Vax Impact 502 Montageanleitung

vax.co.uk

U86-IN-(Be, Pe)

Impact 502

Let’s get started

This vacuum cleaner is intended

for household use only and NOT for

commercial or industrial use.

•

Only use the vacuum cleaner indoors

on dry surfaces and keep the area

you’re cleaning well lit.

•

Keep ngers, hair and loose clothing

from moving parts and openings

whilst using the vacuum cleaner.

•

This vacuum cleaner is NOT to be

used by children under eight years

or persons with reduced physical,

sensory or mental capabilities, unless

they have been given instructions

on how to use the machine or are

supervised during use. Any cleaning

or maintenance of your vacuum

cleaner should not be made by children

without supervision and ensure they

don’t play with the vacuum cleaner.

Only Vax recommend tools should be

used with this vacuum cleaner.

Basic safety precautions

Don’ts

Don’t use this vacuum cleaner if it

has been dropped, damaged or

left outdoors.

Don’t run over the power cord or use

vacuum cleaner if the power cord or

plug is damaged. Please contact our

Customer Care Line on: 0844 4128

455 (Mon-Fri 8.30am to 6.30pm, Sat

9.00am to 5.00pm).

Don’t handle the plug or use the

vacuum cleaner with wet hands.

Don’t pull or carry this vacuum

cleaner by the power cord. Don’t use

the Power cord as a handle, pull the

power cord around corners, sharp

edges or close a door over the Power

cord. Don’t unplug vacuum cleaner by

pulling on the power cord.

Don’t vacuum up any ammable

or combustible materials (lighter

uid, petrol, kerosene etc.) or use

the vacuum cleaner in an area with

explosive vapours or liquid.

Don’t vacuum up hot coals, cigarette

butts, matches or smoking hot burning

items or use in an area where there

may be harmful uids (chlorine,

bleach, and ammonia drain cleaner).

Let’s talk safety

Turn o all controls on the vacuum

cleaner before disconnecting or

connecting the power cord.

Always keep the power cord away

from the brushes, heated surfaces

and open ames whilst using your

vacuum cleaner.

After use always wrap the power

cord around the cord clips provided.

Always make sure the lters are in

place before use.

Always switch o the vacuum

cleaner before disconnecting or

connecting the hose and accessories.

Keep all openings clear and free

from debris as this may aect the

airow/suction.

This vacuum cleaner is tted with a

constantly rotating brush bar. To avoid

damage to your ooring, make sure

the brush bar is raised to the highest

setting when using the accessories

and when using on stairs.

Always take extra care when

positioning the vacuum cleaner on

the stairs.

Always replace the fuse in the plug

with a 13amp fuse.

Use only CE approved 13amp extension

cords, non-approved extension cords

may overheat. Care should be taken to

arrange the extension cord as it can be

a trip hazard.

Store your vacuum cleaner in a cool,

dry area. If lters have been cleaned

as per user guide instructions

ensure they are thoroughly dry

before storing away.

Please keep instructions for

further use.

Do’s

Don’ts

Don’t attempt to remove blockages

with sharp objects as this may cause

damage to your vacuum cleaner.

Don’t vacuum up hard or sharp

objects such as glass, nails, screws or

coins etc.

Don’t use the vacuum cleaner with

incorrect voltage as this may result

in damage or injury to the user. The

correct voltage is listed on the

ratings label.

Thank you for buying this Impact 502.

Taking care of your carpets and hard oors

The Impact 502 is designed to make vacuuming regularly, as eective and ecient as possible

and this user guide will help you get the most out of your machine.

Maintaining your carpets and hard oors will ensure they keep their appearance for longer and

Vax will help you take good care of them.

Taking care of your Impact 502

Also inside this guide are instructions on maintaining your new machine, so that it’s always ready

when you are to tackle your carpets and hard oors.

Taking care of you

We’re here if you need us. Instead of taking me back

to the shop, simply visit:

vax.co.uk/support or call:

(UK) 0844 412 8455 (ROI) 1-800 928 308

Monday-Friday 8.30am to 6.30pm, Saturday 9.00am to 5.00pm

Calls are charged at the UK local rate. Please make a note of the serial number and model number

of the product before calling.

Alternatively, you can write to us at:

Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK

Let us know what you think @VaxUK

Contents

Impact 502

Let’s talk safety

Getting to know your machine

Getting started

Using your machine

Taking care of your machine

Let’s talk technical

What to do if it goes wrong

Getting in touch

Accessories

Notes

Included with

your machine

Impact 502 Pet

TurboTool

Reach extension hose 2.2m

Extension hose 1.5m

Dusting brush

Crevice tool

Extension tube

Hard oor tool

Impact 502 Reach

Initial Setup for normal operation

1. Use the base accessories.

a. Shortest hose

b. Extension tube set to shortest practicable length.

2. Clean lters installed.

3. Dust receptacle empty.

4. All Bleeds must be closed.

5. Variable Power set to Maximum.

6. Floor heads/tools set to Carpet Mode for carpet cleaning.

7. Mechanical Agitation turned ON for carpet cleaning.

8. Floor heads/tools set to Hard Floor Mode for hard oor cleaning.

9. Mechanical Agitation turned OFF for hard oor cleaning.

Getting to know your machine

Getting started

Extension tube

and crevice

Handle release button

Dust brush holder

Handle

Turbo tool holder

(some models only)

Carry handle

Dirt container

release button

Separator

Dirt container lid

Dirt container

HEPA pre-motor lter

(hidden)

Dirt release clip

Upper release

cord hook

Height adjuster dial

Name Impact 502

Voltage 220-240V-50Hz

Wattage 900W

Cord length 8m

Weight 5.25kg

Technical Specication

Subject to technical change without notice.

Filter Kit (Type 110)

1-1-134394-00

Belt Kit (Type 25)

1-1-134411 -00

Turbo Tool (Type 6*)

1-1-134419-00

Crevice Tool (Type 16)

1-1-134427-00

Dusting Brush (Type 10)

1-1-134426-00

Accessories & Consumables

* Selected models only.

To purchase consumables and accessories, please visit vax.co.uk

Hose connector

Hose inlet

On/o button

Getting to know your machine

Getting started

Assembling your vacuum cleaner

Lift handle up and click

into place.

Dusting Brush into dusting

brush holder with brushes

facing outwards.

Line up latch on accessory hose,

push until clicks into place.

Line up TurboTool brushes into

TurboTool holder, push into place

until it clicks (some models only).

Push accessory hose into

hose to machine connector.

Push extension tube and

crevice onto holder.

Before you begin cleaning

WARNING: Always switch o the vacuum cleaner before connecting or disconnecting the hose/attachments

or removing and emptying the dirt container

IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does

overheat the thermostat will automatically turn the vacuum cleaner o. If this happens switch the vacuum cleaner o

and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.

Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the

lters to fully dry before putting back into the machine).

Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch o and unplug before

removing the blockage.

When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brush bar height adjuster

must be set to the highest setting.

PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE

Using your machine

TIP

For best performance use your

vacuum cleaner with only the

accessory hose attached.

Plug vacuum cleaner into the

mains, switch on. Turn brush

bar height adjuster dial to

desired setting.

Press On/O button to

switch on.

Place foot on oor head

and pull handle to recline.

IMPORTANT: Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/

attachments, or removing and emptying the dirt container.

The accessories can be attached to the extension tube or directly to the hose.

When using accessories on the hose/extension tube raise the height adjuster to the highest setting.

Pull hose out of hose

to machine connector.

Attach accessory

to tube/hose.

Attach accessory hose to

extension hose.

If required attach extension

hose to extension tube.

Using accessories

Choose an accessory.

Using your machine

This vacuum cleaner has a

constantly rotating brush bar.

When cleaning on stairs raise the

height adjuster dial to the highest

setting. The brush bar must

overhang the stair tread. Always

take care when cleaning stairs.

WARNING

Hard oor cleaning

Hard oor cleaning tool.

Line up oor tool with base of vacuum

cleaner, push it until it clicks into place.

Lie vacuum cleaner on its

back exposing brush bar.

Hold vacuum cleaner with brush bar over tread of stairs.

Using on the stairs

Always raise the height of the brush bar to hard oor setting when using the vacuum cleaner on lino

and hard oor. Apply the hard oor adaptor for optimum results on hard oors.

TIP

To ensure the oor tool is

correctly tted, the wheels

should be towards the back of

the oor tool when attached to

vacuum cleaner.

Taking care of your machine

Press the dirt container

release button, pull to remove.

Emptying the dirt container

Cleaning the HEPA pre-motor lter

Hold dirt container

over a bin.

Press the dirt release clip,

allowing dirt/debris to fall out.

Turn the dirt container

release button, pull

to remove.

Leave to dry for

24 hours or until

fully dry before

placing back in the

vacuum cleaner.

Turn the HEPA

pre-motor lter

anti-clockwise,

pull to remove.

Tap HEPA pre-motor

lter over a bin to remove

any dirt/debris.

Rinse under water

(max 40°C).

Line up HEPA

pre-motor lter tabs

in dirt container lid,

turn clockwise until it

clicks into place.

IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the

thermostat will automatically turn the machine o. Switch o and unplug the vacuum cleaner. Check the machine

for blockages and clean the lters. Wash the pre-motor lters with warm water (40°C max) and leave for 24

hours or until fully dry before replacing into the machine.

Filters require cleaning at least every 3-6 months (depending on the level of use).

Don’t use your vacuum cleaner without all the lters in place.

TIP

Don’t over ll the dirt

container to avoid blocking

the air ow through the

vacuum cleaner and replace

lters every 6-9 months.

Andere Handbücher für Impact 502

Inhaltsverzeichnis

Andere Vax Staubsauger Handbücher

Vax

Vax Zoom U87-ZM-B Bedienungsanleitung

Vax

Vax HF86-FM-T Technisches Datenblatt

Vax

Vax V-2400C Bedienungsanleitung

Vax

Vax Platinum SmartWash CDCW-SWXS Montageanleitung

Vax

Vax U90-P2 Series Bedienungsanleitung

Vax

Vax ultrixx V-040 Bedienungsanleitung

Vax

Vax VX13 Montageanleitung

Vax

Vax U91-MA-Be Montageanleitung

Vax

Vax Rapide Spring Fresh V-021T Bedienungsanleitung

Vax

Vax Ultrixxcobalt Bedienungsanleitung

Vax

Vax VXCB-01 Bedienungsanleitung

Vax

Vax U86-PF Series Montageanleitung

Vax

Vax U90-VU Series Bedienungsanleitung

Vax

Vax Platinum SmartWash CDCW-SWXP Bedienungsanleitung

Vax

Vax C85-AC-PH-E Bedienungsanleitung

Vax

Vax Impact 306 Bedienungsanleitung

Vax

Vax VHFM700 Bedienungsanleitung

Vax

Vax 6131 Bedienungsanleitung

Vax

Vax Floormate V-120 Bedienungsanleitung

Vax

Vax VX60 Bedienungsanleitung

Vax

Vax 88000 Bedienungsanleitung

Vax

Vax W85-PP-T Dual Power Pro Bedienungsanleitung

Vax

Vax C85-Z1-Be Montageanleitung

Vax

Vax Zero Advance VZ-302 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung