TRENDnet TW100-BRM504 Bedienungsanleitung
TW100-BRM504
Quick Installation Guide
Table of Contents
Table of Contents
Version 08.30.2006
English ......................................................................................................
Troubleshooting ........................................................................................
1
1
3
4
7
1. Before You Start
2. Install Hardware .................................................................................
3. .................................................................
.................................................................................
Configuration The Modem
Installation Requirements
Application
A working DSL Internet Connection
A computer with a wired or wireless network adapter properly installed
Package Contents
1. Before You Start
English
1
TW100-BRM504
Quick Installation Guide
User's Guide CD-ROM
1 x RJ-45 Ethernet Cable (Yellow)
1 x RJ-11 Telephone Cable (Gray)
Mounting Stand
Power Adapter
Web Browser: Internet Explorer (5.0 or higher) or Netscape Navigator
(4.7 or higher)
10/100Mbps
Phone Jack
4-Port ADSL Modem
Firewall Router
(TW100-BRM504)
Workstation with10/100Mbps
Fast Ethernet PCI Adapter
(TE100-PCIWN)
Internet
ADSL Account Ready Line
Notebook with 10/100Mbps
CardBus PC Card
(TE100-PCBUSR)
English
2
Collect Internet Service Provider (ISP) Information
During the installation of your Wireless ADSL Modem Router, the Setup Wizard
will automatically detect your ISP connection type. If the router cannot detect
your ISP connection type, you can manually specify the connection type.
Please verify your DSL Internet broadband connection type with your ISP and
ensure you have all the information for one of the following connection types:
A. Dynamic IP connection
ADSL Modem parameters (VPI or VCI), if it cannot be detected automatically.
ISP may require you to use a particular Hostname or Domain name.
B. Static or Fixed IP connection
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)
Subnet Mask: _____. _____._____._____
Gateway IP Address: ____. _____._____._____
Primary DNS:_____. _____._____._____
Secondary:_____. _____._____._____
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.
C. PPPoE or PPPoA Dynamic IP connection
Login User Name: _________
Password: ________________
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.
D. IPoA Static or Fixed (IP over ATM) connection
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)
Subnet Mask: _____. _____._____._____
Gateway IP Address: ____. _____._____._____
Primary DNS:_____. _____._____._____
Secondary:_____. _____._____._____.
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.
English
3
2. Hardware Installation
2. Connect one end of the yellow RJ-
45 cable to one of the
TW100-BRM504's LAN ports.
Connect the other end of cable to
the computer's Ethernet port.
4. Connect the AC Power Adapter to
the TW100-BRM504 and then to a
power outlet.
1. Attach the mounting stand to the
side of the unit.
5. Verify that the following panel lights
are on: Power, LAN.
3. Connect one end of the gray RJ-11
cable to the TW100-BRM504's
ADSL port. Connect the other end
of the cable to the phone jack.
English
4
3. Configure the Modem
Note: It is recommended that you configure the Modem from a wired computer.
2. Enter User name and Password,
and then click OK. By default,
User name: admin
Password: password
1. Open your web browser, type
http://192.168.0.1 in the
Address bar, and press Enter.
3. Click Setup Wizard.
English
5
5. Select Auto-detect, and then click
Next.
Note: In the example, the DSL connection is PPPoE.
4. Click Next.
6. Wait for the Auto Detection process
to complete.
Note: If the Setup Wizard could not automatically detect your Internet
connection, select Manual Selection and input the information using the
information provided by your ISP.
Note: For other connection methods, follow the on screen instructions after the
Auto Detection.
7. Configure the settings based on
information provided by your ISP.
Then click Next.
9. Verify that the ADSL LED is lit and
then click Close.
Your installation is now complete.
For detailed information regarding the TW100-BRM504's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
CD-ROM, or TRENDnet's website at http://www.trendnet.com.
English
6
8. Check Test Internet Connection,
and then click Finish.
7
Troubleshooting
Q1:
A1:
I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error
message says “The page cannot be displayed.” How can I get into the
TW100-BRM504's web configuration page?
First, check your hardware settings again by following the instructions in Section 2.
Second, make sure the LAN and WLAN lights are lit. Third, make sure your TCP/IP settings
are set to Obtain an IP address automatically (see the steps below).
1. Go into the Control Panel and double-click
the Network Connections icon, right-click
the Local Area Connection icon and then
click Properties.
2. Click Internet Protocol (TCP/IP) and then
click Properties. Then click on Obtain an
IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
The Modem does not auto-detect my DSL connection. What should I do?
First, verify that your DSL account is activated. Second, make sure all the cables are
properly connected (see Section 2). Third, in Section 3, select manual selection in the Setup
Wizard and configure the Modem based on information provided by your ISP.
Q2:
A2:
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
Andere Handbücher für TW100-BRM504
7
Inhaltsverzeichnis
Andere TRENDnet Netzwerk-Router Handbücher
TRENDnet
TRENDnet TW100-BRM504 Bedienungsanleitung
TRENDnet
TRENDnet SMCWBR14S-NL Bedienungsanleitung
TRENDnet
TRENDnet TEW-435BRM - 54MBPS 802.11G Adsl Firewall M Bedienungsanleitung
TRENDnet
TRENDnet TEW-711BR Bedienungsanleitung
TRENDnet
TRENDnet TEG-S80g - Switch Bedienungsanleitung
TRENDnet
TRENDnet DSLR-2000G Bedienungsanleitung
TRENDnet
TRENDnet TPA-311 Bedienungsanleitung
TRENDnet
TRENDnet TW100-BRM504 Bedienungsanleitung
TRENDnet
TRENDnet TE100-S50g Bedienungsanleitung
TRENDnet
TRENDnet TEW-633GR - Wireless Router Installations- und Betriebshandbuch
TRENDnet
TRENDnet TE-4010 Benutzerhandbuch
TRENDnet
TRENDnet TW-H6W1IR Bedienungsanleitung
TRENDnet
TRENDnet TPL-302E2K - Powerline AV Fast EN Adapter Bedienungsanleitung
TRENDnet
TRENDnet TEW-452BRP - 108Mbps Wireless Super G Broadband... Bedienungsanleitung
TRENDnet
TRENDnet TEG-S51SFP Bedienungsanleitung
TRENDnet
TRENDnet TPL-202E - Powerline Fast EN Bridge Bedienungsanleitung
TRENDnet
TRENDnet TW100-BRF214 Bedienungsanleitung
TRENDnet
TRENDnet TEW-827DRU Bedienungsanleitung
TRENDnet
TRENDnet TWG-BRF114 Bedienungsanleitung
TRENDnet
TRENDnet TEW-823DRU Bedienungsanleitung
Beliebte Netzwerk-Router Handbücher anderer Marken
NETGEAR
NETGEAR FS526T - Switch Bedienungsanleitung
Korenix
Korenix JetNet 5710G Series Bedienungsanleitung
Automated Logic
Automated Logic ZN551 Betriebsanleitung
Cisco
Cisco ASR 1000 Series Bedienerhandbuch
EnGenius
EnGenius ESR-9710 Bedienungsanleitung
Cisco
Cisco 805 Series Bedienungs- und Sicherheitshinweise