Whispbar K390 Bedienungsanleitung
K390
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 1 x 1 x 1
x 1 x 4 x 4
Revision No: 7G 1
Fitting Kit K390
MAX kgs (lbs)
W/P WHD
Audi
A4, 4dr Sedan 07-Nov 15 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
A4, 4dr Sedan 08-Feb 16 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
A4, 4dr Sedan 08-Nov 15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
A4, 4dr Sedan 08-Nov 15 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
A4, 4dr Sedan 08-Nov 15 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
A4, 4dr Sedan 09-Feb 16 US 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ CN 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
S4, 4dr Sedan 08-+ US 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K390
X
A B C 1 2 3
A4, 4dr Sedan 07-Nov 15 (ZA) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
A4, 4dr Sedan 08-Feb 16 (NZ) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
A4, 4dr Sedan 08-Nov 15 (AU) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
A4, 4dr Sedan 08-Nov 15 (EU) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
A4, 4dr Sedan 08-Nov 15 (CN) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
A4, 4dr Sedan 09-Feb 16 (US) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (AU) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (CN) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (EU) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (NZ) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (ZA) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
S4, 4dr Sedan 08-+ (US) 410mm - 842mm 830mm -
16 1/8ths" - 33 1/8ths" 32 11/16ths" -
3
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
-330mm
-13"
Fitting Kit EN
K390
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K390
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K390
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●A = Clear
B = Grey
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
6
Fitting Kit EN
K390
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-251
B = 11-04-250
C = 11-04-246
D = 11-04-247
7
Fitting Kit EN
K390
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Please check the front of this manual for
information relating specifically to your
vehicle.
8
Fitting Kit EN
K390
●Locate vehicle's fixed points.
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Tighten locking screw on both legs evenly.
9
Fitting Kit EN
K390
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Inhaltsverzeichnis
Andere Whispbar Autozubehör Handbücher
Whispbar
Whispbar K1021W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K785W Bedienungsanleitung
Whispbar
Whispbar K383W Bedienungsanleitung
Whispbar
Whispbar K318W Bedienungsanleitung
Whispbar
Whispbar K850W Bedienungsanleitung
Whispbar
Whispbar K172W Bedienungsanleitung
Whispbar
Whispbar K427W Bedienungsanleitung
Whispbar
Whispbar K390W Bedienungsanleitung
Whispbar
Whispbar K062W Bedienungsanleitung
Whispbar
Whispbar Q Series Bedienungsanleitung
Whispbar
Whispbar K308W Bedienungsanleitung
Whispbar
Whispbar K598W Bedienungsanleitung
Whispbar
Whispbar K189W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K570W Bedienungsanleitung
Whispbar
Whispbar K510W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K595 Bedienungs- und Installationshandbuch
Whispbar
Whispbar K053W Bedienungsanleitung
Whispbar
Whispbar K631W Bedienungsanleitung
Whispbar
Whispbar K449W Bedienungsanleitung
Whispbar
Whispbar K527W Bedienungsanleitung
