V-tech v 2651 Bedienungsanleitung
Important Safety Instructions
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and injury, including the
following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen
sink, or swimming pool).
5. Do not place this product on an unstable cart, stand, or table. The product
may fall, causing serious damage to the product.
6. Slots and openings in the cabinet and the back or bottom are provided for
ventilation. To protect it from overheating, these openings must not be
blockedbyplacingtheproductonthebed,sofa,rug,orothersimilarsurface.
Thisproductshouldneverbeplacednearoroveraradiatororheatregister.
This product should not be placed in a built-in installation where proper
ventila-tion is not provided.
7. Thisproductshouldbeoperatedonlyfromthetypeofpowersourceindicated
onthemarkinglabel.Ifyouarenotsureofthetypeofpowersupplytoyour
home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it.
9. Never push objects of any kind into this product through cabinet slots as
theymaytouchdangerousvoltagepointsorshortoutpartsthatcouldresult
inariskoffireorelectricshock.Neverspillliquidofanykindontheproduct.
10. To reduce the risk of electric shock, do not disassemble this product, but
take it to an authorized service facility. Opening or removing cabinet parts
other than specified access doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause electric shock when the
appliance is subsequently used.
11. Do not overload wall outlets and extension cords as this can result in the
risk of fire or electric shock.
12.Unplug this product from the wall outlet and refer servicing to a VTech
authorized service facility under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions, because improper adjustment of other controls
mayresultindamageandwilloftenrequireextensiveworkbyaVTech
authorized technician to restore the product to normal operation.
E. If the product has been dropped and the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
13.Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lighting.
14.Do not use the telephone to report a gas leak in the vicinity of the leak.
VTECH COMMUNICATIONS INC
SERVICE DEPT. at1-800-595-9511.InCanada,call VTechTelecommunications
Canada Ltd. at 1-800-267-7377.
SAVE THESE INSTRUCTIONS
!
The v 2651 is an advanced cordless telephone that operates in the 2.4GHz
frequency range. Your v 2651 is capable of supporting up to a maximum of 4
Handsets. Using additional Handsets, up to three people can be conferenced
on a call (2 Handsets and the Base Speakerphone), or two extensions can be
conferencedonacall,whiletwootherextensionscanbetalkinginternally,using
the Intercom feature.
This manual is designed to familiarize you with the v 2651 cordless telephone.
We strongly recommend you read the manual before using your phone.
Toorder additionalsystem Handsets(model#v2600), batterypacks,
or headsets, call VTech Communications Inc at 1-800-595-9511.
Introduction
IMPORTANT
Please record the Base ID#(BS ID) printed on the underside of the v 2651
Baseinthespacebelow. Pleasebecertaintoincludeall15digits/characters.
Base ID #
STOP!!
If you have questions about this product, or
if you're having difficulty with setup or
operation, do not return your phone to the
store. Call our Customer Support Center at
1-800-595-9511
In Canada, call
1-800-267-7377
"
Parts Check List
5Battery Pack
6.User'sManual
7. Wall Mounting Bracket
To purchase replacement battery packs, call VTechCommunications Inc at
1-800-595-9511.InCanada,callVTechTelecommunicationsCanadaLtd. at1-800-
267-7377.
1.Base Unit
2.Handset
3.AC Power Adapter
4.Telephone Cord
AC Power Adapter
Telephone Cord
Handset Base Unit
Wall mounting Bracket
Users Manual
Battery Pack
#
The Handset Layout
1. Antenna
2. Earpiece
3. Scroll Keys
4. Headset Jack (2.5mm)
5. On (Flash)
6. Dialing Keys (0-9, *, #)
7. Handsfree Speakerphone
8. LCD Display
9. Menu/Select
10. Off (Clear)
11. Battery Compartment
12. Intercom
13. Microphone
3
2
6
11
10
12
5
1
7
8
9
4
$
1. Intercom
2. Flash
3. Mute
4. Redial
5. Charging LED
6. Dialing Keys (0-9, *, #)
11. DC Connector
12. Telephone Jack
The Base Unit Layout
1
4
7
8
9
5
MO EL: 2651
VTECH TELECOMMUNICATIONS LT .
MANUFACTURE IN CHINA
COMPLIES WITH 47 CFR PART 68
REGISTRATION NO.: US: 6BXWI01B80-XXXXXX
RINGER EQUIVALENCE: 0.1B
USOC JACK: RJ11C/W
THIS EVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CON ITIONS:
1) THIS EVICE MAY NOT CAUSE HARMFUL INTERFERENCE; AN
2) THIS EVICE MUST ACCEPT ANY INTERFERENCE RECEIVE ,
INCLU ING INTERFERENCE THAT MAY CAUSE UN ESIRE
OPERATION.
PRIVACY OF COMMUNICATIONS MAY NOT BE ENSURE WHEN
USING THIS PHONE.
HAC FCC I : EW72230P2
VTECH TELECOMMUNICATIONS LT .
C 9V 500mA
CLASS 2 POWER SOURCE ONLY
COR LESS TELEPHONE
3
2
6
11
12
10
7. Speakphone Key
8. Charge Contacts
9. In Use
10.Volume
%
Setup
Plug the AC power adapter into an electrical outlet, and the
DC connector into the back of the base unit.
To AC outlet
To telephone
jack
To telephone
outlet AC adapter
VTECH TELECOMMUNICATIONS LT .
C 9V 500mA
CLASS 2 POWER SOURCE ONLY
COR LESS TELEPHONE
CAUTION:Use only the VTech power supply provided with your VTech unit.
IMPORTANT:
FORMAXIMUMPERFORMANCE OF YOUR
CORDLESS TELEPHONE SYSTEM:
1. Chooseacentral locationforyourBaseUnit.
2. Install your Base Unit and Extension
Handsets away from electronic equipment,
such as personal computers, television sets
and microwave ovens.
3. In locations where there are multiple
cordlesstelephones,separateBaseunits
as much as possible.
4. Install your telephone equipment away
from heat sources and sunlight.
5. Avoid excessive moisture,dust orextreme cold.
Connecting Power to Base Unit
Getting Started
&
Follow the steps below:
1.Remove the battery cover by
pressingontheindentandsliding
downward.
2.Align the two holes in the plug
with the socket pins. Insert the
plugintosocket.Placethebattery
pack into the compartment with
the wires coming out of one of
the bottom corners of the pack.
3.Replace the battery cover by
sliding it upwards.
4.If the new battery pack is not
already charged, place the
Handset in the Base unit, or a
remotechargingstand,andallow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
Setup
TheoriginalHandsetthatisshippedwithyourv2651systemwillbeautomatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extensionnumbersinthefollowingorder:HANDSET2,HANDSET3,andfinally
HANDSET 4.
After a Handset battery pack is installed, the Handset will automatically begin
SEARCHINGFOR BASE (ifpreviouslyregistered),oritwillpromptyoutoENTER
BASE ID to register the new Handset.
Installation of Battery Pack in Handset
Getting Started
'
Charging Of Handset Battery Pack
The Handset of your v 2651 cordless telephone is powered by a
rechargeable battery pack. It charges automatically whenever the Handset is
intheBaseUnit.Maximumtalktimeonafullchargeis7.5hours.Maximumstandby
time is over 5 days.
Youshouldchargethebatterypackfor12hourswhenyoufirstreceiveyour
phone. You'll know the battery pack needs charging when:
• The low battery message is displayed :
• The handset seems completely dead,
the LCD is completely clear and does
not activate when you press the keys.
IMPORTANT:
1.Do not dispose of a battery pack in a fire, the cell may explode.
2.Donotopenormutilatethebatterypack. Toxicsubstancesmaybereleased,
causing harm to eyes or skin.
3.Exercise care in handling battery packs in order to prevent an accidental
shortofthechargecontacts,potentiallycausingthebatterypacktooverheat.
4.Donotdispose ofthisbatterypackintohouseholdgarbage.Forinformation
concerning proper battery recycling or disposal, please contact your local
Recycling Center or Disposal Service.
Getting Started
Connecting to phone line
Plug one end of the telephone line cord into the jack on the back of the Base
unit. Plug the other end of this cord into the wall telephone jack.
Checking for dial tone
After the battery ischarged pressON ontheHandset. ThePhoneicon will
appear on the handset display, and you will hear dial tone. If not, see In Case
of Difficulty.
To telephone
jack
To telephone outlet
AC adapter
VTECH TELECOMMUNICATIONS LT .
C 9V 500mA
CLASS 2 POWER SOURCE ONLY
COR LESS TELEPHONE
2
1
3
The Wall Mount bracket is designed for use on standard Wall Mount plates only.
1.Line up the tabs on the wall mount adapter with the holes on the bottom
of the base unit. Snap the wall mount bracket firmly in place.
2.Plug the AC adapter into an electrical outlet, and the DC connector to the
bottom of the base unit. If the handset battery pack has not been charged
previously, place the handset in the base unit cradle, and allow it to charge
for 12 hours.
3.Connect the telephone line cord to the jack on the bottom of the base unit,
and the other end to the telephone jack.
4.Mountthebaseunitonthewall. Positionthebaseunitsothemountingstuds
will fit into the holes on the wall mount bracket. Slide base unit down on
the mounting studs until it locks into place.
Walling Mounting
Getting Started
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere V-tech Schnurloses Telefon Handbücher
V-tech
V-tech DS6520-22 Bedienungsanleitung
V-tech
V-tech DS6121 Bedienungsanleitung
V-tech
V-tech LS6245 Bedienungsanleitung
V-tech
V-tech DS6751 Bedienungsanleitung
V-tech
V-tech CS6858-33 Bedienungsanleitung
V-tech
V-tech ia5829 - Cordless Phone - Operation Bedienungsanleitung
V-tech
V-tech LS6125-2 Bedienungsanleitung
V-tech
V-tech T2440 - 2.4GHz Dual Handset Cordless System Bedienungsanleitung
V-tech
V-tech CTM-A2415 Bedienungsanleitung
V-tech
V-tech IP8300 Bedienungsanleitung
V-tech
V-tech mi6879 Bedienungsanleitung
V-tech
V-tech GZ2456 - VMix Cordless Phone Bedienungsanleitung
V-tech
V-tech CS6120-2 Bedienungsanleitung
V-tech
V-tech T2308 Bedienungsanleitung
V-tech
V-tech LS1400 Bedienungsanleitung
V-tech
V-tech sbc20-2432 Bedienungsanleitung
V-tech
V-tech t2326 Bedienungsanleitung
V-tech
V-tech VT 9171 Bedienungsanleitung
V-tech
V-tech CS6328-2 Bedienungsanleitung
V-tech
V-tech DS6621 Bedienungsanleitung
