V-tech vt2467 Bedienungsanleitung
1
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen
sink, or swimming pool).
5. Do not place this product on an unstable cart, stand, or table. The product
may fall, causing serious damage to the product.
6. Slots and openings in the cabinet and the back or bottom are provided
for ventilation. To protect it from overheating, these openings must not
be blocked by placing the product on the bed, sofa, rug, or other similar
surface. This product should never be placed near or over a radiator or
heat register. This product should not be placed in a built-in installation
where proper ventilation is not provided.
7. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supply to your home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it.
9. Never push objects of any kind into this product through cabinet slots as
they may touch dangerous voltage points or short out parts that could result
in a risk of fire or electric shock. Never spill liquid of any kind on the
product.
10. To reduce the risk of electric shock, do not disassemble this product, but
take it to a VTech authorized service facility. Opening or removing cabinet
parts other than specified access doors may expose you to dangerous
voltages or other risks. Incorrect reassemb-ling can cause electric shock
when the appliance is subsequently used.
11. Do not overload wall outlets and extension cords as this can result in the
risk of fire or electric shock.
Important Safety Instructions
2
12. Unplug this product from the wall outlet and refer servicing to a VTECH
authorized service facility under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions, because improper adjustment of other controls
may result in damage and will often require extensive work by a VTech
authorized technician to restore the product to normal operation.
E. If the product has been dropped and the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lighting.
14. Do not use the telephone to report a gas leak in the vicinity of the leak.
VTECH COMMUNICATIONS INC
SERVICE DEPT. at 1-800-595-9511. In Canada, call VTech Electronics Ltd
at 1-800-267-7377.
SAVETHESE INSTRUCTIONS
3
The GIGAPHONE is an advanced cordless telephone that operates in the 2.4GHz
frequency range. Your GIGAPHONE is capable of supporting up to a maximum
of 4 Handsets. Using additional Handsets, up to three people can be conferenced
on a call (2 Handsets and the Base Speakerphone), or two extensions can be
conferenced on a call, while two other extensions can be talking internally, using
the Intercom feature.
This manual is designed to familiarize you with the GIGAPHONE cordless
telephone. We strongly recommend you read the manual before using your
phone.
To order additional system Handsets (model# VT 2420), battery
packs, or headsets, call VTech Communications Inc at 1-800-595-
9511.
Introduction
IMPORTANT
Please record the Base ID#(BS ID) printed on the underside of the
GIGAPHONE Base in the space below. Please be certain to include all 15
digits/characters.
Base ID #
4
Parts Check List
5. Battery Pack
6. Wall Mounting Bracket
7. Belt clip
8. Owner's Manual
9. Quick Reference Guide
To purchase replacement battery packs, call VTech Communications Inc
at 1-800-595-9511. In Canada, call VTech Electronics Ltd at 1-800-267-7377.
1. Base Unit
2. Handset
3. AC Power Adapter
4. Telephone Cord
Telephone Line Cord
AC PowerAdapter
Handset
Battery Pack
Base Unit
Wall Mounting Bracket
Belt Clip
Owner's Manual
OWNER'S MANUAL
Quick Reference Guide
QRC
5
The Handset Layout
1. Antenna
2. Message Waiting Indicator
3. Earpiece
4. Headset Jack (2.5mm)
5. Scroll Keys
6. On (Flash)
7. Dialing Key (0-9)
8. Handsfree Speakerphone
9. LCD Display
10. Select
11. Off (Clear)
12. Battery Compartment
13. Intercom
14. Microphone
1
3
4
5
6
7
8
9
10
11
14
12
2
13
6
1. Page
2. Charging Contacts
3. Power Indicator
4. Line In Use Indicator
5. Charge Indicator
6. Volume Keys
7. Answer ON/OFF Key
8. Repeat/Slow Key
9. Skip/Quick Key
10. MailBox Keys
11. Erase
12. Menu
13. Select
14. Time/Set
15. Record
16. Spare Battery drawer
17. Spare Battery Release
18. Tone/Pulse
19. DC Connector
20. Telephone Jack
The Base Unit Layout
1
10
11
12
13
14
2
3
6
7
9
8
4
515
17
16 18
19
20
TONE
PULSE
7
Setup
1. Plug the AC power adapter into an electrical outlet, and the DC connector
into the back of the base unit.
Connecting to phone line
Plug one end of the telephone line cord into the jack on the back of the base
unit. Plug the other end of this cord into the wall jack.
Checking for dial tone
After the battery is charged press ON on the Handset. The Phone icon will
appear on the handset display, and you will hear dial tone. If not, see In Case
of Difficulty.
To AC outlet
To telephone
jack
To telephone
socket outlet
AC adapter
TONE
PULSE
Getting Started
8
TONE
PULSE
TONE
PULSE
IMPORTANT:
For best performance the
GIGAPHONE should be installed as
follows:
In an elevated location, in the center
of the room, with no obstructions
nearby.
In a location that is away from other
electrical appliances such as
microwave ovens, personal
computers, or televisions.
Tone/Pulse selection
The TONE/PULSE switch is located
on the bottom of the Base Unit and
fartory set to TONE. If you have touch
tone service, do not change the switch
setting. If you have rutary (Pulse)
service, set the switch to PULSE.
CAUTION: Use only the Vtech power supply provided with your VTECH.
Base Tone/pulse
Getting Started
9
Follow the steps below:
1. Remove the battery cover by
pressing on the indent and
sliding downward.
2. Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts
in the battery compartment.
3. Replace the battery cover by
sliding it upwards.
4. If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and allow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
Installation of Battery Pack in Handset
The original Handset that is shipped with your GIGAPHONE system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally
HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically
begin SEARCHING FOR BASE (if previously registered), or it will prompt
you to ENTER BASE ID to register the new Handset.
1
3
2
Getting Started
10
Spare Battery Charger/Power Backup Function
1. Open the spare battery charger
by pressing the release button,
located on the right-hand side of
the Base Unit. A drawer will
open to reveal the spare battery
compartment.
2. Place a battery pack in the drawer
with the charge contacts facing
up and to the left.
3. Push the drawer closed.
The spare battery takes 24 hours to
fully charge a drained battery.
The GIGAPHONE uses the spare battery charger in the Base Unit. To provide
operational backup in the event of a power failure with the a fully charged battery
pack in the spare battery charger, you will still be able to place a receive calls
from the handset for up to 5 hours.
The spare battery pack can also be used to replace a drained handset battery,
ensuring uninterrupted use.
NOTE :
When using the GIGAPHONE during Power Backup mode, audio quality may
be compromised due to reduced Power availability.
2
CAUTION:TO
REDUCE RISK OF FIRE,
USE ONLY VTECH
80-5017-00-00
CAUTION:TO
REDUCE RISK OF FIRE,
USE ONLY VTECH
80-5017-00-00
BATTERY
INSTALL
THIS
SIDE UP
3
1
TONE
PULSE
Getting Started
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere V-tech Schnurloses Telefon Handbücher
V-tech
V-tech t2308 Benutzerhandbuch
V-tech
V-tech 9119 Bedienungsanleitung
V-tech
V-tech DS6121 Bedienungsanleitung
V-tech
V-tech DS3101 Bedienungsanleitung
V-tech
V-tech Cordless Telephone Bedienungsanleitung
V-tech
V-tech TeleZapper VT2558 Bedienungsanleitung
V-tech
V-tech 918 ADX Bedienungsanleitung
V-tech
V-tech DECT 6.0 LS6315 Series Bedienungsanleitung
V-tech
V-tech CD1103 Bedienungsanleitung
V-tech
V-tech DS6151 - 6.0 Expandable Cordless Phone Bedienungsanleitung
V-tech
V-tech DS6121 Bedienungsanleitung
V-tech
V-tech i 5853 Benutzerhandbuch
V-tech
V-tech DS6670-6C Bedienungsanleitung
V-tech
V-tech VTV2656/2V2600 - V-tech. 2.4 GHz Phone Bedienungsanleitung
V-tech
V-tech mi 6861 Bedienungsanleitung
V-tech
V-tech VT 1932 Bedienungsanleitung
V-tech
V-tech 18150 TWIN Bedienungsanleitung
V-tech
V-tech 2468 - VT Cordless Phone Bedienungsanleitung
V-tech
V-tech i 5871 Bedienungsanleitung
V-tech
V-tech t2429 - 2.4 GHz Analog Cordless Phone Benutzerhandbuch
