Vremi VRM050660N Bedienungsanleitung
Beverage Cooler | 1
This Is
A Manual.
Beverage Cooler
BEFORE FIRST USE:
To prevent any internal damage, it is very important to
keep refrigeration units (like this one) upright throughout their
journey. Please leave it standing upright and outside the box
for 24 HOURS before plugging it in.
Beverage Cooler | 4
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed to reduce
the risk of explosion, fire, electrical shock, and/or injury to persons. If physical injury or damage is
caused by failure to follow these instructions, the warranty does not apply.
• Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of
obstruction.
• Do not store explosive substances, such as aerosol cans with flammable propellant, in this
appliance.
• Do not use extension cords or ungrounded (two-prong) adapters.
• This appliance is intended to be used in households and similar applications, such as staff
kitchen areas in shops, offices and other working environments; hotels, motels and other
residential type environments; bed and breakfast type environments; catering and similar
non-retail applications.
• Do not pull the power cord when pulling the power plug of the beverage cooler. Please
firmly grasp the plug and pull it out from the socket directly.
• The refrigerant of this product is R600a, which is flammable. Make sure not to damage the
cooling system during transportation and installation.
Warnings related to electricity
• Do not damage the power cord under any condition.
• This appliance must be grounded due to the event of an
electrical short circuit.
• This appliance is equipped with a grounded wire and a
grounded plug. Plug into a properly installed grounded 3
prong outlet.
• The beverage cooler uses an AC power supply of 120V/60 Hz.
• For your safety, don’t place electric devices on top of the cooler, like microwaves or
electric kettles, and don’t store your beverage cooler inside pantries.
Warnings related to use
• Make sure the cooler is placed in a well-ventilated, indoor environment on flat, sturdy
ground (rotate left or right to adjust the wheel to level if unstable).
• Be careful not to get fingers or dangling accessories caught in the cooler door.
• This cooler and its packaging are not intended to be played with or used by children. If
a child is using the cooler, it must be with adult supervision to avoid injury.
• Keep the cooler out of moist, damp, or humid environments and situations, so as not to
damage the electrical insulation.
• Do not use a base, cooler door, etc. as pedal or support.
• Do not place heavy objects on top of the cooler to prevent accidental damage or injury.
• Do not use this cooler to store fresh foods, such as meats, vegetables, fruits, etc. This
product can only be used to chill beverages.
Beverage Cooler | 5
Warnings related to placing items
• Do not put flammable, explosive, volatile, or highly corrosive items in the cooler.
• Do not place flammable items near the cooler to avoid a fire hazard.
• This product is for household refrigeration appliances, mainly used for the storage of
beverages. It’s not used for other purposes, such as storage of blood, drugs, and biological
products.
Warnings related to disposal
Suffocation Hazard:
Remove door from your old beverage cooler.
Failure to do so can result in death or brain damage.
Before disposing your beverage cooler:
1. Take off the doors.
2. Leave the shelf racks in place so that children may not easily climb inside.
All refrigeration products contain refrigerants, which under federal law must be removed prior
to product disposal. Check with a qualified disposal company for instructions.
Important Safety Instructions
SAVE THESE INSTRUCTIONS
For Household Use Only
Beverage Cooler | 6
Parts List
PLACEMENT
• Before using the cooler, remove all packaging materials, including bottom
cushions, foam pads, and tape inside the cooler. Tear off the protective film on
the door and the cooler body.
• Make sure the cooler is placed in a well-ventilated, indoor environment on flat,
sturdy ground (turning clockwise to raise the appliance, and counter-clockwise to
lower the appliance).
• Leave a minimum of 1/2” between each side of the appliance and the wall.
The top and back of the appliance should have a minimum 2” clearance. This
allows for proper air circulation.
• Avoid putting the cooler in direct sunlight or too close to a heat source. Keep
a safe distance of at least 12 inches between the cooler and a stove or furnace if it
can’t be avoided. We also advise applying an insulation board in that case.
• Install the appliance in a location where the temperature is between 55°F and
90°F. For best performance, do not install the beverage cooler behind a cabinet
door.
1
4
2
3
1Glass Door
2Shelf Racks (3)
3Electronic Control
4Leveling Leg
Beverage Cooler | 7
Operating Instructions
INSTALLATION
Warning: Excessive Weight Hazard
Use two or more people to move and install beverage cooler. Failure to do so can result in
back or other injury.
• Keep in upright position for 24 hours before initial power up.
• While the cooler is empty, set the Temperature Control to maximum and leave for 1
hour.
• Follow steps below if you want to change the door orientation from left-hinge to right-
hinge:
1. Remove top hinge cover and 3 top hinge screws which are below it. Then remove top
hinge.
2. Remove 1 cabinet plug and 1 door handle plug.
3. Remove the door.
4. Remove right and left leveling legs.
5. Remove the bottom hinge and 3 bottom hinge screws.
6. Install the bottom hinge on the other side of the leveling legs with 3 bottom hinge
screws.
7. Install right and left leveling legs. There are two holes below the beverage cooler to fit
the two leveling legs.
8. Install the door.
9. Install the top hinge on the other side with 3 top hinge screws.
10. Install top cover above the top hinge and install 1 cabinet plugs on the other side.
11. Adjust the leveling legs.
Beverage Cooler | 8
Operating Instructions
INTRODUCTION TO THE BEVERAGE COOLER’S FUNCTIONS
1. The maximum capacity is 90 cans (12 oz/335 ml) when placed vertically as shown in Figure A.
2. In order to achieve the maximum capacity, arrange the 25 cans in top three rows
(five cans across the depth and five cans across the length) as shown in Figure A.
3. Arrange the 15 cans in bottom rack (three cans across the depth and five cans
across the length) as shown in Figure B.
1Top hinge cover
2Top hinge screws
3Top hinge
4Cabinet plug
5Bottom hinge
6Door handle plug
7Bottom hinge screw
8Leveling legs
Beverage Cooler | 9
4. Store beverages in sealed containers only.
5. Operate the beverage cooler by adjusting the temperature control buttons (up and down
arrows) to various settings. The adjusting temperature range is between 32°F and 61°F. Press
once and the temperature will increase 1 °F. Press once and the temperature will
decrease 1 °F. Your new set temperature will flash on the display for five seconds and then
change to the actual temperature until the set temperature is reached.
6. Press and hold the and simultaneously for 3 seconds and the temperature display
will switch between °C & °F.
7. Press power button to turn off the display, press again to activate the display.
8. Standby Mode
To activate standby mode, press and hold the power button for 3 seconds. You will hear a
beep and the display will turn off. To deactivate standby mode, press the button again. You
will hear a beep and the standard display will turn on.
9. Lighting
Press the lighting button to turn the light on or off.
Operating Instructions
Beverage Cooler | 10
Cooler isn’t cool
Cooler is not refrigerating
Vibration noise
Condensation on the glass
door
Compressor runs too long
or cycles on/off frequently
The door is being opened too often. Or the cooler is too
full of bottles or cans. Reduce the frequency of opening
the door. Lower the temperature if needed.
The power is out or the cooler isn’t plugged in.
Unplug and wait for 10 seconds, plug in again.
The appliance is placed on uneven ground, or touching
the wall.
Adjust the leveling legs, or move away from the wall.
This is normal during high humidity. It can also happen
when the door is opened too frequently.
Simply wipe away any drops of water.
This is normal during hot weather. It can also happen if
the door is not closed tightly. Or temperature setting is
at coldest. Make sure that nothing inside the cooler is
causing the door open. Adjust temperature to a warmer
setting.
Possible Causes & Solutions
Problem
Troubleshooting
Inhaltsverzeichnis
Andere Vremi Zubehör Handbücher
