Williams Sound SoundPlus WIR RX22-4 Montageanleitung

SoundPlus®Four-Channel Infrared Receiver

Model WIR RX22-4, 2.3-3.8 MHz

Instructions For Use & Care

SAFETY INFORMATION

Hearing Safety:

This product is designed to amplify

sounds to a high volume level which

could potentially cause hearing dam-

age if used improperly. To protect your

hearing and the hearing of others:

1. Make sure the volume is turned

down before putting on the ear-

phone or headphone before adjust-

ing the volume to a comfortable

level.

2. Set the volume level at the mini-

mum setting that you need to hear.

3. Do not allow children or other

unauthorized persons to have access

to this product.

BATTERY SAFETY & DISPOSAL

Do not attempt to recharge dispos-

able batteries, which may explode,

release dangerous chemicals, cause

burns, or other serious harm to the

user or product.

PACEMAKER SAFETY

1. Before using this product with a pace-

maker or other medical device, con-

sult your physician or the manufactur-

er of your pacemaker or other medical

device.

2. If you have a pacemaker or other med-

ical device, make sure that you are using

this product in accordance with safety

guidelines established by your physician

or the pacemaker manufacturer.

CAUTION!

OPERATING INSTRUCTIONS

1. Install AA batteries: Open the battery

compartment by lifting the tab on the

back of the receiver with your finger.

To remove depleted batteries, pull up

on the fabric strip.

IMPORTANT: If Alkaline (non-

rechargeable) batteries are being

installed, slide the battery selection

switch in the battery compartment to the

“Alkaline” position. See Fig. A above. If

installing NiMH (or rechargeable) bat-

teries, slide the battery selection switch

to the “NiMH” position.

Press the batteries into place over the

fabric strip. Be sure to observe proper

polarity (+/-). Damage due to improp-

er battery installation may void the

warranty on the product. close the

battery door. LED will flash when the

batteries are getting low; continue to

use until the sound becomes weak or

distorted, or the unit quits operating,

then replace or recharge batteries.

RECYCLING INSTRUCTIONS

Help Williams Sound protect the envi-

ronment! Please take the time to dis-

pose of your equipment properly.

Product Recycling:

Please do NOT dispose of your Williams

Sound equipment in the household trash.

Please take the equipment to a electron-

ics recycling center; OR, return the prod-

uct to the factory for proper disposal.

Battery Recycling:

Please do NOT dispose of used batteries

in the household trash. Please take the

batteries to a retail or community collec-

tion point for recycling.

9/15/06

–

FIG. A

On/Off

Volume Switch

Earphone

Jack

"On"

Indicator LED

Channel

Selector Knob

OFF

6. To turn the receiver off, rotate the

volume control knob to the left until

it clicks off. The ON indicator should

not be lit. To prolong the battery life

of the unit, turn the receiver off when

it is not in use.

Battery Information

The WIR RX22-4 Receiver can use two

(2) disposable AA batteries (BAT 001) or

two (2) AA rechargeable batteries (BAT

026). Note: The BAT 026 provides longer

life than other rechargeable batteries. Do

not substitute other rechargeable batteries

and chargers.

Low Battery Indicator

The “On” indicator on top of the unit will

flash to indicate low battery.

Recharging

If the WIR RX22-4 is equipped with

rechargeable batteries, up to 12 units can

be charged at one time in the optional

CHG 3512 multi-charger. Refer to MAN

116 charger instruction sheet for complete

charging instructions. For ordering infor-

mation, please contact Williams Sound at

800-843-3544.

Earpad Cleaning

Do not immerse the earphone in water or

other cleaning agent. Foam pads may be

removed and washed with a mild laundry

soap solution, rinse thoroughly, and air-

dried. You may also opt to purchase new

foam pads. Call the factory for more

information: 800-843-3544

FIG B: WIR RX22-4 Control Panel

2. Plug the earphone, headphone or

neckloop into the headphone jack on

the receiver’s control panel.

3. Turn the receiver on by rotating the

volume control knob. The ON indica-

tor should illuminate RED.

4. Select the channel you’d like by turn-

ing the channel selector knob on the

control panel. Choose between 4

standard frequencies:

2.3 MHz (Ch.1), 2.8 MHz (Ch. 2),

3.3 MHz (Ch.3), or 3.8 MHz (Ch. 4).

Important: Make sure the receiver

frequency matches the transmitter

frequency.

