Whalen BJKC Bedienungsanleitung

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.

PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Date 2020-10-09 Rev. 0001-A

Kitchen Cart

Model # BJKC

ADULT ASSEMBLY REQUIRED

If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the

store where it was purchased. Please call our toll-free customer service number and have your

instructions and parts list ready to provide the model name, part name or factory number:

1-866-942-5362

Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday

Or visit our website 24 hours a day, 7 days a week for product assistance at

www.whalenfurniture.com

Or e-mail your request to parts@whalenfurniture.com

LOT NUMBER:

DATE PURCHASE

MANUFACTURER: Whalen Furniture Manufacturing

CATALOG: Kitchen Cart

MODEL # BJKC

M A X I M U M R E C O M M E N D E D W E

G H T L O A D S

MAXIMUM LOAD 45.4 kg / 100 lb.

MAXIMUM LOAD 22.7 kg / 50 lb.

MAXIMUM LOAD 9.1 kg / 20 lb.

Children have died from furniture tipover.

To reduce the risk of furniture tipover:

 ALWAYS install tipover restraint provided.

 NEVER put a TV on this product.

 NEVER allow children to stand, climb or hang on drawers, doors, or shelves.

 NEVER open more than one drawer at a time.

 Place heaviest items in the lowest drawers.

Use of tip-over restraints may only reduce, but not eliminate, the risk of tip-over.

WARNING

THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM

WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM WEIGHTS

INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

IMPORTANT

Before you begin: Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-

abrasive surface. You will need the parts identified on page 4 of this instruction manuals.

NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH THE DOWELS. EXCESS GLUE CAN BE

WIPED OFF WITH A DAMP CLOTH.

Insert Dowel at least half way by tapping lightly with a rubber mallet (not included), IF NECESSARY.

CAM LOCK SYSTEM OPERATION

HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS

1. Screw the Cam Bolt into the pre-drilled small holes on the panel. Connect both panels together; making sure

the Cam Bolt goes into the pre-drilled hole at the end of the panel with the Cam Lock.

2. Insert the Cam Lock into the pre-drilled large hole in the panel. Make sure the arrow on the Cam Lock is

pointed towards the Cam Bolt.

3. Once the Cam Bolt is connected inside the Cam Lock, take a Phillips screwdriver (not included) and

tighten the Cam Lock clockwise.

4. Plug the Cam Lock Cover into the cross slot of the Cam Locks to conceal the cam.

You are now ready to assemble the KD unit.

GLUE

FINAL

1 2 43

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

A- Top Section (Qty. 1) B-Bottom Shelf (Qty. 1)

C- Partition Panel (Qty. 1) D- Side Frame (Qty. 2) E- Adjustable Shelf (Qty. 2)

F- Caster G- Side Handle (1) Cam Lock (2) Cam Bolt

(Qty. 4) (Qty. 2) (Qty. 4+1 extra) (Qty. 4+1 extra)

(3) M8 x 30 mm Wood Dowel (4) 1/4” x 25 mm Bolt (5) 1/4” x 32 mm Bolt (6) 1/4” x 38 mm Bolt

(Qty. 8+1 extra) (Qty. 8+1 extra) (Qty. 4+1 extra) (Qty. 12+1 extra)

(7) Lock Washer (8) Flat Washer (9) Shelf Pin (10) Cam Lock Cover

(Qty. 24+1 extra) (Qty. 24+1 extra) (Qty. 8+1 extra) (Qty. 4+1 extra)

Hex Wench Glue Touch-up Pen Tipping Restraint Hardware Kit (Qty. 2)

(Qty. 1) (Qty. 1) (Qty. 1) (Included in plastic bag)

Tools required (not included): Phillips screwdriver, stud finder, power drill, pencil, tape measure, and

1/8” drill bit.

Assembly Instructions

NOTE: DO NOT fully tighten all cam locks and bolts until you finish assembling all parts. Once assembled,

go back and fully tighten all cam locks and bolts.

1. Unpack the unit and confirm that you have all the hardware and required parts.

2. Place the Top Section (A) upside down on a level and protective surface as shown.

3. Remove the drawers by pulling the drawer all the way out, then simultaneously pushes the plastic

release lever of the ball bearing slide up on one side and down on the other side, and then pull the

drawer completely out.

4. Securely screw the Cam Bolts (2) into the designated small holes on the Top Section (A) and Bottom

Shelf (B) with a Phillips screwdriver.

NOTE: Screw-in cam bolts must be screwed down flush.

Left drawer

Right drawer

Assembly Instructions

5. Glue the Wood Dowels (3) into the inner holes on the Bottom Shelf (B) and Partition Panel (C) as shown.

6. Attach the Side Handles (G) to the Side Frames (D) using four 32 mm Bolts (5) with the Lock Washers (7)

and Flat Washers (8).

G G

578

Assembly Instructions

7. Attach one Side Frame (D) to the Top Section (A) with four 38 mm Bolts (6) and eight Washers (7 and 8).

8. Attach the Partition Panel (C) to the Top Section (A) by engaging two Cam Locks (1). Make sure that

the cam locks point towards the right side of the unit. (Refer to page 3 on Cam Lock system operation

supplement).

Assembly Instructions

9. Align and attach the Bottom Shelf (B) to the Partition Panel (C) by engaging two Cam locks (1).

10. Continue to fasten the Bottom Shelf (B) to the Side Frame (D) using two 38 mm Bolts (6) with the

Washers (7 and 8).

11. Attach the other Side Frame (D) to the Top Section (A) and Bottom Shelf (B) with six 38 mm Bolts (6)

and Washers (7 and 8).

678

Assembly Instructions

12. Fasten the Casters (F) to the joint between the Bottom Shelf (B) and Side Frames (D) with two 25 mm

Bolts (4) and four Washers (7 and 8) per caster.

13. Ask for assistance to lift the previous assembly upright.

14. Insert the Shelf Pins (9) into the desired holes in the sides of each compartment. Make sure you place

the four shelf pins in the same level so the shelf is not tilted. Tilt and rest the Adjustable Shelves (E)

onto the Shelf Pins (9). Be sure to fit the notches underneath the shelves onto the shelf pins properly.

15. Plug four Cam Lock Covers (10) onto the visible Cams Locks to conceal the cams.

The nuts face inward

Assembly Instructions

16. Now, go back and securely tighten all the cam locks and screws. Make sure that all the parts are tight

and there are no gaps between the parts. This will help keep the unit square.

17. Place the drawer back by pushing the ball bearing cart all the way to the end of the slides (in both sides)

and align the slide runners on the drawer with the slide tracks on the unit and push it carefully inside

until it stops.If the drawer does not go in smoothly, please take it out and repeat the step.

CAUTION: Lock the casters at all times when not rolling the unit and particularly when opening the drawers.

FRONT

Ball bearing cart

Left drawer

Right drawer

Take Safety Precautions When Using Your Storage!

Inhaltsverzeichnis

Andere Whalen Inneneinrichtung Handbücher

Whalen

Whalen Evans Creek CTCDC-1 Bedienungsanleitung

Whalen

Whalen Bayside CUS4PCHD-1PC Bedienungsanleitung

Whalen

Whalen BBLAVC54T Bedienungsanleitung

Whalen

Whalen 3-in-1 TV Stand Bedienungsanleitung

Whalen

Whalen Z BEAM WSZB1848-5BW-2 Bedienungsanleitung

Whalen

Whalen Bayside FURNISHINGS CUS7PD-4-BE Bedienungsanleitung

Whalen

Whalen Hendricks Series Bedienungsanleitung

Whalen

Whalen Devon File EC-DEDF Bedienungsanleitung

Whalen

Whalen BBHC60DBC Bedienungsanleitung

Whalen

Whalen NOLAHBST Bedienungsanleitung

Whalen

Whalen TV Console BBAVCL54-SMB Bedienungsanleitung

Whalen

Whalen Bayside CSCGLBST-4-UK-BL Bedienungsanleitung

Whalen

Whalen WF48GVB Bedienungsanleitung

Whalen

Whalen Sagemoor SAGE7PD-E Bedienungsanleitung

Whalen

Whalen Bayside CUS60WD-5 Bedienungsanleitung

Whalen

Whalen SMXL-6 Bedienungsanleitung

Whalen

Whalen WSMTB63-W Bedienungsanleitung

Whalen

Whalen Breckenridge Executive Chair Bedienungsanleitung

Whalen

Whalen WF60CVG Bedienungsanleitung

Whalen

Whalen SFKCWWR Bedienungsanleitung

Whalen

Whalen Braxton 7-pc Dining Set Bedienungsanleitung

Whalen

Whalen Huntingdon EC-HUDF Bedienungsanleitung

Whalen

Whalen WF60AVG Bedienungsanleitung

Whalen

Whalen Bayside CSC72LC-1 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung