Whispbar K612W Bedienungsanleitung
K612W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 8 x 4 x 4 x 4
x 4 x 4 x 4 x 1
x 4 x 4
Revision No: 6F 1
Fitting Kit K612W
MAX kgs (lbs)
W/P WHD
Opel
Combo C, 5dr Van 01-11 CN 75 kgs (165 lbs) 100 kgs (220 lbs)
Combo, 5dr Van 01-11 ZA 75 kgs (165 lbs) 100 kgs (220 lbs)
Vauxhall
Combo C, 5dr Van 01-11 CN 75 kgs (165 lbs) 100 kgs (220 lbs)
Holden
Combo XC, 5dr Van 01-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)
Combo XC, 5dr Van 01-+ NZ 75 kgs (165 lbs) 100 kgs (220 lbs)
Renault
Master MWB, 4dr Van 10-+ EU 75 kgs (165 lbs) 100 kgs (220 lbs)
Master MWB, 4dr Van 10-+ EU 75 kgs (165 lbs) 100 kgs (220 lbs)
Master MWB, 4dr Van 10-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)
Master MWB, 4dr Van 10-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)
Master MWB, 4dr Van 10-+ NZ 75 kgs (165 lbs) 100 kgs (220 lbs)
Master MWB, 4dr Van 10-+ NZ 75 kgs (165 lbs) 100 kgs (220 lbs)
2
Fitting Kit K612W
X
A B C 1 2 3
Combo C, 5dr Van 01-11 (CN) 220mm 1040mm - 910mm 915mm -
8 11/16ths" 40 15/16ths" - 35 13/16ths" 36" -
Combo C, 5dr Van 01-11 (CN) 220mm 1040mm - 910mm 915mm -
8 11/16ths" 40 15/16ths" - 35 13/16ths" 36" -
Combo XC, 5dr Van 01-+ (AU) 220mm 1040mm - 910mm 915mm -
8 11/16ths" 40 15/16ths" - 35 13/16ths" 36" -
Combo XC, 5dr Van 01-+ (NZ) 220mm 1040mm - 910mm 915mm -
8 11/16ths" 40 15/16ths" - 35 13/16ths" 36" -
Combo, 5dr Van 01-11 (ZA) 220mm 1040mm - 910mm 915mm -
8 11/16ths" 40 15/16ths" - 35 13/16ths" 36" -
Master MWB, 4dr Van 10-+ (EU) 160mm 1050mm - 1150mm 1150mm -
6 5/16ths" 41 5/16ths" - 45 1/4ths" 45 1/4ths" -
Master MWB, 4dr Van 10-+ (EU) 160mm 1050mm 1720mm 1150mm 1150mm 1150mm
6 5/16ths" 41 5/16ths" 67 11/16ths" 45 1/4ths" 45 1/4ths" 45 1/4ths"
Master MWB, 4dr Van 10-+ (AU) 160mm 1050mm - 1150mm 1150mm -
6 5/16ths" 41 5/16ths" - 45 1/4ths" 45 1/4ths" -
Master MWB, 4dr Van 10-+ (AU) 160mm 1050mm 1720mm 1150mm 1150mm 1150mm
6 5/16ths" 41 5/16ths" 67 11/16ths" 45 1/4ths" 45 1/4ths" 45 1/4ths"
Master MWB, 4dr Van 10-+ (NZ) 160mm 1050mm - 1150mm 1150mm -
6 5/16ths" 41 5/16ths" - 45 1/4ths" 45 1/4ths" -
Master MWB, 4dr Van 10-+ (NZ) 160mm 1050mm 1720mm 1150mm 1150mm 1150mm
6 5/16ths" 41 5/16ths" 67 11/16ths" 45 1/4ths" 45 1/4ths" 45 1/4ths"
3
Fitting Kit EN
K612W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K612W
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K612W
●Tighten adjusting screw to 3 Nm (2.2 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
6
Fitting Kit EN
K612W
●Fit rubber pad (supplied with crossbar) to
foot.
●Make sure the pad fits into the holes
underneath the foot.
Fitment
●Locate vehicle's fixed points.
●Fixed point may vary to those pictured.
●Open or remove fixed-point covers.
●Sort hex bolts into lengths. Choose correct
length for your vehicle.
●A = Master Van
B = Combo Van
C = Not applicable unless advised
7
Fitting Kit EN
K612W
●Place large flat washer onto bolt.
●Install bolt with washer up through the
fixed-point from inside vehicle.
NOTE: May require holding in place by a
second person or sticky tape.
●Apply silicon sealant.
●Place rubber seal over bolt thread as
shown.
8
Fitting Kit EN
K612W
●Place second flat washer over rubber seal.
●Screw flange nut onto hex bolt.
●Tighten flange nut using 10mm (3/8")
spanner provided.
●Do not over tighten.
9
Fitting Kit EN
K612W
●Check seal is secure.
NOTE: If seal has slid out from under
washer, loosen flange nut slightly.
●Place crossbar foot over grubscrews.
●Tighten the plastic knob. The side with the
nut showing should be facing up.
10
Inhaltsverzeichnis
Andere Whispbar Autozubehör Handbücher
Whispbar
Whispbar K555W Bedienungsanleitung
Whispbar
Whispbar K745W Bedienungsanleitung
Whispbar
Whispbar K506W Bedienungsanleitung
Whispbar
Whispbar K043W Bedienungsanleitung
Whispbar
Whispbar K423W Bedienungsanleitung
Whispbar
Whispbar S55W Bedienungsanleitung
Whispbar
Whispbar K621W Bedienungsanleitung
Whispbar
Whispbar K450W Bedienungsanleitung
Whispbar
Whispbar K571W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K075W Bedienungsanleitung
Whispbar
Whispbar K927 Bedienungsanleitung
Whispbar
Whispbar K389W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K700W Bedienungsanleitung
Whispbar
Whispbar K725W Bedienungsanleitung
Whispbar
Whispbar K156W Bedienungs- und Installationshandbuch
Whispbar
Whispbar K361W Bedienungsanleitung
Whispbar
Whispbar K073W Bedienungsanleitung
Whispbar
Whispbar K623W Bedienungsanleitung
Whispbar
Whispbar K765W Bedienungsanleitung
Whispbar
Whispbar K307W Bedienungsanleitung
