Vax ACTION 602 U86-AN-BE Technisches Datenblatt

vax.co.uk

U86-AN-Be/U86-AN-Pe/U86-IN2-Pe

Action 602

Let’s get started

Basic safety precautions

Don’ts

8Don’t use this vacuum cleaner if

it has been dropped, damaged or

left outdoors.

8Don’t run over the power cord or use

vacuum cleaner if the power cord

or plug is damaged. Please contact

our Customer Care Line on:

0330 026 8455 (Mon-Fri 8.30am

to 6.30pm, Sat 9.00am to 5.00pm).

8Don’t handle the plug or use the

vacuum cleaner with wet hands.

8Don’t pull or carry this vacuum

cleaner by the power cord. Don’t use

the power cord as a handle, pull the

power cord around corners, sharp

edges or close a door over the power

cord. Don’t unplug vacuum cleaner

by pulling on the power cord.

8Don’t vacuum up any ammable

or combustible materials (lighter

uid, petrol, kerosene etc.) or use

the vacuum cleaner in an area with

explosive vapours or liquid.

8Don’t vacuum up hot coals, cigarette

butts, matches or smoking hot

burning items or use in an area

where there may be harmful uids

(chlorine, bleach, and ammonia

drain cleaner).

Let’s talk safety

This vacuum cleaner is intended

for household use only and NOT for

commercial or industrial use.

• Only use the vacuum cleaner indoors

on dry surfaces and keep the area

your cleaning well lit.

• Keep ngers, hair and loose clothing

from moving parts and openings

whilst using the vacuum cleaner.

• This vacuum cleaner can be used

by children aged from 8 years and

above and persons with reduced

physical, sensory or mental

capabilities or lack of experience and

knowledge if they have been given

supervision or instruction concerning

use of the vacuum cleaner in a safe

way and understand the hazards

involved. Children shall not play with

the vacuum cleaner. Cleaning and

user maintenance shall not be made

by children without supervision.

• Only Vax recommended tools should

be used with this vacuum cleaner.

Please keep instructions for

further use.

Do’s

3Turn o all controls on the vacuum

cleaner before disconnecting or

connecting the power cord.

3Always make sure lters are in place

before use.

3Always switch o the

vacuum cleaner before

disconnecting or connecting

the hose and accessories.

3Keep all openings clear and free

from debris as this may aect the

airow/suction.

3Always replace the fuse in the plug

with a British 13amp fuse. Always

protect the power cable from heated

surfaces and open ames.

3Take extra care when positioning

and using the vacuum cleaner

on the stairs.

3Use only CE approved 13amp

extension cords, non-approved

extension cords may overheat.

Care should be taken to

arrange the extension cord

as it can be a trip hazard.

3Store your vacuum cleaner in a cool,

dry area. If lters have been cleaned

as per user guide instructions

ensure they are thoroughly dry

before storing away.

Don’ts

8Don’t attempt to remove blockages

with sharp objects as this may cause

damage to your vacuum cleaner.

8Don’t vacuum up hard or sharp

objects such as glass, nails, screws

or coins etc.

8Don’t use the vacuum cleaner with

incorrect voltage as this may result

in damage or injury to the user.

The correct voltage is listed on the

ratings label.

Let’s talk safety

Taking care of you

We’re here if you need us. Instead of taking me back

to the shop, simply visit:

vax.co.uk/support or call:

(UK) 0330 026 8455 (ROI) 1-800 928 308

Monday-Friday 8.30am to 6.30pm, Saturday 9.00am to 5.00pm

Calls are charged at the UK local rate. Please make a note of the serial number and model number

of the product before calling.

Alternatively, you can write to us at:

Vax Ltd., Plot 302, Stonebridge Cross Business Park, Hampton Lovett, Droitwich,

Worcestershire, WR9 0LW, UK

This user guide can also be found online at: vax.co.uk/support

Let us know what you think @VaxUK

Thank you for buying this Action 602.

Taking care of your carpets

The Action 602 is designed to make washing carpets regularly, as eective and ecient

as possible and this user guide will help you get the most out of your machine.

Maintaining your carpets will ensure they keep their appearance for longer and smell fresh and

clean. You’ve chosen the carpets for your home for a reason and Vax will help you take good care

of them.

Taking care of your Action 602

Also inside this guide are instructions on maintaining your new machine, so that it’s always ready

when you are to tackle your carpets.

Contents

Let’s talk safety

Getting to know your machine

Getting started

Using your machine

Taking care of your machine

Let’s talk technical

What to do if it goes wrong

Getting in touch

Accessories

Notes

Action 602

Included with

your machine

Action 602 Pet

TurboTool

Reach extension hose 2.2m

Reach extension hose 1.5m

2 in 1 dusting/upholstery

& crevice tool

Extension tube

Hard oor tool

Action 602 Reach

Initial Setup for normal operation

1. Use the base accessories.

a. Shortest hose.

b. Extension tube set to shortest practicable length.

2. Clean lters installed.

3. Dust receptacle empty.

4. All Bleeds must be closed.

5. Variable Power set to Maximum.

6. Floor heads/tools set to Carpet Mode for carpet cleaning.

7. Mechanical Agitation turned ON for carpet cleaning.

8. Floor heads/tools set to Hard Floor Mode for hard oor cleaning.

9. Mechanical Agitation turned OFF for hard oor cleaning.

Extension tube

and crevice

Handle release button

Dust brush holder

(some models only)

Handle

Turbo tool holder

(some models only)

Carry handle

Dirt container

release button

Separator

Dirt container lid

Dirt container

HEPA pre-motor lter

(hidden)

Dirt release clip

Upper release

cord hook

Hose to machine

connector

Height adjuster dial

Name Action 602

Voltage 220-240V-50Hz

Wattage 900 Air Watts

Cord length 7m

Weight 7.5kg

Technical Specication

Subject to technical change without notice.

Filter Kit (Type 110)

1-1-134394

Belt Kit Type 25

1-1-134411

Turbo Tool Type 6*

1-1-134419

Crevice Tool (Type 16)

1-1-134427

Dusting Brush (Type 10)

1-1-134426

Pro Cleaning kit

(1-1-133326)

Accessories & Consumables

* Selected models only.

To purchase consumables and accessories, please visit vax.co.uk

Hose connector

Hose inlet

On/o button

Getting to know your machine

Assembling your vacuum cleaner

Lift handle up and click

into place.

Slide 2 in 1 Dusting Brush onto

dust brush holder with brushes

facing outwards.

Line up latch on accessory hose,

push until clicks into place.

Line up turbo tool brushes into

turbo tool holder, push into place

until it clicks (some models only).

Push accessory hose into

hose to machine connector.

Push extension tube and

crevice onto holder.

Before you begin cleaning

IMPORTANT: Always switch o the vacuum cleaner before connecting or disconnecting the hose/attachments

or removing and emptying the dirt container.

IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does

overheat the thermostat will automatically turn the vacuum cleaner o. If this happens switch the vacuum cleaner o

and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.

Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the

lters to fully dry before putting back into the machine).

Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch o and unplug before

removing the blockage.

When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brush bar height adjuster

must be set to the highest setting.

PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE

Getting started

Plug vacuum cleaner into the

mains, switch on. Turn brush

bar height adjuster dial to

desired setting.

Press On/O button to

switch on.

Place foot on oor head

and pull handle to recline.

The accessories can be attached to the extension tube or directly to the hose.

When using accessories on the hose/extension tube raise the height adjuster to the highest setting.

Pull hose out of hose

to machine connector.

Attach accessory

to tube/hose.

Attach accessory hose to

extension hose.

If required attach extension

hose to extension tube.

Using accessories

Choose an accessory.

Using your machine

IMPORTANT: Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/

attachments, or removing and emptying the dirt container.

TIP

For best performance use your

vacuum cleaner with only the

accessory hose attached.

Hard oor cleaning

Hard oor cleaning tool.

Line up oor tool with base of vacuum

cleaner, push it until it clicks into place.

Lie vacuum cleaner on its

back exposing brushbar.

Hold vacuum cleaner with brush bar over tread of stairs.

Using on the stairs

Always raise the height of the brush bar to hard oor setting when using the vacuum cleaner on lino and hard oor.

Using your machine

TIP

Filters require cleaning at least

every three months.

This vacuum cleaner has a

constantly rotating brushbar. When

cleaning on stairs raise the height

adjuster dial to the highest setting.

The brushbar must overhang the

stair tread. Always take care when

cleaning stairs.

WARNING

Press the dirt container

release button, pull to remove.

Emptying the dirt container

Cleaning the HEPA pre-motor lter

Hold dirt container

over a bin.

Press the dirt release clip,

allowing dirt/debris to fall out.

Turn the dirt container

release button, pull

to remove.

24hr

Leave to dry for

24 hours or until

fully dry before

placing back in the

vacuum cleaner.

Turn the HEPA

pre-motor lter

anti-clockwise,

pull to remove.

Tap HEPA pre-motor

lter over a bin to remove

any dirt/debris.

Rinse under water

(max 40°C).

Line up HEPA

pre-motor lter tabs

in dirt container lid,

turn clockwise until it

clicks into place.

Taking care of your machine

Filters require cleaning at least every 3-6 months (depending on the level of use).

Don’t use your vacuum cleaner without all the lters in place.

IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the

thermostat will automatically turn the machine o. Switch o and unplug the vacuum cleaner. Check the machine

for blockages and clean the lters. Wash the lters with warm water (40°C max) and leave for 24 hours or until

fully dry before replacing into the machine.

TIP

Don’t over ll the dirt

container to avoid blocking

the air ow through the

vacuum cleaner and replace

lters every 6-9 months.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Vax Staubsauger Handbücher

Vax

Vax MACH PET Montageanleitung

Vax

Vax Rapide Ultra W90-RU-B Bedienungsanleitung

Vax

Vax W86-DP-B Montageanleitung

Vax

Vax Floormate V-120 Bedienungsanleitung

Vax

Vax White Bedienungsanleitung

Vax

Vax Cadence V-044AA Bedienungsanleitung

Vax

Vax Performance Cyclonic V-008SC Bedienungsanleitung

Vax

Vax Air Series Bedienungsanleitung

Vax

Vax U90-P1 Series POWER1 Bedienungsanleitung

Vax

Vax Rapide Ultra VCWRU1000 Bedienungsanleitung

Vax

Vax V-091 Bedienungsanleitung

Vax

Vax V-2300U Bedienungsanleitung

Vax

Vax VPS4 Bedienungsanleitung

Vax

Vax U89-VU-R-A Bedienungsanleitung

Vax

Vax VX2 Bedienungsanleitung

Vax

Vax H89-12V Series Bedienungsanleitung

Vax

Vax H87-T1-B Bedienungsanleitung

Vax

Vax SLIMVAC VX63 Bedienungsanleitung

Vax

Vax Energise Vibe C85-E2-Be Montageanleitung

Vax

Vax VZL-6013 Bedienungsanleitung

Vax

Vax Flair C86-FD-Be Montageanleitung

Vax

Vax POWER ESSENTIALS VEC-41 Bedienungsanleitung

Vax

Vax VX3 Bedienungsanleitung

Vax

Vax V-2000 U Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung