Ubiquiti Bullet AC-IP67 Bedienungsanleitung

Bullet AC IP67 N-Type Right Angle Adapter

Package Contents

Installation Requirements

Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor

wired Ethernet connections and should be grounded through the AC ground of the

PoE.

We recommend that you protect your networks from harmful outdoor environments

and destructive ESD events with industrial-grade, shielded Ethernet cable from

Ubiquiti. For more details, visit ui.com/toughcable

Surge protection should be used for all outdoor installations. We recommend that

you use two Ethernet Surge Protectors, model ETH-SP, one near the Bullet and the

other at the entry point to the building. The ETH-SP will absorb power surges and

safely discharge them into the ground.

* Shown without antenna.

Hardware Overview

BulletAC-IP67 Quick Start Guide

Reset Button

Ethernet Port

To reset to factory defaults, press and hold the Reset button for more than 10

seconds while the device is powered on.

This 10/100/1000 Ethernet port is used to connect the power and should be

connected to the LAN and DHCP server.

Hardware Installation

BulletAC-IP67 Quick Start Guide

Note: The Bullet should be mounted vertically to reduce stress on the N-Type

Connector. The N-Type Right Angle Adapter may be used as needed.

Accessing airOS via Wi-Fi

Verify connectivity in the airOS® Configuration Interface using the UNMS™ app or Web

Portal. Both are available for 15 minutes immediately after you power on the device. If

necessary, you can power cycle the device to re-enable its Wi-Fi.

UNMS App

1. Download the UNMS app.

2. Connect your device’s Wi-Fi to the SSID named: <model>:<MAC Address>

Note: Ensure that DHCP is enabled on your Wi-Fi adapter.

BulletAC-IP67 Quick Start Guide

3. Launch the app and follow the on-screen instructions.

Web Portal

1. Connect your device’s Wi-Fi to the SSID named: <model>:<MAC Address>

2. Launch your web browser and go to: http://setup.ui.com

3. Select your Country and Language. You must agree to the Terms of Use to use the

product. Click Continue.

4. Create a username and password. Confirm your new password and then click Save.

Note: Ensure that your Wi-Fi connection has DHCP enabled.

BulletAC-IP67 Quick Start Guide

The airOS Configuration Interface will appear, allowing you to customize your settings

as needed. For additional details, refer to the User Guide available at

ui.com/download/airmax-ac

Installer Compliance Responsibility

Devices must be professionally installed and it is the professional installer’s

responsibility to make sure the device is operated within local country regulatory

requirements.

Antenna

Select your antenna from the list. If Calculate EIRP Limit is enabled, transmit output

power is automatically adjusted to comply with the regulations of the applicable country.

For a Custom antenna, Antenna Gain is entered manually. Note the requirements and

antenna types listed below.

Cable Loss (When applicable)

Enter the cable loss in dB. Output power is adjusted to compensate for loss between

the radio and the antenna.

Certified Antenna Types

This radio transmitter FCC ID: SWX-BDBAC / IC: 6545A-BDBAC has been approved

by FCC / ISED Canada to operate with the antenna types listed below with the

maximum permissible gain for each antenna type indicated. Antenna types not included

in this list or having a gain greater than the maximum gain indicated for that type, are

strictly prohibited for use with this device.

Antenna Frequency Gain

Omni 2.4 GHz

5 GHz

13 dBi

Sector 2.4 GHz

5 GHz

17 dBi

22 dBi

Dish 2.4 GHz

5 GHz

24 dBi

34 dBi

Specifications

BulletAC-IP67 Quick Start Guide

BulletAC-IP67BulletAC-IP67

Dimensions 190 x 46 mm (7.72 x 1.81")

Weight 213 g (7.51 oz)

Enclosure Aluminum and Rubber

Processor MIPS 74KC

Memory DDR2 64MB

Networking Interface (1) 10/100/1000 Ethernet Port

Antenna Connector N-Type Connector

Max. Power Consumption 7W

Max. TX Power 22 dBm

Power Supply 24VDC, 0.3A (Minimum)*

Power Method 24V Passive PoE (Pairs 4, 5+; 7, 8 Return)

Shock and Vibration ETSI300-019-1.4

ESD/EMP Protection ±24kV Contact / Air

Operating Temperature -40 to 70° C

(-40 to 158° F)

Operating Humidity 5 to 95% Noncondensing

Weatherproofing IP67

Certifications CE, FCC, IC

* Not included with the BulletAC-IP67.

Operating Frequency (MHz)

US/CA 2400 - 2483.5

U-NII-1 5150 - 5250

U-NII-2A 5250 - 5350

U-NII-2C 5470 - 5725

U-NII-3 5725 - 5850

Worldwide 2400 - 2483.5

5150 - 5875

Safety Notices

1. Read, follow, and keep these instructions.

2. Heed all warnings.

3. Only use attachments/accessories specified by the manufacturer.

WARNING: Do not use this product in location that can be submerged by water.

