Tripp Lite Full Motion Flat Screen Desk Mount Bedienungsanleitung

Owner’s Manual

Full Motion

Flat Screen Desk Mount

MODEL: DDR1327S

CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR

PROPERTY DAMAGE MAY OCCUR!

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

75x75

100x100 27”

MAX 9kg

(19.8lbs)

MAX

Español 11 • Français 21 • Русский 31 • Deutsch 41

14-04-247-933321.indb 1 5/6/2014 1:46:08 PM

NOTE: Read the entire instruction manual before you start installation and assembly.

Warranty & Warranty Registration

WARNING

• Do not begin the installation until you have read and understood the instructions

and warnings contained in this manual. If you have any questions regarding any

of the instructions or warnings, please visit www.tripplite.com/support.

• This mounting bracket was designed to be installed and utilized ONLY as

speciﬁed in this manual. Improper installation of this product may cause damage

or serious injury.

• Make sure that the mounting surface can safely support the combined load of

the equipment and all attached hardware and components.

• Always use an assistant or mechanical lifting equipment to safely lift and position

equipment.

• Tighten screws rmly, but do not over-tighten. Over-tightening can damage the

items, greatly reducing their holding power.

• This product is intended for indoor use only. Using this product outdoors could

lead to product failure and personal injury.

5-Year Limited Warrant

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects

in material and workmanship for a period of 5 years from the date of initial purchase. If the product should

prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole

discretion.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE,

ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY

SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES,

INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY

PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL

DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not

allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions

may not apply to you. This warranty gives you speciﬁc legal rights, and you may have other rights which vary from

jurisdiction to jurisdiction).

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate

or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes

no representation or warranty as to the suitability or ﬁtness of these devices for any speciﬁc application.

WARRANTY REGISTRATION

Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You’ll be

automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*

* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.

Tripp Lite has a policy of continuous improvement. Speciﬁcations are subject to change without notice.

14-04-247-933321.indb 2 5/6/2014 1:46:08 PM

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to

installing. If any parts are missing or faulty, visit www.tripplite.com/support for service.

Pole (x1)

Desk Clamp Assembly (x1)

M4X14 (x4) M5X14 (x4) D5 Washer (x4)

Package M

Package P

Adapter Bracket Assembly (x1)

3mm Hex Key (x1)

6mm Hex Key (x1)

4mm Hex Key (x1)

Base Plate (x1)

5mm Hex Key (x1)

Pad (x1)

14-04-247-933321.indb 3 5/6/2014 1:46:08 PM

1. Install the Pole and Desk Clamp Assembly

2. Desk Installation

• Determine approximate location for mount, keeping in mind display size, height adjustment and pitch/roll

requirements.

• Slip the desk mount assembly over the edge of desk so that clamp fully contacts desk edge.

• Turn the knob to adjust the clamp to edge of desk and secure it tightly.

Note: min. desktop thickness=10mm (.4”)

max. desktop thickness=90mm (3.5”)

2a. Edge Installation

tighten

loosen

collar

tighten

3mm Hex Key

adjustable height

14-04-247-933321.indb 4 5/6/2014 1:46:08 PM

2. Desk Installation

Disassemble the desk clamp assembly by removing the clamp

adjustment screw and the three attachment screws from the

base plate.

Re-install the base plate with three retained attachment screws. Tighten securely.

From below the desk, insert retained clamp adjustment screw through Pad and up through the hole in the desk.

Thread screw by turning the knob into base plate but do not tighten completely at this time. Center the desk

mount assembly over the hole and then securely tighten screw.

Note: min. hole diameter =10mm (.4”)

max. hole diameter =70mm (2.75”)

2b. Hole Installation

Pad

Clamp Adjustment Screw

Base Plate

Rubber Pad

Attachment Screw

4mm Hex Key

14-04-247-933321.indb 5 5/6/2014 1:46:09 PM

3. Install Adapter Bracket

Lift the display and align the rear mounting

holes with the mount’s VESA plate.

Attach the display to the VESA plate with the appropriate included screws.

Do not over-tighten screws

D5 Washer M4X14

M5X14

TV TV

14-04-247-933321.indb 6 5/6/2014 1:46:09 PM

4. Install Adapter Bracket Assembly (attached display)

Using an assistant or mechanical

lifting equipment, lift the display with

attached VESA plate. Then slide the

adapter bracket assembly (with the

display attached) down the pole until it

touches the collar.

Pulling up on the handle allows the

arm to rotate 360 degrees in either

direction. Releasing the handle enables

tightening or adjustment.

tighten

Collar

Adjustable Handle

14-04-247-933321.indb 7 5/6/2014 1:46:09 PM

5. Height Adjustment

Tighten the socket

screw if the arm

assembly’s joints make

popping sounds during

adjustment.

Keep the wall mount arm level during tension adjustment. You may need to slightly loosen or tighten the

adjustment screw using the provided Hex Keys depending on the weight of display installed.

If display settles on its own, rotate adjustment screw towards the “+” symbol.

If display rises on its own, rotate adjustment screw towards the “-” symbol.

6mm Hex Key

14-04-247-933321.indb 8 5/6/2014 1:46:09 PM

6. Cable Management

FOLD 3

DUSTCATCHER

Connect the cables to the display. Press cable cover inward to route the cables through the space.

Note: Leave slack in cable for arm movement.

14-04-247-933321.indb 9 5/6/2014 1:46:09 PM

360°

7. Adjustment

To correct the tilting angle, tighten the

adjustment screws using the provided

Hex Keys (or tighten the knob).

Adjust to the desired location or tilt.

+90°

-40°

Max 335mm (13”)

Height Adjustment

Maintenance

• Check that the bracket is secure and safe to use at regular intervals (at least every three months).

• Please visit www.tripplite.com/support if you have any questions.

360°

5mm

Hex Key

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

14-04-247-933321.indb 10 5/6/2014 1:46:12 PM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Tripp Lite Rack & Stand Handbücher

Tripp Lite

Tripp Lite SmartRack NEMA 4 Bedienungsanleitung

Tripp Lite

Tripp Lite DDR1327SQFC-1 Bedienungsanleitung

Tripp Lite

Tripp Lite AG-0072 Bedienungsanleitung

Tripp Lite

Tripp Lite SmartRack SR1UCAGE Bedienungsanleitung

Tripp Lite

Tripp Lite N063-008-ENC Bedienungsanleitung

Tripp Lite

Tripp Lite DWM1323SE Bedienungsanleitung

Tripp Lite

Tripp Lite DDR1026MQ Bedienungsanleitung

Tripp Lite

Tripp Lite Dual Flat Screen Flex ArmDesk Clamp Bedienungsanleitung

Tripp Lite

Tripp Lite DDR1327NBMSC Bedienungsanleitung

Tripp Lite

Tripp Lite DMPDS4970 Bedienungsanleitung

Tripp Lite

Tripp Lite DMR1015X3 Bedienungsanleitung

Tripp Lite

Tripp Lite DWMLARM1732AM Bedienungsanleitung

Tripp Lite

Tripp Lite DDR1327SQFC-1 Bedienungsanleitung

Tripp Lite

Tripp Lite N48M Series Bedienungsanleitung

Tripp Lite

Tripp Lite DWM1742S Bedienungsanleitung

Tripp Lite

Tripp Lite Safe-IT WWSSFDSAM Bedienungsanleitung

Tripp Lite

Tripp Lite SmartRack SRDUCTN7009 Bedienungsanleitung

Tripp Lite

Tripp Lite DMVWSC4570XUL Bedienungsanleitung

Tripp Lite

Tripp Lite DWF4585X Bedienungsanleitung

Tripp Lite

Tripp Lite DMFC3265M Bedienungsanleitung

Tripp Lite

Tripp Lite SRWO12US2 Bedienungsanleitung

Tripp Lite

Tripp Lite DDR1327SDFC-1 Bedienungsanleitung

Tripp Lite

Tripp Lite DDR811TRAYTAA Bedienungsanleitung

Tripp Lite

Tripp Lite DWM2655M Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung