Star Micronics TSP600 Series Handbuch

Replacing the interface board

“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”

Federal Communications Commission Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.

This statement will be applied only for the printers marketed in U.S.A.

Statement of The Canadian Department of Communications Radio Interference Regulations

ThisdigitalapparatusdoesnotexceedtheClassAlimitsforradionoiseemissionsfrom digitalapparatussetoutintheRadioInterferenceRegulations

of the Canadian Department of Communications.

Leprésentappareilnumériquen’émetpasdebruitsradioélectriquesdépassantleslimitesapplicablesauxappareilsnumériquesdelaclasseAprescrites

dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

The above statement applies only to printers marketed in Canada.

The interface board is an option for the printer TSP600/TUP900 series.

When replacing the interface board, please use the following procedure.

Interface Board Applicable printer

IFBD-HD04 ......................RS-232C (25pin)

IFBD-HN04 ......................RS-232C (9pin) TSP

600 Series

IFBD-HC04 ......................Parallel TUP900 Series

Replacement

1. Make sure that the power cord is unplugged.

2. Remove the 2 screws.

3. Remove the interface board unit in the direction of the arrow.

4. When the new board is RS-232C interface board unit, change the setting of the

DIP Switches if necessay, referring to TSP600 User’s Manual or TBD900

Specification Manual.

5. Slide the new interface board in until it is firmly seated.

Note: Insert the interface board so that it connects with the connector.

6. Secure the interface board using the two screws.

80871230 IFTBD600

TSP600

DIP switch

(On RS

232C interface board)

Screw

Andere Handbücher für TSP600 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Star Micronics Drucker Handbücher

Star Micronics

Star Micronics TUP900 Series Kurzanleitung zur Einrichtung

Star Micronics

Star Micronics TSP700 Series Bedienungs- und Wartungshandbuch

Star Micronics

Star Micronics TSP043E Series Bedienungsanleitung

Star Micronics

Star Micronics LS-5 SERIES Bedienungsanleitung

Star Micronics

Star Micronics Delta Bedienungsanleitung

Star Micronics

Star Micronics TSP800 Series Bedienungsanleitung

Star Micronics

Star Micronics NB-15 Bedienungsanleitung

Star Micronics

Star Micronics NX-1040 Bedienungsanleitung

Star Micronics

Star Micronics NP-IO Bedienungsanleitung

Star Micronics

Star Micronics Star DP8340 Bedienungsanleitung

Star Micronics

Star Micronics DP8340RC Series Bedienungsanleitung

Star Micronics

Star Micronics LaserPrinter 8 Bedienungsanleitung

Star Micronics

Star Micronics TSP600 Series Bedienungsanleitung

Star Micronics

Star Micronics SP500 Series Bedienungsanleitung

Star Micronics

Star Micronics TSP200 Series Bedienungs- und Wartungshandbuch

Star Micronics

Star Micronics TSP600 Series Bedienungsanleitung

Star Micronics

Star Micronics TSP400 Series Bedienungs- und Wartungshandbuch

Star Micronics

Star Micronics FVP-10U Bedienungsanleitung

Star Micronics

Star Micronics Star DP8340 Bedienungsanleitung

Star Micronics

Star Micronics SP312F Bedienungsanleitung

Star Micronics

Star Micronics SP500 Series Bedienungsanleitung

Star Micronics

Star Micronics TSP400 Series Bedienungsanleitung

Star Micronics

Star Micronics TSP650 Series Bedienungsanleitung

Star Micronics

Star Micronics SP500 Series Montageanleitung

Beliebte Drucker Handbücher anderer Marken

Lexmark

Lexmark 1400 Series Handbuch

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Samsung

Samsung BIXOLON SRP-350plusF Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Epson

Epson ET-7750 Betriebsanleitung

Canon

Canon CLBR 460ps Bedienungsanleitung

Eltron

Eltron P210 Guide Bedienungsanleitung

Ricoh

Ricoh MD-P1 Bedienungsanleitung

Epson

Epson SC-F7100 series Bedienungsanleitung

Epson

Epson Stylus C40UX Bedienungsanleitung

Canon

Canon imagePASS-A2 Bedienungsanleitung

Canon

Canon S820D Bedienungsanleitung