Whalen 19WTLD-SPCA Bedienungsanleitung

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.

PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Date 2019-10-25 Rev. 0001-A

Timbercrest Desk

Model # 19WTLD-SPCA

ADULT ASSEMBLY REQUIRED DUE TO THE PRESENCE OF SMALL PARTS, SHARP

POINTS, SHARP EDGES AS RECEIVED

If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the

store where it was purchased. Please call our toll-free customer service number and have your

instructions and parts list ready to provide the model name, part name or factory number:

1-866-942-5362

Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday

Or visit our web site 24 hours a day, 7 days a week for product assistance at

www.whalenfurniture.com

Or e-mail your request to parts@whalenfurniture.com

LOT NUMBER:

DATE PURCHASED: / /

MANUFACTURER: Whalen Furniture Manufacturing

CATALOG: Timbercrest Desk

MODEL #: 19WTLD-SPCA

MADE IN CHINA

SPECIAL NOTE

Please read the instruction sheets completely before assembly. Examine all packaging

material before discarding carton. Remove any remaining staples from the carton before

discarding. Remove all parts from carton and separate into groups as indicated on part

list. Please ensure all parts are included prior to assembly. Use of power tools to

complete assembly is not recommended.

M A X I M U M R E C O M M E N D E D W E I G H T L O A D S

THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM

WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM

WEIGHTS INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

MAXIMUM LOAD 200 lb. (90.8 kg)

MAXIMUM LOAD 15 lb. (6.8 kg)

IMPORTANT

Before you begin: Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-

abrasive surface. You will need the parts identified on page 4 and 5 of this instruction manual.

NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH DOWELS. EXCESS GLUE CAN BE WIPED

OFF WITH DAMP CLOTH.

Insert the Dowel at least half way by tapping lightly with a rubber mallet, IF NECESSARY.

CAM LOCK SYSTEM OPERATION

HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS

1. Screw the Cam Bolt into the threaded inserts on the panel. Connect both panels together; making sure Cam

Bolt goes into the pre-drilled hole on the end of panel for Cam Lock.

2. Insert the Cam Lock into the pre-drilled large hole on the panel. Make sure the arrow on the face of Cam

Lock faces out and points towards Cam Bolt.

3. Take a Phillips screwdriver and rotate the Cam Lock clockwise to lock the Cam Bolt in place.

4. Plug the Cam Lock Cover into the cross slot of the Cam Lock to conceal the Cam.

You are now ready to assemble the KD unit.

1 2 43

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

A- Desk Top Panel (Qty. 1) B- Desk Bottom Panel (Qty. 1) C- Desk Back Panel (Qty. 1)

D- Desk Right Front Panel (Qty. 1) E- Desk Side Panel (Qty. 3) F- Left Partition Panel (Qty. 2)

G- Desk Right Partition Panel (Qty. 1) H1- Drawer Front (Qty. 2) H2- Drawer Back Panel (Qty. 2)

H6- Drawer Bottom Panel (Qty. 2) I- Desk Left Front Panel (Qty. 1) J- Return Top Panel (Qty. 1)

K- Return Bottom Panel (Qty. 1) L- Return Back Panel (Qty. 1) M- Return Left Side (Qty. 1)

N- Return Right Partition Panel (Qty. 1) O- Return Left Front (Qty. 1) P- Return Right Front (Qty. 1)

H3- Drawer Left Side (Qty. 2) H4- Drawer Right Side Qty. 2) H5- Drawer Bottom Support (Qty. 2)

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

Q- Desk Long Stretcher (Qty. 1) R- Desk Short Stretcher (Qty. 1) S- Desk Back Leg (Qty. 1)

T- Desk Front Leg (Qty. 1) U- Desk Side Frame (Qty. 1) V- Return Stretcher (Qty. 1)

W- Return Side Frame (Qty. 1) X- Cable Wheel (Qty. 3)

(1) Large Cam Lock (2) Large Cam Bolt (3) M8 x 30 mm Wood Dowel

(Qty. 46+2 extra) (Qty. 46+2 extra) (Qty. 74+2 extra)

(4) M8 x 20 mm Wood Dowel (5) 1/4” x 30 mm Bolt (6) Lock Washer

(Qty. 2+1 extra) (Qty. 6+1 extra) (Qty. 14+1 extra)

(7) Flat Washer (8) 1/4” x 18 mm Bolt (9) 5/32” x 12 mm Bolt (10) Small Cam Lock

(Qty. 14+1 extra) (Qty. 14+1 extra) (Qty. 6+1 extra) (Qty. 12+1 extra)

(11) Small Cam Bolt (12) M4 x 35 mm Screw (13) M4 x 14 mm Flat Head Screw (14) Handle

(Qty. 12+1 extra) (Qty. 48+2 extra) (Qty. 4+1 extra) (Qty. 2)

(15) Grommet (Qty. 2) (16) Metal Bracket (Qty. 1) Hex Wrench (Qty. 1) Glue (Qty. 2)

Tools required: Hex wrench (provided), Phillips screwdriver and Hammer (not provided).

H1 H1

Drawer Assembling

1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a

carpeted floor or the empty carton to avoid any scratch.

2. Securely screw the Small Cam Bolts (11) into the designated small holes on the Drawer Front (H1)

using a Phillips screwdriver.

3. Fasten the Drawer Left and Right Sides (H3 and H4) to the Drawer Front (H1) with 4 Small Cam Locks

(10).

4. Fasten the Drawer Bottom Support (H5) to the Drawer Front (H1) with 2 Small Cam Locks (10).

5. Slide the Drawer Bottom Panel (H6) all the way into the grooves.

Drawer Assembling

6. Fasten the Drawer Back Panel (H2) to the Drawer Side Panels (H3 and H4) and Bottom Support (H5)

with six 35 mm Screws (12). Make sure that the Drawer Bottom Panel (H6) fits securely into the groove

of the Drawer Back Panel (H2).

7. Turn the assembled drawer upright. Attach the Handle (14) to the pilot holes on the Drawer Front (H1)

with two 14 mm Flat Head Screws (13).

8. Repeat the same procedure to assemble the other drawer.

H4 H2

Desk Assembling

9. Securely screw the Large Cam Bolts (2) into the designated small holes on the Desk Top Panel (A),

Back Panel (C), Side Panels (E) and Front Panels (D and I) using a Phillips screwdriver.

10. Glue the M8 x 30 mm Wood Dowels (3) into the inner holes of Back Panel (C) and Partition Panels (F

and G).

NOTE: It is very important to use a small amount of glue on both ends of dowels.

Desk Assembling

11. Align and attach the Partition Panels (F and G) to the Back Panel (C) by engaging 3 Large Cam Locks

(1) (Refer to page 3 on Cam Lock system operation supplement).

12. Glue M8 x 30 mm Wood Dowels (3) into the inner holes of Side Panels (E) and Front Panels (D and I).

Desk Assembling

13. Glue the M8 x 20 mm Wood Dowels (4) into the inner holes of Desk Right Front Panel (D).

14. Attach the Desk Right Front Panel (D) to the Right Partition Panel (G) with one Large Cam Lock (1).

15. Attach the Desk Left Front Panel (I) to the Left Partition Panel (F) with one Large Cam Lock (1).

Inhaltsverzeichnis

Sprachen:

Andere Whalen Inneneinrichtung Handbücher

Whalen

Whalen WMCPRO-9 Bedienungsanleitung

Whalen

Whalen BBAT27TC Bedienungsanleitung

Whalen

Whalen TEN2PST Bedienungsanleitung

Whalen

Whalen XLCD-15 Bedienungsanleitung

Whalen

Whalen Peruzzi SPLS-PE48D Bedienungsanleitung

Whalen

Whalen Bayside Furnishings CSC7PD-2B Bedienungsanleitung

Whalen

Whalen Triton Wood Veneer Bookcase Bedienungsanleitung

Whalen

Whalen Bayside FURNISHINGS CSC7PD-12-T Bedienungsanleitung

Whalen

Whalen WF24AVG Bedienungsanleitung

Whalen

Whalen Victory VIC7PD Bedienungsanleitung

Whalen

Whalen WF24FVB Bedienungsanleitung

Whalen

Whalen Axon Task WC-13AX-GO Bedienungsanleitung

Whalen

Whalen WSF48MS26GAO Bedienungsanleitung

Whalen

Whalen MainStays Parsons Bedienungsanleitung

Whalen

Whalen PAL70ECON Bedienungsanleitung

Whalen

Whalen WSWB722436W-US Bedienungsanleitung

Whalen

Whalen 19WTFL-SPCA Bedienungsanleitung

Whalen

Whalen Bayside Furnishings CSC72LBK-6 Bedienungsanleitung

Whalen

Whalen Westport SMUBCH Betriebsanleitung

Whalen

Whalen Montcross MON7PD-E Bedienungsanleitung

Whalen

Whalen CAMELOT Bedienungsanleitung

Whalen

Whalen Bayside Furnishings CSCDT-3E Bedienungsanleitung

Whalen

Whalen Kendal Chair Gray Bedienungsanleitung

Whalen

Whalen Bayside FURNISHINGS CUKGLBST-3G Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung