Ubiquiti EdgeSwitch 5XP Bedienungsanleitung

EdgeSwitch 5XP Screws (Qty. 2) Anchors (Qty. 2)

Power Adapter (24V, 2.5A) Power Cord

Package Contents

Installation Requirements

Drill, 6 mm drill bit, and Phillips screwdriver (wall-mounting)

For outdoor applications, shielded Category 5 (or above) cabling should be used for all

wired Ethernet connections and should be grounded through the AC ground of the power

supply.

We recommend that you protect your networks from harmful outdoor environments and

destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For

more details, visit

ui.com/toughcable

IMPORTANT:

Although the cabling can be located outdoors, the EdgeSwitch itself

should be housed inside a protective enclosure.

WARNING:

To reduce the risk of re or electric shock, do not expose this

EdgeSwitch to rain or moisture.

Hardware Overview

ES-5XP Quick Start Guide

Management Power/Link LED

RJ45 PoE LED (Ports 1 - 5)

RJ45 Speed/Link/Act LED (Ports 1 - 5)

Management Port

USB Port

RJ45 (Ports 1 - 5)

Oﬀ No Power/No Link

Amber

After bootup, the LED indicates power. After an initial link

is established, the LED indicates a 10/100 Mbps

connection. If the link terminates, the LED turns oﬀ until a

link is re-established. If the unit reboots, the LED will

again indicate power until a link is established.

Oﬀ No Power over Ethernet

Green 24V Power over Ethernet

Oﬀ No link

Amber Link established at 10/100 Mbps

Amber Flashing Link activity at 10/100 Mbps

Green Link established at 1000 Mbps

Green Flashing Link activity at 1000 Mbps

10/100 Mbps port used to access the EdgeSwitch Conguration Interface.

Reserved for future use.

ES-5XP Quick Start Guide

Reset Button

Power

10/100/1000 Mbps ports for switching and PoE (also available for management by

default).

To reset to factory defaults, press and hold the Reset button for more than 10 seconds

while the unit is powered on.

Connect the included Power Adapter to the Power port.

Hardware Installation

Place the EdgeSwitch on a bench top or other at surface.

WARNING:

FAILURE TO PROVIDE PROPER VENTILATION MAY CAUSE FIRE HAZARD.

KEEP AT LEAST 20 MM OF CLEARANCE NEXT TO THE VENTILATION HOLES FOR

ADEQUATE AIRFLOW.

Wall-Mounting

ES-5XP Quick Start Guide

Grounding the EdgeSwitch (Optional)

The EdgeSwitch is grounded through the Power Adapter; however, you can add optional ESD

grounding for enhanced ESD protection.

ES-5XP Quick Start Guide

Connecting Power

Connecting Ethernet

ES-5XP Quick Start Guide

Note:

PoE is disabled by default on all numbered ports and is not available on the

Management port. To enable PoE on the appropriate ports, use the Ports tab in the

Conguration Interface.

Accessing the Conguration Interface

Connect to the Conguration Interface:

1. Ensure that your computer (or other host machine) is connected to the Management port

on the EdgeSwitch.

Note:

By default, you can congure the EdgeSwitch via any port; however, we

recommend the Management port. (Access to the Conguration Interface can be

limited to the Management port only. You can congure this setting on the Device

tab.)

2. Congure the Ethernet adapter on your host system with a static IP address on the

192.168.1.x subnet (e.g., 192.168.1.100).

3. Launch your web browser. Type https://192.168.1.20 in the address eld. Press enter (PC)

or return (Mac).

ES-5XP Quick Start Guide

4. Enter ubnt in the Username and Password elds. Click Login.

The Conguration Interface will appear and allow you to customize your settings. You can

enable PoE on the Ports tab.

You can also manage your device using the Ubiquiti® Network Management System. UNMS™

lets you congure, monitor, upgrade, and back up your devices using a single application.

Specications

ES-5XP

Dimensions 197 x 87.5 x 27.3 mm

(7.76 x 7.28 x 1.61")

Weight 250 g

(8.82 oz)

Power Input 24VDC, 2.5A Power Adapter (Included)

Max. Power Consumption 60W

PoE Out Voltage Range 22-24VDC

Max. PoE Wattage Per Data Port 11.5W

ESD Rating ±24 kV Air/Contact

PoE Method Passive

Button Reset

USB Port 2.0 Type A (Reserved for Future Use)

Processor MIPS 24K, 400 MHz

System Memory 64 MB

Code Storage 8 MB

PoE Congurable Per Port

Management Port N/A

ES-5XP Quick Start Guide

ES-5XP

Data Ports Oﬀ/24V

LEDs Per Port

Management Port Power/Link

Data Ports PoE, Speed/Link/Activity

Networking Interfaces

Management Port (1) 10/100 Ethernet Port

Data Ports (5) 10/100/1000 Ethernet Ports

Operating Temperature -25 to 55° C

(-13 to 131° F)

Operating Humidity 90% Noncondensing

Certications CE, FCC, IC

Safety Notices

1. Read, follow, and keep these instructions.

2. Heed all warnings.

3. Only use attachments/accessories specied by the manufacturer.

WARNING:

Failure to provide proper ventilation may cause re hazard. Keep at least 20 mm of

clearance next to the ventilation holes for adequate airow.

WARNING:

To reduce the risk of re or electric shock, do not expose this product to rain or

moisture.

WARNING:

Do not use this product in location that can be submerged by water.

WARNING:

Avoid using this product during an electrical storm. There may be a remote risk of

electric shock from lightning.

Electrical Safety Information

1. Compliance is required with respect to voltage, frequency, and current requirements indicated on the

manufacturer’s label. Connection to a diﬀerent power source than those specied may result in

improper operation, damage to the equipment or pose a re hazard if the limitations are not followed.

2. There are no operator serviceable parts inside this equipment. Service should be provided only by a

qualied service technician.

3. This equipment is provided with a detachable power cord which has an integral safety ground wire

intended for connection to a grounded safety outlet.

a. Do not substitute the power cord with one that is not the provided approved type. Never use an

adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.

b. The equipment requires the use of the ground wire as a part of the safety certication, modication

or misuse can provide a shock hazard that can result in serious injury or death.

c. Contact a qualied electrician or the manufacturer if there are questions about the installation prior

to connecting the equipment.

d. Protective earthing is provided by Listed AC adapter. Building installation shall provide appropriate

short-circuit backup protection.

e. Protective bonding must be installed in accordance with local national wiring rules and regulations.

ES-5XP Quick Start Guide

Andere Handbücher für EdgeSwitch 5XP

Andere Ubiquiti Schalten Handbücher

Ubiquiti

Ubiquiti EdgeSwitch 8 Bedienungsanleitung

Ubiquiti

Ubiquiti TS-16-CARRIER Bedienungsanleitung

Ubiquiti

Ubiquiti EdgeSwitch Bedienungsanleitung

Ubiquiti

Ubiquiti US-XG-6POE Bedienungsanleitung

Ubiquiti

Ubiquiti unifi switch 8 Bedienungsanleitung

Ubiquiti

Ubiquiti EdgeSwitch ES-16-XG Bedienungsanleitung

Ubiquiti

Ubiquiti US-XG-6POE Bedienungsanleitung

Ubiquiti

Ubiquiti ETHERMAGIC EM-S Bedienungsanleitung

Ubiquiti

Ubiquiti US-XG-6POE Bedienungsanleitung

Ubiquiti

Ubiquiti TS-5-POE ToughSwitchPoE Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi USW-24-POE Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi US-8-60W Bedienungsanleitung

Ubiquiti

Ubiquiti EdgeSwitch ES-16-150W Bedienungsanleitung

Ubiquiti

Ubiquiti US-16-XG Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi USW-Industrial Bedienungsanleitung

Ubiquiti

Ubiquiti TS-5-POE ToughSwitchPoE Bedienungsanleitung

Ubiquiti

Ubiquiti unifi switch 8 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Switch Flex Bedienungsanleitung

Ubiquiti

Ubiquiti UnFi US-48-500W Bedienungsanleitung

Ubiquiti

Ubiquiti US-16-XG Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi USW-Pro-24-POE Bedienungsanleitung

Ubiquiti

Ubiquiti EdgeSwitch 10 XP Bedienungsanleitung

Ubiquiti

Ubiquiti FiberPoE Bedienungsanleitung

Ubiquiti

Ubiquiti POE-50-60W Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung