12V DAB FM Radio Adaptor
This car kit is the car digital FM audio broadcasting unit,
using a high-performance digital broadcasting processor.
With built-in encoding, modulation and transmitting of
the DAB signal to most car audio systems. A versatile
device with built-in USB charging socket.
1 : ON/OFF power switch
2 : LCD display window
3 : Multi-Key (Freq.adjust/auto search/volume control)
4 : Previous Frequency
5 : Indicator LED
6 : USB charging port (5V/2.4A)
7 : LED Power indicator
8 : Antenna terminal
9 : Next Frequency
Step 2:
1. Remove the white protective paper on black film
2. Remove the protective paper on transparent film
3. The removed white protective paper and transparent
protective paper can then be discarded.
Step 3:
Stick the black film on the metal on the inside of pillar
and the transparent film on glass; ensure there is enough
room for the connecting strip between the black and
transparent film.
Step 4: Ensure the black and transparent films are firmly
fixed to the metal and winscreen. The antenna wire can
be traced down the inside of the pillar cover.
Product Features:
1: Supports full FM Frequency
2: Auto power-Off & memory function
3: Supports USB output charging, 5V/2.4A max
4: LCD display
5: Support QPSK
6: DVB Freq 174.928Mhz--239.2MHz
Essential Note: To receive a clear signal and the
maximum number of available DAB channels, the copper
element of the SWDAB1 aerial MUST be fixed to a metal
surface. Care should be taken that there is enough free
space between the copper and clear plastic element
when fixing these items, please see these instructions.
Please Note: If the vehicle has side/front air bags in the
front pillars (indicated as a place to fit SWDAB1 in the
instructions), it is recommended to find an alternative
metal earthing location. Such as under the corner of the
roof lining near the side pillar.
Operation/Fitting Guide: First use
Insert the product into the 12V power socket and turn
switch (5) to ON position, the display screen will
illuminate and go into boot-up state. Insert one end of
antenna into the product antenna port (8), fix the other
end on car windshield glass. (Antenna installation
method and steps are shown as follows).
Step 1: Decide which side of the vehicle you want to
mount the antenna. Remove the plastic pillar cover plate
on the side chosen. Please Note: If the vehicle has
side/front air bags in the front pillars it is recommended
to find an alternative metal earthing location. Such as
under the corner of the roof lining near the side pillar.
SWDAB1 Manual AW.qxp_Layout 1 23/08/2018 12:58 Page 2
