Stryker 6390 Gebrauchs- und Pflegehandbuch

www.stryker.com 1

6390 Angle Position Sensor (APS) Calibration Instructions

TOOLS REQUIRED

• StrykerEMSUSBTool • Male-to-MaleUSBCable

• T25TorxDriver • TapeMeasure

PROCEDURE

1. Placethevehicleonalevelsurface.

2. MakesurethatthePower-LOADmainpoweristurnedon.

3. PressandholdthereleaseleveratthefootendofthePower-LOADsystemandpulltoremovethecotfromthe

vehiclepatientcompartment.

Note: The head end LED indicators turn solid green only when the cot is ready to unload.

4. Unloadthecotfromthevehicle:

• For cot models 6500/6506 & 6510/6516:

1. Pressandholdtheextend(+)buttononthecotcontrolswitchtoextendthecotbaseuntilthecotwheels

restontheground.

2. Releasetheextend(+)buttonafterthecotisnolongersupportedbytheliftingarms.Theliftingarmswill

continuemovinguntiltheyhavefullylowered.Do not unlock the cot from Power-LOAD.

• For cot models 6085/6086:

1. Operator1(footend)-Graspthecotframeatthefootend.Squeezeandholdthecotmanualrelease.

2. Operator2(side) - Graspthebase frame,liftslightly,andlower the baseframetoits fullyextended

position.Verifythatthebaseisfullyextended.

3. Operator1(FootEnd)−Releasethe cotmanualreleasetolock theundercarriageintotheextended

position.

4. Pressthedown()buttononthePower-LOADcontrolpaneltolowertheliftingarmsandcot.Do not

unlock the cot from Power-LOAD.

5. UsingaT25Torxdriver,removethetwoscrews(A)thatsecurethecovertotheleftwingassemblytogainaccess

to the USB port (Figure 1).  Save the screws and

coverforreinstallation.

6. UnscrewthecapthatprotectstheUSBport.

7. Set the laptop with the Stryker EMS USB tool

installedontopofthecotmattressatthefootend

ofthecot.

Figure 1

6390 Angle Position Sensor (APS) Calibration Instructions

2www.stryker.com

8. Plugthemale-to-maleUSBcableintotheUSBportandtoanavailableUSBportonthelaptop.

Note: Make sure that the male-to-male USB cable will not get caught on anything while the Power-LOAD

system moves in and out of the vehicle patient compartment.

9. Double-clicktheStryker EMS USB Toolicononyourdesktop.Thetoolsoftwarewillautomaticallydetectthe

Power-LOAD.

10. AftertheStrykerEMSUSBtoolandPower-LOADareconnected,clickAdvanced andthenclickCalibrate APS.

11. IntheEnter Passwordfield,enterStryker1andclickEnter.

12. Loadthecotintothevehicle:

• For cot models 6500/6506 & 6510/6516:

• Pressandholdtheretract(–)buttononthecotcontrolswitchtofullyretractthecotundercarriageuntil

thecotissupported.

• For cot models 6085/6086:

• Presstheup()buttononthePower-LOADcontrolpaneltoraisetheliftingarmstothehighestposition.

Note: The cot legs do not retract.

• Operator1(FootEnd)−Graspthecotframeatthefootend.Squeezeandholdthecotmanualrelease.

• Operator2(Side)−Stabilizethecotbyplacingonehandontheouterrail.Graspthebaseframe.After

thefootendoperatorhassqueezedthecotmanualrelease,retracttheundercarriagewithonehandand

holditinplace.

• Operator 1 (Foot End) - Release the cot manual release to lock the undercarriage in the retracted

position.Ensurethatthecotmanualreleaseisreleased.Ifitisnotreleased,thecotbasewillextend

preventingthecotfromlockinginthefastener.

13. Pushthecotintothevehiclepatientcompartmentuntilthefootendcotwheelsareoverthefloorofthevehicle

patientcompartment,butnotinthefullinandlockedposition.

www.stryker.com 3

6390 Angle Position Sensor (APS) Calibration Instructions

Figure 3

14. Using a tape measure, measure the distance from the

bottomofthefootendcotwheeltothefloorwiththecot

wheelfacingthebackofthevehiclepatientcompartment

(Figure2).Makesurethatthedistancebetweenthebot tom

ofthefootendcotwheeltotheflooris2in.

• Ifthemeasurementismorethan2in,clickDecrement

(-) on the Connected to Trolley calibration screen

(Figure3).

• Ifthemeasurementislessthan2in,clickIncrement

(+) on the Connected to Trolley calibration screen

(Figure3).

15. Graspthecotframeatthefootendto

pullthecotoutofthevehiclepatient

compartment.

Note: The head end LED indicators

turn solid green only when the cot is

ready to unload.

16. Unload the cotfrom the vehicle(see

steps3-4onpage1).

17.  Load the cot into the vehicle (see

steps12-13onpage2).

18. Repeatsteps12-17untilthe distance

between the bottom of the foot end

cotwheeltotheflooris2in.

19. Unplug the male-to-male USB cable

fromthePower-LOADUSBport.

20. Screw the USB port cap back on to

theUSBport.

21. UsingaT25Torxdriver,reinstallthetwoscrews(removedinstep5)tosecurethecovertotheleftwingassembly.

Note: Make sure that the extruded “U” nut does not rotate clockwise when you tighten the bottom right T25

Torx screw on the left wing assembly cover.

22. Verifyproperoperationoftheproductbeforereturningittoservice.

3800E.CentreAve.,Portage,MI49002

1-800-327-0770|2014/01

Figure 2

2”

RearDoor

Andere Handbücher für 6390

Inhaltsverzeichnis

Andere Stryker Medizinische Geräte Handbücher

Stryker

Stryker Isolibrium PE Bedienungsanleitung

Stryker

Stryker LIFEPAK 15 Bedienungsanleitung

Stryker

Stryker CORE 2 Bedienungsanleitung

Stryker

Stryker Secure II 3002 Bedienungsanleitung

Stryker

Stryker InterPulse 0210 000 Series Bedienungsanleitung

Stryker

Stryker GoBed II Bedienungsanleitung

Stryker

Stryker Altrix 8001 Bedienungsanleitung

Stryker

Stryker 3002 Bedienungsanleitung

Stryker

Stryker Gynnie Bedienungsanleitung

Stryker

Stryker Secure Connect Handbuch

Stryker

Stryker S3 MEDSURG BED Bedienungsanleitung

Stryker

Stryker Nara Bedienungsanleitung

Stryker

Stryker Crossfire 2 Bedienungsanleitung

Stryker

Stryker 240-099-156 Bedienungsanleitung

Stryker

Stryker cub Bedienungsanleitung

Stryker

Stryker Prime TC 1450 Handbuch

Stryker

Stryker Reprocessed Stanley Bed Alarm Sensor Pad Bedienungsanleitung

Stryker

Stryker Mul-T-Pad 8002-062-612 Bedienungsanleitung

Stryker

Stryker LigaSure Impact Bedienungsanleitung

Stryker

Stryker 6082 RUGGED MX-PRO Bedienungsanleitung

Stryker

Stryker 5050 Bedienungsanleitung

Stryker

Stryker Ultra Comfort SE 1703 Bedienungsanleitung

Stryker

Stryker 1027 Bedienungsanleitung

Stryker

Stryker ARGAIOS Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung

Romet

Romet R210 Bedienungsanleitung