WAC Lighting WS-W2505 Bedienungsanleitung

Installation Instructions

Item number: WS-W2505

WARNING

IMPORTANT: NEVER attempt any work without shutting off the electricity.

- Read all instructions before installing.

- System is intended for installation by a qualified electrician in accordance with the National Electrical Code

and local regulations.

- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew

the fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you

are working on.

- Place the wall switch in the “OFF” position.

CAUTION

- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use

any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of

this fixture.

CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

AVERTISSEMENT

IMPORTANT : Coupez l’électricité avant TOUTE manipulation.

- Lisez toutes les instructions avant d'installer.

- Système est destiné à être installé par un électricien qualifié en conformité avec le code national de

l'électricité et les règlements locaux.

- Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur

principal en position d’arrêt (« OFF »).

- Placez l’interrupteur mural en position d’arrêt (« OFF »).

MISE EN GARDE

- Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions. Ne remplacez pas les

pièces, n'en laissez pas de côté et ne les utilisez pas si elles sont usées ou brisées. Le non-respect de ces

instructions peut annuler l’homologation ETL/CETL du luminaire.

MISE EN GARDE

Ors de la manipulation de l'appareil, ne pas appliquer de pression à la LED, tenir l'appareil par la seule base.

ADVERTENCIA

IMPORTANTE: NUNCA intente hacer trabajos sin desconectar el suministro eléctrico.

- Lea y comprenda todas las instrucciones e ilustraciones por completo antes de proceder con el ensamblaje

e instalación de esta lámpara.

- Sistema está disenado para ser instalado por un electricista calificado, de acuerdo con el código eléctrico

nacional y las normas locales.

- Diríjase a la caja de fusibles o a la caja del interruptor de circuito principal en su hogar. Coloque el

interruptor de alimentación principal en la posición “OFF” (APAGADO).

- Coloque el interruptor de la pared en la posición “OFF” (APAGADO).

PRECAUCIÓN

- Todas las piezas deben usarse como lo indican estas instrucciones. No reemplace las piezas, noomita

piezas durante la instalación ni utilice piezas gastadas o rotas. El incumplimiento de esta indicación podría

invalidar la calificación ETL/CETL esta lámpara.

PRECAUCIÓN Al manipular el aparato, no aplique presión a los LED, mantenga el aparato en la base sólo.

Hardware

Fig.1

PREPARATION

1. Shut off the power at the circuit breaker and remove existing

fixture, including the crossbar.

2. Carefully unpack your new fixture and lay out all the parts on

a clear area. Be careful not to lose any small parts

necessary for installation.

MOUNTING THE FIXTURE (Fig. 1)

3. Secure mounting backplate (DD) to the junction box (FF)

using junction box screws (BB). The side of the mounting

backplate marked “GND” (EE) must face out.

CONNECTING THE WIRES (Fig. 2)

4. Connect the electrical wires as shown in Fig. 2, making sure

that all wire connectors (AA) are secured. If your outlet box

has a green or bare copper ground wire, connect the fixture’s

ground wire to it. Otherwise, connect the fixture’s ground

wire directly to the backplate (DD) using the green screw (EE)

provided. After wires are connected, tuck them carefully

inside the junction box.

5. Place the fixture over the mounting backplate (DD) and

secure with screws (CC) and gasket (GG).

Fig. 2

COMPLETING THE INSTALLATION (Fig. 3)

6. To prevent moisture from entering the outlet box

and causing a short, use clear caulking (i.e.

indoor/outdoor silicone sealant) to outline the

outside of fixture backplate where it meets the wall

leaving a space at bottom to allow moisture a

means to escape (Fig. 3).

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green or

Bare

Copper

(Ground)

Andere WAC Lighting Außenleuchte Handbücher

WAC Lighting

WAC Lighting MODERN FORMS 716 Series Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED 139 Series Bedienungsanleitung

WAC Lighting

WAC Lighting 5222 Bedienungsanleitung

WAC Lighting

WAC Lighting 5031-CCBBR Bedienungsanleitung

WAC Lighting

WAC Lighting Modern Forms FL-1850 Bedienungsanleitung

WAC Lighting

WAC Lighting Responsible Lighting Axis Bedienungsanleitung

WAC Lighting

WAC Lighting 4011 Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED 911 Series Bedienungsanleitung

WAC Lighting

WAC Lighting Grand Accent 5212 Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED WS-W37612 Bedienungsanleitung

WAC Lighting

WAC Lighting SCOOP series Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED 689 Series Bedienungsanleitung

WAC Lighting

WAC Lighting Accent Color Changing Bedienungsanleitung

WAC Lighting

WAC Lighting DS-WS05 Bedienungsanleitung

WAC Lighting

WAC Lighting WS-W20506 Bedienungsanleitung

WAC Lighting

WAC Lighting InvisiLED PRO Outdoor 24V Bedienungsanleitung

WAC Lighting

WAC Lighting MODERN FORMS TL-1810 Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED 649 Series Bedienungsanleitung

WAC Lighting

WAC Lighting dweled 486 Series Bedienungsanleitung

WAC Lighting

WAC Lighting InvisiLED Classic Outdoor 24V Bedienungsanleitung

WAC Lighting

WAC Lighting Modern Forms 488 Series Bedienungsanleitung

WAC Lighting

WAC Lighting Endurance WP-LED415 Bedienungsanleitung

WAC Lighting

WAC Lighting dweLED 578 Series Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

NEBO

NEBO NEB-LSP-0020 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung