STIEBEL ELTRON DHE SL Bedienungsanleitung

STIEBEL ELTRON

DHE SL

3 Phase electric fullyelectronic controlled

instantaneous hot water system

This unit electronically switches on via a

flow wheel at 2.5ltr/min

DHE 18 SL -18.0kW / 26amps per phase

DHE 21 SL -21.0kW / 31amps per phase

DHE 27 SL -27.0kW / 39amps per phase

3 Active phases & 1 Earth (no neutral)

Maximum 60oC

Minimum 20oC

M2 Memory button

Play “” button on the cover (menu button)

M1 memory button

Trouble Shooting DHE SL

1. Unit not heating…. water coming out the tap but no temperature rise on the

cold at all. Set unit to 60degC on front lcd display before proceeding

a. Has the unit been activated – Initial start up procedure followed?

•The small square activation button pushed in fully.

See page 29 “5.10” of instruction manual for start-up procedure. The lcd

display will not come on if not activated.

If activated proceed.

b. Check power to the unit – phase to earth = 230V, phase to phase =

400V

If yes proceed, if no rectify power issue.

c. Is there an “error” message on the front of the lcd display?

If there is an error on the display, remove cover and activate the service

mode button pg33 . Follow the instructions to determine the fault – an

error code will be displayed eg. “E1, E2, E3 or E4”

If no error message proceed.

d. Check to ensure the plumbing is correct.

•Cold supply to the right side of the unit and hot out on the left when

looking at it.

Water will flow backwards through the unit but will not activate the power

to heat the water. When in service mode the flow rate will indicate

approx 3.0ltr/min even though more flow is coming out of the hot tap

(this is a good indication pipe-work is back to front).

If pipe-work correct proceed.

e. With power off and cold water isolation valve turned off remove the

outlet pipe and fit a flexi to run into a bucket or floor drain. Open isolation

valve to run water through the unit and switch power on. Re-check to

see if unit is now operating.

If temperature correct, there is an issue with the plumbing after the hot

water system. Rectify plumbing and re-test.

If temperature still not correct – replace unit.

Trouble Shooting DHE SL

2. Unit only warm…. warm water only coming out of the tap, will not get hot.

Set unit to 60degC on front lcd display before proceeding

a. Is there an “error” message on the front of the lcd display?

If there is an error on the display, remove cover and activate the service

mode button pg33. Follow the instructions to determine the fault – an

error code will be displayed eg. “E3” = outlet sensor fault.

If no error message proceed.

b. Isolate the cold supply to the hot water unit and then open up the hot

tap.

•If a tempering valve is installed only a dribble of water should come

out of the outlet. If any greater than a dribble there is a fault with the

tempering valve or a cross connection.

Try adjusting the tempering valve to eliminate the water flow from the

hot tap to a minimum. Re-test hot water system.

•If no tempering valve installed there should be no flow of water from

the outlet. If water is still flowing there is a cross connection.

Eliminate cross connection if water is still flowing.

Proceed if no water flow.

c. With the power on to the unit, “tong” the 3ea active phases to measure

for amperage. When the unit is activated you should get a reading on all

phases – the amps will vary on the unit size and flow rate v’s

temperature setting on the unit.

If no amperage on 1 or more phases the element will need to be

replaced.

If amperage on all phases proceed.

d. With power off and cold water isolation valve turned off remove the

outlet pipe and fit a flexi to run into a bucket or floor drain. Open isolation

valve to run water through the unit and switch power on. Re-check to

see if unit is now operating.

If temperature correct, there is an issue with the plumbing after the hot

water system. Rectify plumbing and re-test.

If temperature still not correct – replace unit.

Trouble Shooting DHE SL

3. Unit fluctuating…. Unit fluctuating hot and cold when showering.

Set unit to 60degC on front lcd display before proceeding

a. Is there an “error” message on the front of the lcd display?

If there is an error on the display, remove cover and activate the service

mode button pg33. Follow the instructions to determine the fault – an

error code will be displayed eg. “E3” = outlet sensor fault.

If no error message proceed.

b. Is the unit installed with a tempering valve?

If yes proceed, if no go to “b”.

•Ensure the tempering valve is a high performance model suitable for

instant hot water units. If the wrong valve is installed the unit will

fluctuate.

If correct proceed.

c. Isolate the cold supply to the hot water unit and then open up the hot

tap.

•If a tempering valve is installed only a dribble of water should come

out of the outlet. If any greater than a dribble there is a fault with the

tempering valve or a cross connection.

Try adjusting the tempering valve to eliminate the water flow from the

hot tap to a minimum. Re-test hot water system.

If correct proceed.

d. Check shower head to remove any restrictors. Note all shower heads

now have a restrictor located in them somewhere to comply with

“WELS”. This MUST be removed as it may cause the unit to fluctuate.

If restrictor found, remove and re-test. Restrictors can cause back

pressure on the unit causing it to switch on and off.

If no restrictor proceed.

e. With power off and cold water isolation valve turned off remove the

outlet pipe and fit a flexi to run into a bucket or floor drain. Open isolation

valve to run water through the unit and switch power on. Check for

temperature fluctuations.

If no fluctuating occurs there is a restriction further down the hot

plumbing pipe-work. Rectify and re-test.

If unit is still fluctuating – replace.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere STIEBEL ELTRON Boiler Handbücher

STIEBEL ELTRON

STIEBEL ELTRON DHC 3-1 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DCE 10 Plus Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON Tempra 12 B Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON PSH 30 Trend Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHF 13 C Montageanleitung

STIEBEL ELTRON

STIEBEL ELTRON Tempra 12 B Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON PSH 50 Trend Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHM 3 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DNM 3 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHCE 8 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SHZ 30 F Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SHO AC 600 7,5 Kurzanleitung

STIEBEL ELTRON

STIEBEL ELTRON CF 12 KW Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SNU 10 Plus Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SN 5 SLI comfort Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHB-E 11 SLi electronic Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHB-E 11 LCD Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON MINI 2 Technisches Datenblatt

STIEBEL ELTRON

STIEBEL ELTRON SHU 10 SLi comfort Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON HSBC 200 Technisches Datenblatt

STIEBEL ELTRON

STIEBEL ELTRON PSH 20 Plus Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SHC 10 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON SBB 300 PLUS Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON DHB 12 si Bedienungsanleitung

Beliebte Boiler Handbücher anderer Marken

Kenmore

Kenmore 153.582400 Bedienungsanleitung

clage

clage E-Mini Series Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-180 Bedienungsanleitung

Bradford White

Bradford White EF Series Bedienungsanleitung

Eccotemp

Eccotemp 40-H Bedienungsanleitung

Dimplex

Dimplex ECSd125-580 Leitfaden

Dux

Dux 32FCR6N Bedienungsanleitung

Noritz

Noritz N-132M Gebrauchsanweisung

TESY

TESY GCV7/4S 10047 Technisches Datenblatt

A.O. Smith

A.O. Smith Gphe 50 Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Fehlerbehebungshandbuch

Koryo

Koryo KWHZF15Y Bedienungsanleitung

Pentair

Pentair PSC-14-4-02 Bedienungsanleitung

GE 40M06AAG Montageanleitung

Thermor

Thermor AEROMAX SPLIT 2 Bedienungsanleitung

American Hometec

American Hometec AHQ-B03X Bedienungsanleitung

PVI

PVI MAXIM Bedienungsanleitung

Sunerg Solar Energy

Sunerg Solar Energy Calor Top 200D Betriebsanleitung