Stryker LIFEPAK 15 Bedienungsanleitung

Page A

LIFEPAK 15 Monitor/Deﬁbrillator

Pocket guide

LIFEPAK®15

Monitor/Defibrillator

This is not the complete instructions

for use. Refer to the Operating

Instructions for complete device

information including directions

for use, indications and warnings.

Page 1

LIFEPAK 15 Monitor/Deﬁbrillator

Home screen

SPO2 %

CO2 mmHg

ART mmHg

CVP mmHg

NIBP mmHg

150

Heart rate

SpO2/SpCO/

SpMet

EtCO2

IP1

or temperature

IP2

NIBP

Channel 1

Channel 2

Channel 3

Message area

Heart symbol

Alarm limits Bluetooth®indicator

Battery indicator

Selected energy

ECG Lead/Size

Alarm indicator

Time

Battery indicators

Indicator Description

Active

battery

Low

battery

Very

low

battery

The debrillator is using the battery in well

1 for power. Battery status indicators display

up to 4 green bars. Each green bar represents

approximately 25% remaining charge. For example,

3 green bars indicate about 75% remaining charge.

Battery in well 1 is in use and is low. One yellow

bar indicates 5% to 10% remaining charge.

Battery in well 1 is in use and is very low; 1 red

ashing bar indicates 0 to 5% remaining charge.

The debrillator automatically switches to the

other battery only if adequate charge is available.

If both batteries show red bars, the REPLACE

BATTERY voice prompt occurs.

Page 2

LIFEPAK 15 Monitor/Deﬁbrillator

To connect a therapy cable

to the defibrillator:

To disconnect the therapy cable

from the defibrillator:

QUIK-COMBO®Electrodes

with REDI-PAKTM preconnect system

• Reads ECG with lead II

• Delivers debrillation shock

• Delivers external pacing

Therapy cable

connector

QUIK-COMBO

electrode connector

QUIK-COMBO

Therapy Electrodes

Lateral

Connecting therapy electrodes

Connecting therapy cable to debrillator

Listen for click

Page 3

LIFEPAK 15 Monitor/Deﬁbrillator

GREEN ON button turns device on and off

ENERGY SELECT increases or decreases

energy level while in Manual Mode

CHARGE charges the device in Manual Mode

SHOCK initiates discharge of the debrillator

energy to the patient

ANALYZE initiates analysis in AED Mode

CPR initiates or silences METRONOME feature CPR

SYNC activates synchronization mode

Manual debrillation controls

Page 4

LIFEPAK 15 Monitor/Deﬁbrillator

Noninvasive pacing procedure

Demand pacing

1. Press ON

2. Apply ECG electrodes

3. Apply and connect QUIK-COMBO®therapy electrodes;

consider sedation if patient is conscious

4. Press PACER

5. Conrm placement of the sense marker ( )

is near the middle of each QRS

6. Press RATE to select desired pacing rate

7. Press CURRENT until electrical

capture occurs

8. Check blood pressure and pulse to verify

mechanical capture

PAUSE button facilitates temporary viewing

of underlying rhythm

Note: Heart rate alarms are disabled during pacing.

Observe patient continuously.

Page 5

LIFEPAK 15 Monitor/Deﬁbrillator

Control Description

NIBP Initiates blood pressure measurement.

LED illuminated when BP measurement

is being obtained.

ALARMS Activates and silences alarms. LED illuminated

when alarms are enabled and ashes when an

alarm condition occurs.

OPTIONS Accesses optional functions

EVENT Accesses user-dened events

Returns to Home Screen display

SPEED Scrolls through and selects screen or

DIAL menu items

Display mode button switches between color

display and black and white display

Other features, right side

Page 6

LIFEPAK 15 Monitor/Deﬁbrillator

Noninvasive blood pressure

monitoring procedure

1. Press ON

2. Select appropriate sized cuff, attach snugly to extremity;

align cuff marking (if present) with artery

3. Connect tubing to the cuff and to the NIBP port

on the monitor

4. Change initial ination pressure if necessary—Default:

160 mmHg

5. Position extremity in relaxed and supported position

at heart level

6. Inform patient that cuff will inate and squeeze arm

7. Press NIBP to start measurement NIBP

To cancel measurement, press NIBP again

When the measurement is complete, systolic, diastolic, and mean

arterial pressures are displayed.

NIBP measurement typically takes 40

seconds to complete. If the measurement

is not completed in 120 seconds, the cuff

automatically deates.

Page 7

LIFEPAK 15 Monitor/Deﬁbrillator

Connection Action

Connect: Open CO2port door, insert FilterLine®

connector and turn clockwise until connector is

rmly seated.

Disconnect: Rotate FilterLine connector

counterclockwise and pull connector out.

Connect: Align cable connector with SpO2port and

push in until connector clicks into place.

Disconnect: Press the gray buttons on each side

of the cable connector simultaneously and pull

connector out.

Connect: Insert NIBP tubing connector into the

NIBP port.

Disconnect: Press the latch on the left side of the

port and pull tubing connector out.

Connect: To connect green ECG connector with

ECG port, align green key on cable with notch on

port. Insert cable until connector is rmly seated.

Disconnect: Use the nger pull to pull the ECG

connector straight out.

Connect: Align the IP (invasive pressure) cable

connector with the P1 or P2 port; position the

gap on the connector facing up. Insert the cable

connector into the port until the connector is

rmly seated.

Disconnect: Grip the connector and pull straight out.

Features, left side,

Invasive pressure option

CO2

SpO2

NIBP

ECG

Page 8

LIFEPAK 15 Monitor/Deﬁbrillator

Features, left side,

Continuous temperature option

Connection Action

Connect: Open CO2 port door, insert FilterLine

connector, and turn clockwise until connector is

rmly seated.

Disconnect: Rotate FilterLine connector

counterclockwise and pull connector out.

Connect: Align cable connector with SpO2port

and push in until connector clicks into place.

Disconnect: Press the gray buttons on each side

of the cable connector simultaneously and pull

connector out.

Connect: Insert NIBP tubing connector into the

NIBP port.

Disconnect: Press the latch on the left side of the

port and pull tubing connector out.

Connect: The green ECG connector with the green

ECG port. Insert the cable connector into the port

until the connector is rmly seated.

Disconnect: Use the nger pull to pull the ECG

connector straight out.

Connect: Align the temperature adapter cable to

the temperature port. Attach selected temperature

sensor to adapter cable.

Disconnect: Grip the connector and pull straight out.

Inhaltsverzeichnis

Andere Stryker Medizinische Geräte Handbücher

Stryker

Stryker ENDOSCOPY Standard Bedienungsanleitung

Stryker

Stryker EPIC II Bedienungsanleitung

Stryker

Stryker Power-PRO IT 6516 Handbuch

Stryker

Stryker HeartSine Gateway LIFELINKcentral Bedienungsanleitung

Stryker

Stryker Visum Bedienungsanleitung

Stryker

Stryker 4126-000-000 Bedienungsanleitung

Stryker

Stryker Performance-PRO XT Bedienungsanleitung

Stryker

Stryker PneumoSure Bedienungsanleitung

Stryker

Stryker Power-PRO TL Cot Bedienungsanleitung

Stryker

Stryker FL28C Bedienungsanleitung

Stryker

Stryker Hansson Pin System Bedienungsanleitung

Stryker

Stryker 5050 Bedienungsanleitung

Stryker

Stryker 1080 Bedienungsanleitung

Stryker

Stryker S3 MEDSURG BED Bedienungsanleitung

Stryker

Stryker B3000n Badge Bedienungsanleitung

Stryker

Stryker GOBED FL17E Bedienungsanleitung

Stryker

Stryker ComfortGel 2850-000-016 Bedienungsanleitung

Stryker

Stryker MX-PRO R3 Bedienungsanleitung

Stryker

Stryker TriaDyne III Proventa 2030 Bedienungsanleitung

Stryker

Stryker F-ABSLT2BER Bedienungsanleitung

Stryker

Stryker POWEReam 4405 Series Bedienungsanleitung

Stryker

Stryker 240-099-156 Bedienungsanleitung

Stryker

Stryker 1089 Bedienungsanleitung

Stryker

Stryker Nara 4402 Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung

Romet

Romet R210 Bedienungsanleitung