Thomas 1137 Bedienungsanleitung
USER’S
GUIDE
Transparent
Maturing tank
Refs. 1137 –1138 - 11371
THOMAS APICULTURE
French designer and manufacturer
Of beekeeping equipment
ZA de l’Évangile
321, rue Bernard de la Rochefoucauld
45450 Fay-aux-Loges –France
Tél: +33 (0)2 38 46 88 00
Fax : +33 (0)2 38 59 28 28
E-mail : contact@thomas-apiculture.com
www.thomas-apiculture.com
Non-contractuals pictures
Transparent maturing tank : User’s Guide 2/5
- Version du 10/06/2020 -
Technical Definition
Diameter : Ø 250 mm
Capacity : 20 kg
Weight :
Ref. 1138 : 9,5 kg
Ref. 1137 : 7,5 kg
Ref. 11371 : 8,5 kg
Motor :
Ref. 1138 : 220 V –20 W
Ref. 11371 : 220 V –170 W
The maturing or decantation process take place
after the extraction step.
This process allows the impurities in the honey
(pollen grains, etc.) to rise to the surface. To do this, it
is necessary to store the honey in a maturing
machine.
The transparent maturer also makes it possible to
display the honey, in particular during demos.
It can be supplied with lighting or heated base.
SAFETY PRECAUTIONS
CAUTION : Before connecting the appliance to the power supply, make sure that the electrical
installation complies with current standards (protection by earth leakage circuit breaker, earth wire,
etc.).
Check the supply voltage.
Before using the unit for the first time, clean the unit to remove any residual chips or filings.
The transparent maturing tank displays the honey while allowing them to settle.
It can be supplied with a base lighting, allowing to emphasize the honey while keeping the bottom of
the tank at temperature.
The device can also be equipped with a heating bottom to maintain the honey in a liquid state.
The maturer is equipped with a 40/49 outlet fitted with a "Perfection" tap.
Do not the device heat for a long time without surveillance (for example over night).
- Version du 10/06/2020 -
OPERATING PRINCIPLE
Ref. 1137 : Transparent maturing tank
Open the lid of the maturing tank and pour the honey into it.
Close the lid.
To collect the honey, place a container under the outlet and open the "Perfection" tap.
Ref. 1138 : transparent maturing tank with base lighting
Connect to the power supply.
Open the lid of the maturing tank and pour the honey into the tank.
Close the lid.
Set the ON/OFF switch (1) to ON to turn on the 20 W bulb (2).
To turn it off, set the switch to OFF.
To collect the honey, place a container under the outlet and open the "Perfection" tap.
Ref. 11371 : Transparent maturing tank with heated base
WARNING:
This unit is equipped with an energy dosing device. It is not a thermostat, the values serve as a
reference and do not indicate the temperature (the maximum level of use is 2).
Connect to the power supply.
Open the lid of the maturing tank and pour the honey into it.
Close the lid.
Set the energy meter to position 2 maximum.
The heat signal lights up to indicate when heating.
To collect the honey, place a container under the outlet and open the "Perfection" tap.
Transparent maturing tank : User’s Guide 3/5
- Version du 10/06/2020 -
MAINTENANCE
CAUTION : Disconnect the machine from the power supply before servicing.
Protect electrical appliances when cleaning.
Clean with hot water.
The maturing tank is a seasonal equipment but must operate regularly throughout the
year (at least a few seconds per month when empty).
Store preferably in a dry room.
Replacing the bulb (Ref. 1138) :
Turn the appliance upside down.
Remove the metal circlip used to hold the bulb and then remove the bulb.
Install a new bulb.
Replace the circlip on the new bulb.
"Perfection" tap adjustment:
The "Perfection" tap has a hexagonal screw for precise adjustment. This screw is used
to adjust the pressure exerted by the seal on the honey outlet. The higher the pressure,
the less chance of leakage, but the harder the valve will be to handle. It is up to the
customer to determine the right balance.
Transparent maturing tank : User’s Guide 4/5
- Version du 10/06/2020 -
Frequent questions
CAUTION : Unplug the machine before any maintenance operation.
Problem Possible solution
The machine does not heat up
(Ref. 11371)
- Check that the unit is connected to the power supply.
- Check the power supply (power failure).
- Turn the regulator and check that the light comes on.
- Make sure that the energy dosing unit is not set to 0.
The machine does not light up
(Ref. 1138)
-
Check that the unit is connected to the power supply.
-
Check the power supply (power failure).
-
Check the state of the bulb, change it if necessary
(see
"Maintenance").
Transparent maturing tank : User’s Guide 5/5
If the problems are still there,
please contact us :
Customer Service :
02 38 46 88 00
From 8:00 am to 12:00 am
And from 2:00 pm to 5:30 pm
From Monday to Friday
Technical Help:
High season 12H/24 and 6 days /7
(Monday - Saturday 8:00 am –8:00 pm)
Off season 8H/24 et 5 days /7
(Monday –Friday from 8:00 to 12:00
And from 1:30 pm to 6:00 pm)
assistance-technique@thomas-apiculture.com
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Thomas Laborausrüstung Handbücher
Beliebte Laborausrüstung Handbücher anderer Marken
Agilent Technologies
Agilent Technologies 5800 ICP-OES Bedienungsanleitung
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Bedienungsanleitung
NI
NI PXI-5422 Handbuch
Collomix
Collomix Aqix Bedienungsanleitung
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Bedienungsanleitung
Ocean Insight
Ocean Insight FLAME-NIR+ Bedienungsanleitung
Parker
Parker ALIGN-MG-NA Bedienungsanleitung
BD
BD 644787 Bedienungsanleitung
DENTAURUM
DENTAURUM Compact Megaplus Bedienungsanleitung
Biuged Laboratory Instruments
Biuged Laboratory Instruments BGD 626 Bedienungsanleitung
VWR
VWR SAS Super IAQ Bedienungsanleitung
illumina
illumina MiSeqDx Bedienungsanleitung