115*42*128cm
115*42*51cm
116*19*58.5cm
14.5kg
120kg
16+ years
140+ cm
30km/h
20-25km
25°
-10-45°C
8.5 inch Pneumatic rubber tire
36V
42V
7.5AH
-10-45°C
350W
front &rear
Rear (disc brake + pedal brake)
Can't customize colors
3 modes
Charging step tips
Open the charge
port cover.
Insert the
charge plug.
Close the charge
port cover when
finished.
Do not charge if the charge port or power cord is wet.
Do not charge or use your baery if it is damaged or
see trace of water.
Close the charge port cover when not charging.
WARNING
Charging
5
Link to page 2
3 4
Use a so, wet cloth to wipe the mainframe clean. Hard to remove dirt can be scrubbed with a toothbrush and toothpaste, then
cleaned with a so, wet cloth. Scratches on plastic parts can be polished with fine grit abrasive paper.
7 Maintenance
Cleaning and Storage
Do not wash your Electric Scooter with alcohol, gasoline, acetone, or other corrosive/volatile solvents. These substances may damage
the appearance and internal structure of your Electric Scooter. Do not wash your Electric Scooter with a power washer or hose.
Make sure the Electric Scooter is powered OFF, the charging cable is unplugged, and the rubber cap on the charge port is tightly
sealed before cleaning; otherwise you may damage the electronic components.
Store your Electric Scooter in a cool, dry place. Do not store it outdoors for extended periods of time. Exposure to sunlight and
temperature extremes (both hot and cold) will accelerate the aging process of the plastic components and may reduce baery life.
Typically, a fully charged baery should retain charge for 120-180 days in Standby Mode. A low-power baery should retain charge for
30-60 days in Standby Mode. Remember to charge the baery aer each use. Completely draining the baery may cause permanent
damage to the baery. Electronics inside the baery record the charge-discharge condition of the baery;
Do not store or charge the baery at temperatures outside the stated limits (see Specifications). Do not puncture the baery. Refer to
your local laws and regulations regarding baery recycling and/or disposal.
A well maintained baery can perform well even aer many miles of riding. Charge the baery aer each ride and avoid draining the
baery completely. When used at room temperature (70°F [22°C]) the baery range and performance is at its best; whereas using it at
temperatures below 32°F (0°C) can decrease range and performance. Typically, at 14°F (-10°C) range can be half that of the same
baery at 70°F (22°C). Baery range will recover when temperature rises.
Baery Pack Maintenance
WARNING
WARNING
Do not aempt to disassemble the baery. Risk of fire. No user serviceable parts.
Do not ride when the ambient temperature is outside the machine operation temperature (see Specifications) because low/high
temperature will limit the maximum power/torque. Doing so could cause personal injury or property damage due to slips or falls.
Baeries or packaging for baeries are labeled in accordance with European Directive 2006/66/EC concerning baeries and accumula-
tors and waste baeries and accumulators. The Directive determines the framework for the return and recycling of used baeries and
accumulators as applicable throughout the European Union. This label is applied to various baeries to indicate that the baery is not
to be thrown away, but rather reclaimed upon end of life per this Directive.
In accordance with the European Directive 2006/66/EC, baeries and accumulators are labeled to indicate that they are to be collected
separately and recycled at end of life. The label on the baery may also include a chemical symbol for the metal concerned in the
baery (Pb for lead, Hg for mercury, and Cd for cadmium). Users of baeries and accumulators must not dispose of baeries and
accumulators as unsorted municipal waste, but use the collection framework available to customers for the return, recycling, and
treatment of baeries and accumulators. Customer participation is important to minimize any potential effects of baeries and
accumulators on the environment and human health due to the potential presence of hazardous substances.
Technozom products sold in the European Union, meet the requirements of Directive 2011/65/EU on the restriction of the use of certain
hazardous substances in electrical and electronic equipment (“RoHS recast” or “RoHS 2”).
9 Certifications
European Union Compliance Statement
Baery recycling information for the European Union
Radio and Telecommunications Terminal Equipment Directive
Restriction of Hazardous Substances Directive (RoHS)
8 Specifications
Dimensions
Item Data
Weight
Rider
Machine
Parameters
Baery
Motor
Features
Unfold: Length x Width x Height
Fold: Length x Width x Height
Carton: Length x Width x Height
Net
Payload
Recommended Age
Required Height
Max. Speed
Range
Max. Slope
Operating Temperature
Tire
Nominal Voltage
Max. Charging Voltage
Nominal Capacity
Charging Temperature
Nominal Power
Shock Absorber
Brake
Atmosphere Light
Riding Modes
6
Folding
Turn off your Electric scooter. Pull down the safety hook and open the quick release lever.
Align the hook and the buckle and hook them.
When your Electric scooter is folded up, li it by the stem to carry.
1.
2.
3.
Quick Release Lever
1
Charge port
