Sony BKSM-R103 Bedienungsanleitung

ANALOG OUTPUT BOARD

BKSM-R103

INSTALLATION MANUAL

1st Edition

Serial No. 10001 and Higher

!WARNING

This manual is intended for qualified service personnel only.

To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that

contained in the operating instructions unless you are qualified to do so. Refer all servicing to

qualified service personnel.

!WARNUNG

Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt.

Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die

Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei

Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen. Andere als die angegeben

Wartungsarbeiten dürfen nur von Personen ausgeführt werden, die eine spezielle Befähigung

dazu besitzen.

!AVERTISSEMENT

Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin

de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les

réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres.

Pour toute réparation faire appel à une personne compétente uniquement.

1 (E)

BKSM-R103

Table of Contents

Manual Structure

Purpose of this manual ........................................................................................ 3 (E)

Contents ............................................................................................................... 3 (E)

Related manual .................................................................................................... 3 (E)

1. Overview ............................................................................................. 1-1 (E)

2. Installation

2-1. Installation of Board and Rear Panel .................................................... 2-1 (E)

2-2. Matching Connectors and Cables..........................................................2-5 (E)

2-3. Input and Output Signal of Connector .................................................. 2-5 (E)

2-4. Internal Switch ...................................................................................... 2-6 (E)

3 (E)

BKSM-R103

Purpose of this manual

This manual is the installation manual of the BKSM-R103 Analog Output Board.

This manual is intended for use by trained system and service engineers, and

describes the information regarding installation.

Contents

The following is a summary of all the section for understanding the contents of this

manual.

Section 1 Overview

Explains the overview of the BKSM-R103.

Section 2 Installation

Explains how to install the BKSM-R103 to the DSM-R1/D1, the connector informa-

tion for peripheral equipment connections, etc.

Related manual

Besides this Installation Manual, the following manual is available for the BKSM-

R103.

.Maintenance Manual (Not supplied with the BKSM-R103)

This manual describes the information that premise the service based on parts

replacement (schematic diagrams, board layouts, parts list, etc.).

If this manual is required, please contact to Sony’s service organization.

Manual Structure

1-1 (E)

BKSM-R103

The BKSM-R103 is the board which converts the output data from the decoder board of the DSM-R1/D1

into analog composite video signal and analog audio signal, and outputs these converted signals.

In the BKSM-R103, the video data from the decoder board of the DSM-R1/D1 is decoded and converted

digital to analog, then output this converted signal as analog composite video signal.

Similarly, the audio data from the decoder board is converted digital to analog, then output this converted

signal as analog audio signal.

The BKSM-R103 can be installed in the following units.

.DSM-R1 Digital Satellite Demodulator

.DSM-D1 SDTI Demultiplexer

The BKSM-R103 consists of the following components.

.APR-31 board : 1 pc.

.ANALOG OUT rear panel assembly (with 3-pin XLR connectors) *1: 1 pc.

.ANALOG OUT rear panel assembly (with 5-pin XLR connectors) *1: 1 pc.

.Coaxial cable : 1 pc.

.Harness (with white connectors) : 1 pc.

.Harness (with red connectors) *2: 1 pc.

.Screw for board installing (PWH 3x6) : 4 pcs.

.Screw for rear panel installing (B 3x6) : 4 pcs.

*1: Use either of the two panels for your purpose.

.Rear panel with 3-pin XLR connectors : Enables 2-channel audio output.

.Rear panel with 5-pin XLR connectors : Enables 4-channel audio output.

*2: When the rear panel with 3-pin XLR connectors is used, this harness is not used.

Section 1

Overview

2-1 (E)

BKSM-R103

Section 2

Installation

2-1. Installation of Board and Rear Panel

To avoid shock hazard, be sure to turn the power of the

DSM-R1/D1 off and unplug the appliance from the outlet

before installing.

Installation position

The APR-31 board can be installed in either “1” (OUT 1)

side or “2” (OUT 2) side of the DSM-R1/D1.

The installation position of the ANALOG OUT rear panel

depends on the APR-31 board position.

When the APR-31 board is installed in “1” side, install the

ANALOG OUT rear panel to the “1” side.

Similarly, when the APR-31 board is installed in “2” side,

install the ANALOG OUT rear panel to the “2” side.

OUT 2 side

OUT 1 side

DSM-R1/D1 APR-31 board

OUT 2 side

OUT 1 side

Preparations

(1) Turn the power of the DSM-R1/D1 off, then unplug

the appliance from the outlet.

(2) Remove the six screws, and remove the top panel from

the DSM-R1/D1.

DSM-R1/D1

B 4x6

Top panel

2-2 (E) BKSM-R103

1. Installation of Board

(1) Match the hole on the APR-31 board with the ejector

pin on the DEC board of the DSM-R1/D1.

(2) Connect the connector on the APR-31 board to the

connector on the DEC board.

Make sure that the connector is connected tightly.

(3) Secure the APR-31 board using the four screws (PWH

3x6) supplied with the BKSM-R103.

2. Installation of Rear Panel Assembly

(1) Remove the four screws, and remove the blank panel

from the DSM-R1/D1.

Keep the removed blank panel and screws.

(2) Secure the ANALOG OUT rear panel using the four

screws (B 3x6) supplied with the BKSM-R103.

The BKSM-R103 comes with the two varieties of the

ANALOG OUT rear panel assembly. Use either of the

two panels for your purpose.

.Rear panel with 3-pin XLR connectors :

Enables 2-channel audio output.

.Rear panel with 5-pin XLR connectors :

Enables 4-channel audio output.

2-1. Installation of Board and Rear Panel

APR-31 board

DEC board Hole

Ejector pin

Connector

APR-31 board

Ejector lever

DEC board

PWH 3x6

Blank panel

B 3x6

ANALOG OUT

rear panel assembly

B 3x6

Inhaltsverzeichnis

Andere Sony Medienkonverter Handbücher

Sony

Sony TDM-NC1 - Wi-fi Client For Streaming Music Montageanleitung

Sony

Sony PCWA-DE80 - Wireless Lan Router Bedienungsanleitung

Sony

Sony BKPF-101A Bedienungsanleitung

Sony

Sony CarrierGate PCWA-DE50 Bedienungsanleitung

Sony

Sony DSC-1024HD Bedienungsanleitung

Sony

Sony HDRC-4000 Bedienungsanleitung

Sony

Sony HKSP-313 Bedienungsanleitung

Sony

Sony XDBK-103 Bedienungsanleitung

Sony

Sony DSC-1024G Bedienungsanleitung

Sony

Sony DVMC-DA1 Bedienungsanleitung

Sony

Sony HKSP-1125 Bedienungsanleitung

Sony

Sony BKSI-2050 Bedienungsanleitung

Sony

Sony DVMC-DA2 Bedienungsanleitung

Sony

Sony MEU-WX1 Bedienungsanleitung

Sony

Sony HKPF-9000 Bedienungsanleitung

Sony

Sony DVMC-DA2 Bedienungsanleitung

Sony

Sony BKSR-2025 Bedienungsanleitung

Sony

Sony NXLK-IP50Y Bedienungsanleitung

Sony

Sony NAS-CZ1 M-Crew Bedienungsanleitung

Sony

Sony HVBK-1520 Bedienungsanleitung

Sony

Sony MVE-9000-C Bedienungsanleitung

Sony

Sony CarrierGate PCWA-DE50 Merkblatt

Sony

Sony HKSP-1125 Bedienungsanleitung

Sony

Sony Ipela SNT-EX104 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung