StarTech.com SM2NGFFMBU33 Bedienungsanleitung

Manual Revision: 12/16/2014

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

SM2NGFFMBU33

USB 3.0 to M.2 NGFF SSD Enclosure

with UASP

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment o and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Changes or modications not expressly approved by StarTech.com could void the user’s

authority to operate the equipment.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.

CAN ICES-3 (B)/NMB-3(B)

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Product Diagram ....................................................................................1

Enclosure...................................................................................................................................................... 1

Internal Drive Tray..................................................................................................................................... 1

Introduction............................................................................................2

Packaging Contents ................................................................................................................................. 2

System Requirements.............................................................................................................................. 2

Hardware Installation............................................................................3

How to Use ..............................................................................................8

Connecting the Hard Drive.................................................................................................................... 8

Powering the Drive Enclosure .............................................................................................................. 8

Disconnecting the Hard Drive.............................................................................................................. 8

Initializing the Hard Drive ...................................................................................................................... 9

Technical Support ..................................................................................10

Warranty Information............................................................................10

Instruction Manual

Product Diagram

Enclosure

Internal Drive Tray

1. Drive tray screws

2. USB 3.0 Micro-B port

1. M.2 (NGFF) SSD Connector

2. Drive installation bracket

3. Drive length adjustment holes

Instruction Manual

Introduction

Packaging Contents

• 1 x USB 3.0 SATA HDD/SSD Enclosure

• 1 x USB 3.0 Cable

• 1 x SSD Mounting Screw and Stando

• 1 x Mini Screw Driver

• 1 x Instruction Manual

System Requirements

• Computer system with available USB 3.0 (5 Gbit/s) port or USB 2.0 port (480Mbps)

• M.2 NGFF SATA SSD Drive

Tool Requirements

• 5mm nut driver or small plyers

• Size 1 (PH1) Philips head screw driver

Instruction Manual

Hardware Installation

WARNING! SSD Drives and storage adapters require careful handling. If you are

not careful with your SSD Drive, lost data may result. Always handle your drive with

caution. Be sure that you are properly grounded by wearing an anti-static strap when

handling computer components or discharge yourself of any static electricity build-up

by touching a large grounded metal surface (such as the computer case) for several

seconds.

1. Using a Philips head screw driver (not included) Remote the 2 drive tray screws on

either side of the USB 3.0 Micro B port, on the front of the enclosure.

Note: The included screw driver is specically for the SSD installation screw and will

be too small to open the enclosure.

2. Remove the front plate, and slide the internal drive tray out.

Instruction Manual

3. Install your M.2 SSD into the drive tray, by following the below steps.

a. Determine if the drive installation bracket requires relocating by assessing your

drive length. The board is labeled with the respective drive types for length but if

your drive type is unknown, place your SSD next to the M.2 (NGFF) SSD connector,

note which drive installation hole matches the height of your SSD. If the bracket is

already installed in the correct position please proceed to step (d.).

b. (Only required if the drive installation bracket requires relocating) Remove

the nut holding the stando in place on the reverse side of the drive tray using a

small set of plyers or 5mm nut driver (Not included).

Instruction Manual

c. (Only required if the drive installation bracket requires relocating) Reseat

the drive installation stando in the drive installation hole that matches your SSD.

Replace the removed nut on the reverse side by using a small set of plyers or 5mm

nut driver (not included).

d. Using the included screw driver, remove the screw threaded into the drive

mounting stando.

Note: The connector on your M.2 SSD is keyed so the drive will only t one way.

Instruction Manual

e. Slide the M.2 connector on the SSD into the M.2 reciprocal connector on the drive

tray.

f. Press the drive down toward the drive mounting stando, and drive the removed

screw through the mounting hole on your SSD drive and into the drive mounting

stando using the included Philips head screw driver.

Your M.2 SSD is now installed in the internal drive tray.

4. Slide the internal drive tray back into the enclosure so that the USB 3.0 Micro B

connector is facing outward, and place back into position so that the mounting

holes line up.

Instruction Manual

5. Using a Philips head screw driver (not included), replace the 2 drive tray screws on

either side of the USB 3.0 Micro B port, on the front of the enclosure.

6. Using the included USB 3.0 cable, connect the SSD enclosure to your computer

system.

Your SSD enclosure is now ready to use.

Inhaltsverzeichnis

Andere StarTech.com Gehäuse Handbücher

StarTech.com

StarTech.com InfoSafe SAT3510U2B Bedienungsanleitung

StarTech.com

StarTech.com S251BU31REMD Bedienungsanleitung

StarTech.com

StarTech.com HSB2535SATBK Bedienungsanleitung

StarTech.com

StarTech.com RK123WALHM Bedienungsanleitung

StarTech.com

StarTech.com SAT2510BU3 Bedienungsanleitung

StarTech.com

StarTech.com USB2SLSATINT Bedienungsanleitung

StarTech.com

StarTech.com SAT3540U2E Bedienungsanleitung

StarTech.com

StarTech.com S3510BMU33ET Systemhandbuch

StarTech.com

StarTech.com S2510U2WF Bedienungsanleitung

StarTech.com

StarTech.com INFOSAFE IDE2510U2 Bedienungsanleitung

StarTech.com

StarTech.com SAT2510U2F Bedienungsanleitung

StarTech.com

StarTech.com RK2620WALHM Bedienungsanleitung

StarTech.com

StarTech.com SAT3510U2V Bedienungsanleitung

StarTech.com

StarTech.com S252BU313R Bedienungsanleitung

StarTech.com

StarTech.com HSB13SATSASB Bedienungsanleitung

StarTech.com

StarTech.com RK1820WALHM Bedienungsanleitung

StarTech.com

StarTech.com INFOSAFE IDE2510U2 Bedienungsanleitung

StarTech.com

StarTech.com SAT2510U2REM Bedienungsanleitung

StarTech.com

StarTech.com SAT2510B12U3 Bedienungsanleitung

StarTech.com

StarTech.com SAT3510U2F Bedienungsanleitung

StarTech.com

StarTech.com S352BU33HR Bedienungsanleitung

StarTech.com

StarTech.com M2E1BMU31C Bedienungsanleitung

StarTech.com

StarTech.com RK616WALM Bedienungsanleitung

StarTech.com

StarTech.com RK1219WALHM Bedienungsanleitung

Beliebte Gehäuse Handbücher anderer Marken

SilentiumPC

SilentiumPC Armis AR5 Handbuch

Pulsar

Pulsar 17/TRP80/DSPR Bedienungsanleitung

Thermaltake

Thermaltake V150 TG Bedienungsanleitung

MSI

MSI MPG SEKIRA 500X Bedienungsanleitung

Antec

Antec Dark fleet DF-10 Bedienungsanleitung

Nexans

Nexans WTC05 Bedienungsanleitung

Peavey

Peavey DS 1502 Bedienungsanleitung

D-Link

D-Link ShareCenter Pro DNS-1550-04 Bedienungsanleitung

Rosewill

Rosewill RX82-U(JBOD) Bedienungsanleitung

QNAP

QNAP SAS JBOD CLI 1.0 Bedienungsanleitung

GAMDIAS

GAMDIAS Talos P1 Bedienungsanleitung

Auvs

Auvs KR615 Bedienungsanleitung

Digitus

Digitus DA-71114 Bedienungsanleitung

CommScope

CommScope FDH 3000 Bedienungsanleitung

FS FHD-FWME4 Bedienungsanleitung

JBL

JBL CS1215T Bedienungsanleitung

Pulsar

Pulsar ARAD-S4 Bedienungsanleitung

Pulsar

Pulsar AWO454 Bedienungsanleitung