WARNING: Avoid using this product during an electrical storm. There may be a remote

risk of electric shock from lightning.

Electrical Safety Information

1. Compliance is required with respect to voltage, frequency, and current requirements indicated

on the manufacturer’s label. Connection to a different power source than those specified may

result in improper operation, damage to the equipment or pose a fire hazard if the limitations are

not followed.

BulletAC-IP67 Quick Start Guide

2. There are no operator serviceable parts inside this equipment. Service should be provided only

by a qualified service technician.

Limited Warranty

ui.com/support/warranty

The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and,

where applicable, specify arbitration instead of jury trials or class actions.

Compliance

FCC

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions.

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful interference to radio

communications. Operations of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

This radio transmitter has been approved by FCC.

ISED Canada

CAN ICES-3(A)/NMB-3(A)

This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to

the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

This radio transmitter has been approved by ISED Canada.

The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential

for harmful interference to co-channel mobile satellite systems.

CAN ICES-3(A)/NMB-3(A)

Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1. l’appareil ne doit pas produire de brouillage;

2. l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible

d’en compromettre le fonctionnement.

Le présent émetteur radio a été approuvé par ISDE Canada.

Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une

utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de

satellites mobiles utilisant les mêmes canaux.

IMPORTANT NOTE

Radiation Exposure Statement

BulletAC-IP67 Quick Start Guide

This equipment complies with radiation exposure limits set forth for an uncontrolled

environment.

This equipment should be installed and operated with minimum distance 256 cm between the

radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

AVIS IMPORTANT

Déclaration sur l’exposition aux rayonnements

Cet équipement est conforme aux limites prévues pour l’exposition aux rayonnements dans un

environnement non contrôlé.

Lors de l’installation et de la mise en fonctionnement de l’équipement, assurez-vous qu’il y ait

une distance minimale de 256 cm entre l’élément rayonnant et vous.

Cet émetteur ne doit être installé à proximité d’aucune autre antenne ni d’aucun autre émetteur,

et ne doit être utilisé conjointement à aucun autre de ces appareils.

Australia and New Zealand

Warning: This equipment is compliant with Class A of CISPR 32. In a residential

environment this equipment may cause radio interference.

Brazil

Nota: Este equipamento não tem direito à proteção contra interferência prejudicial e não

pode causar interferência em sistemas devidamente autorizados.

CE Marking

CE marking on this product represents the product is in compliance with all directives that are

applicable to it.

Country List

AT BE BG CY CZ DE DK EE EL ES FI FR HR HU

IE IT LV LT LU MT NL PL PT RO SE SI SK UK

BFWA (Broadband Fixed Wireless Access) members noted in blue

Note: This device meets Max. TX power limit per ETSI regulations.

The following apply to products that operate in the 5 GHz frequency range:

Note: This device is restricted to indoor use only when operating in the 5150 - 5350 MHz

frequency range within all member states.

Note: All countries listed may operate at 30 dBm. BFWA member states may operate at 36

dBm.

Note: Operation in the 5.8 GHz frequency band is prohibited in BFWA member states.

Other countries listed may use the 5.8 GHz frequency band.

RoHS/WEEE Compliance Statement

BulletAC-IP67 Quick Start Guide

Inhaltsverzeichnis

Andere Ubiquiti Drahtloser Zugangspunkt Handbücher

Ubiquiti

Ubiquiti LTU-Lite Bedienungsanleitung

Ubiquiti

Ubiquiti GigaBeam GBE Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM365 Bedienungsanleitung

Ubiquiti

Ubiquiti UBB Bedienungsanleitung

Ubiquiti

Ubiquiti PBE-M5-620 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Bedienungsanleitung

Ubiquiti

Ubiquiti PBE-5AC-400-ISO-EU Bedienungsanleitung

Ubiquiti

Ubiquiti BULLETM2-HP-US Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStationM Series Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF 60 Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-24HD Bedienungsanleitung

Ubiquiti

Ubiquiti UF-Nano Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-AC-LITE Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Dream Machine Beacon Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-AC-IW Bedienungsanleitung

Ubiquiti

Ubiquiti NBE-5AC-Gen2 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi WiFi BaseStationXG UWB-XG-BK Bedienungsanleitung

Ubiquiti

Ubiquiti PrismStation 5AC Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AP AC Lite Bedienungsanleitung

Ubiquiti

Ubiquiti RocketM Series Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-IW-HD Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-IW-HD Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-5XHD Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung

Draytek

Draytek VIGORAP 902 Bedienungsanleitung

EnGenius

EnGenius EAP350 Bedienungsanleitung