Sundstrom SR570 Installations- und Benutzerhandbuch

…assemble the SR570 head-top

BEFORE YOU START:

Check that the equipment is complete in

accordance with the packing list and has not

been damaged in transport.

Packing list:

1. Face shield 2. Breathing hose 3.Peel off

with clips 4. User instructions 5. Cleaning

tissue

Connect the breathing hose. Connect the hose to

the face shield, a click is heard when it is correct

attached. Connect the hose to the fan and then

turn 1/8 of a turn.

The performance check should be checked on

every occasion before the fan unit is used.

Start the fan unit. Place the head-top in the flow

meter. Grip the bag to seal around the breathing

hose. Grip the flow meter tube with the other

hand, the tube will point upwards from the bag.

Read the position of the ball in the tube. This

should hover at a level with or slightly above the

upper marking on the tube, (175 l/min).

If minimum flow is not achieved, check that

•the flow meter is held upright,

•the ball moves freely,

•the bag seals well around the hose.

The equipment is designed to provide a warning

if the air flow is obstructed.

Provoke an air flow stoppage by gripping the top

part of the bag or by shutting off the flow meter

outlet. The fan unit should then initiate alarms

by sound, light and vibrations. In usage of

compressed air the control valve SR 348 will

warn by sound.

…put on the hood

If necessary, adjust the head harness. There are

a lot of adjustment options, see fig. 11. To adjust

the head harness easier, remove the head

harness from the face shield, see “To change the

head harness”.

Height adjustment.

A - how deep the head end up in the head part.

B - how high the face shield sits on the head. If

necessary, adjust for hearing protectors.

Angle adjustment between visor and head

harness.

C - the angle against the visor. Adjust if the face

is too close to the visor or if the hearing

protector not is sealed around the ear.

D - adjustment of the angle of the headband

around the back of the head.

Width adjustment of the head harness.

E- rough adjustment of the width of the head

harness.

F - the width of the head harness.

Raise the visor and put the face shield on.

Lower the visor unit by pulling the face seal

down under your chin. A clicking sound indicates

that the visor unit has been lowered fully.

Insert a finger between your chin and the face

seal and run the finger along the contact surface

of the face seal all the way round to check that it

fits well against the face.

Make sure that the breathing hose runs along

your back and is not twisted.

Airflow deflector

The airflow can be directed towards visor or face

for optimal comfort.

…use the peel-off

Press the peel-off clip into the center of the side

of the visor.

Secure the peel-off to the peel-off clips.

When mounting more peel-offs, mount them so

that the tabs end up different to ease the

removal.

…fit hearing protectors

It is possible to attach hearing protectors into

the slot connection on the sides of the face

shield.

If necessary, adjust the head harness of the face

shield to get the hearing protectors in correct

position.

…clean the SR570

The person who is responsible for cleaning and

maintenance of the equipment must have

suitable training and be well acquainted with

work of this type.

Sundström cleaning tissues SR 5226 are

recommended for daily care.

NOTE! Never use solvents for cleaning.

If the equipment is more heavily fouled, the

head harness seal, face seal and sweatband can

be put in a laundry bag and machine wash (max

40 °C). Other items can be washed in a

dishwasher (max 55°C).

If necessary, spray the face shield with 70 %

ethanol or isopropanol solution for disinfection.

…store the head-top and parts

After cleaning, store the equipment in a dry and

clean place at room temperature. Store the face

shield with the visor in the fully raised or fully

lowered position. Avoid exposing it to direct

sunlight.

…schedule maintenance

Recommended minimum requirements on

maintenance routines so you will be certain that

the equipment will always be in usable

condition.

Before use

After use

Yearly

Visual inspection

Function check

Cleaning

New hose gasket

New exhal.

membrane

…change the visor

Release and remove the visor.

Fit the new visor. Start in the center.

Make sure that the visor is centered and ends up

in the groove on the face shield.

Secure the visor on the right and left side.

Check that the visor is properly locked around

the edge of the face shield.

…change the exhalation valve

The exhalation membrane is mounted inside the

valve cover.

Remove the visor.

Release and remove the valve cover.

Release and remove the membrane.

Press on the new membrane in right position

according to the picture. Carefully check that the

membrane is in contact with the valve seat all

round.

Press the valve cover into place.

Secure the valve cover on one side.

Secure the valve cover on the other side

…change the face shield

Release the face seal hooks from the head

harness.

Push the face seal pins out and remove the face

seal.

Fit the new face seal. The marking on the face

seal and visor should be in front of each other.

Press the face seal all around the visor.

Make sure that the face seal pins are fixed in the

visor.

Secure the face seal hooks into the head

harness.

…change the head harness seal

Release the face seal hooks from the head

harness.

Remove the forehead seal.

Andere Handbücher für SR570

Andere Sundstrom Atemwegsprodukt Handbücher

Sundstrom

Sundstrom H06-0321 Bedienungsanleitung

Sundstrom

Sundstrom SR 900 Bedienungsanleitung

Sundstrom

Sundstrom SR 90 Airline Bedienungsanleitung

Sundstrom

Sundstrom SR 90 Airline Montageanleitung

Sundstrom

Sundstrom SR 905 Bedienungsanleitung

Sundstrom

Sundstrom SR 700 Bedienungsanleitung

Sundstrom

Sundstrom SR 200 Montageanleitung

Sundstrom

Sundstrom SR 200 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 EX Bedienungsanleitung

Sundstrom

Sundstrom SR570 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 500 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 EX Bedienungsanleitung

Sundstrom

Sundstrom SR307 Technisches Handbuch

Sundstrom

Sundstrom SR 200 Bedienungsanleitung

Sundstrom

Sundstrom SR307 Technisches Handbuch

Sundstrom

Sundstrom SR 100 APR Bedienungsanleitung

Sundstrom

Sundstrom SR 100 Technisches Handbuch

Sundstrom

Sundstrom SR540 Bedienungsanleitung

Sundstrom

Sundstrom SR 520 Bedienungsanleitung

Sundstrom

Sundstrom SR570 Bedienungsanleitung

Sundstrom

Sundstrom SR 63 Bedienungsanleitung

Sundstrom

Sundstrom SR500EX Bedienungsanleitung

Sundstrom

Sundstrom SR 700 Bedienungsanleitung

Sundstrom

Sundstrom SR 540 EX Bedienungsanleitung

Beliebte Atemwegsprodukt Handbücher anderer Marken

Omron

Omron COMP A-I-R NE-C801 Bedienungsanleitung

CERES

CERES nosko nebulizer kit Bedienungsanleitung

Dr.Frei

Dr.Frei NE-SM1 Bedienungsanleitung

North

North 5400 series Bedienungsanleitung

John Bunn

John Bunn Neb-u-Lite LX2 Bedienungsanleitung

DeVilbiss

DeVilbiss UltraNeb Bedienungsanleitung

Sperian

Sperian Panther Hip-Pac P9684 Series Bedienungsanleitung

Dräger

Dräger X-plore 6570 Bedienungsanleitung

3M 8000 Series Bedienungsanleitung

Respironics

Respironics SideStream HS860 Bedienungsanleitung

JARDIBRIC

JARDIBRIC KPBRU20 Bedienungsanleitung

Ombra

Ombra 63506 Bedienungsanleitung

Lotus

Lotus M-9520A Bedienungsanleitung

Philips

Philips Respironics EE Leak 1 AF541 Bedienungsanleitung

EVOLU

EVOLU Nano AiR MINI Bedienungsanleitung

Ambu

Ambu SPUR II Bedienungsanleitung

MSA AUER

MSA AUER 3S-PF Bedienungsanleitung

MSA

MSA C420 Bedienungsanleitung