Handbücher für SP-65

Inhaltsverzeichnis

Andere SnowEx Streuer Handbücher

SnowEx

SnowEx V-Pro 32300 Bedienungsanleitung

SnowEx

SnowEx SP-85 Betriebsanleitung

SnowEx

SnowEx Renegade S150A Bedienungsanleitung

SnowEx

SnowEx SP-85 Betriebsanleitung

SnowEx

SnowEx SP-1675 Bedienungsanleitung

SnowEx

SnowEx Bulk-Pro 1875 Bedienungsanleitung

SnowEx

SnowEx VX-3210 Bedienungsanleitung

SnowEx

SnowEx V-Pro 32300 Bedienungsanleitung

SnowEx

SnowEx SP-2200 Bedienungsanleitung

SnowEx

SnowEx SP-2400 Betriebsanleitung

SnowEx

SnowEx HELIXX Bedienungsanleitung

SnowEx

SnowEx Super Maxx SP-9300XH Betriebsanleitung

SnowEx

SnowEx SP-325 Betriebsanleitung

SnowEx

SnowEx V-Maxx G2 VX-6010 Bedienungsanleitung

SnowEx

SnowEx K1-131116 Betriebsanleitung

SnowEx

SnowEx SP-575V Betriebsanleitung

SnowEx

SnowEx 7500 Bedienungsanleitung

SnowEx

SnowEx V-Pro SP-2000 Bedienungsanleitung

SnowEx

SnowEx V-Maxx G2 Bedienungsanleitung

SnowEx

SnowEx SP-85 Betriebsanleitung

SnowEx

SnowEx Sidewalk-Pro SD-95 Bedienungsanleitung

SnowEx

SnowEx SP-225-1 Betriebsanleitung

SnowEx

SnowEx VX-1500 Bedienungsanleitung

SnowEx

SnowEx VX-4200 Bedienungsanleitung

Beliebte Streuer Handbücher anderer Marken

PEQUEA

PEQUEA GT-100 Bedienungsanleitung

Herculano

Herculano H2RS9 Bedienungsanleitung

Epoke

Epoke SKE8 Bedienungsanleitung

GEA

GEA EL44 Technisches Datenblatt

Boss Snowplow

Boss Snowplow TGS 800 Bedienungsanleitung

Fisher

Fisher EMERSON 168 Series Bedienungsanleitung

Fisher

Fisher POLY-CASTER 78601 Bedienungsanleitung

TurfEx

TurfEx RS7200 Betriebsanleitung

Fayat Group

Fayat Group DYNAPAC S100 Fehlerbehebungshandbuch

Art's-Way Manufacturing

Art's-Way Manufacturing X700 Installations- und Betriebshandbuch

Ferris

Ferris Pathfinder Series Bedienungsanleitung

EASTMAN

EASTMAN CR 500 Bedienungsanleitung

Nogueira

Nogueira RoyalFlow-600 Bedienungsanleitung

Buyers

Buyers TGS05B Bedienungsanleitung

Magnum

Magnum V-BOX PV Series Beilage

Meyer's

Meyer's VB280 Bedienungsanleitung

Kramer

Kramer VM-400HDCP Bedienungsanleitung

H&S

H&S 5134 Bedienungsanleitung