IMPORTANT: Make sure the

“SoundPlus IR” artwork on the front

of the unit is not covered up while in

use. Do not place the receiver in a

pocket or purse or it will not work

properly.

5. Adjust the volume to a comfortable

listening level

LANYARD CLIP INSTALLATION

For hands free operation of the WIR RX22-4

receiver, use the provided lanyard clip to

hang the unit around your neck.

To Install: Position the lanyard clip on the

rear of the WIR RX22-4 receiver as shown

in FIG C. Turn the lanyard clip 180° left or

right as shown in FIG D. The lanyard clip

is now installed and ready for use.

To Remove: Turn the lanyard clip 180° so

the edge points toward the top of the unit as

shown in FIG C. Gently pull the lanyard

clip away from the unit to remove.

LIMITED WARRANTY

Williams Sound products are engi-

neered, designed and manufactured

under carefully controlled conditions

to provide you with many years of

reliable service. Williams Sound war-

rants the WIR RX22-4 receiver

against defects in materials and work-

manship for FIVE (5) years. During

the first five years from the purchase

date, we will promptly repair or

replace the WIR RX22-4 receiver.

Earphones, headphones, batteries,

cables, carry cases, and all other

accessory products carry a 90-day

warranty.

WILLIAMS SOUND HAS NO CON-

TROL OVER THE CONDITIONS

UNDER WHICH THIS PRODUCT

IS USED. WILLIAMS SOUND,

THEREFORE, DISCLAIMS ALL

WARRANTIES NOT SET FORTH

ABOVE, BOTH EXPRESS AND

IMPLIED, WITH RESPECT TO THE

WIR RX22-4 RECEIVER, INCLUD-

ING BUT NOT LIMITED TO, ANY

IMPLIED WARRANTY OF MER-

CHANTABILITY OR FITNESS FOR

A PARTICULAR PURPOSE.

WILLIAMS SOUND SHALL NOT

BE LIABLE TO ANY PERSON OR

ENTITY FOR ANY MEDICAL

EXPENSES OR ANY DIRECT,

INCIDENTAL OR CONSEQUEN-

TIAL DAMAGES CAUSED BY

ANY USE, DEFECT, FAILURE OR

MALFUNCTION OF THE PROD-

UCT, WHETHER A CLAIM FOR

– or –

FIG. C

FIG. D

SUCH DAMAGES IS BASED UPON

WARRANTY, CONTRACT, TORT OR

OTHERWISE. THE SOLE REMEDY FOR

ANY DEFECT, FAILURE OR MALFUNC-

TION OF THE PRODUCT IS REPLACE-

MENT OF THE PRODUCT. NO PERSON

HAS ANY AUTHORITY TO BIND

WILLIAMS SOUND TO ANY REPRE-

SENTATION OR WARRANTY WITH

RESPECT TO THE WIR RX22-4 RECEIV-

ER. UNAUTHORIZED REPAIRS OR

MODIFICATIONS WILL VOID THE

WARRANTY.

The exclusions and limitations set out above

are not intended to, and should not be con-

strued so as to contravene mandatory provi-

sions of applicable law. If any part or term

of this Disclaimer of Warranty is held to be

illegal, unenforceable or in conflict with

applicable law by a court of competent

jurisdiction, the validity of the remaining

portions of this Disclaimer of Warranty

shall not be affected, and all rights and obli-

gations shall be construed and enforced as if

this Limited Warranty did not contain the

particular part or term held to be invalid.

If you experience difficulty with your sys-

tem, call Toll-Free for Customer

Assistance:

1-800-843-3544

If it is necessary to return the system for

service, your Customer Service

Representative will give you a Return

Authorization Number (RA) and shipping

instructions.

Pack the system carefully and send it to:

Williams Sound Corp.

Attn: Repair Dept.

10321 West 70th Street

Eden Prairie, MN 55344

Receiver Style: Body-Pack, dual-lens detector, lanyard

Size: 4.1" L x 2.85" W x 1.2" H (104.1 mm x 72.4 mm x 30.4 mm)

Weight: 4.5 oz (127 g) with batteries

Color and Material: Black

Lanyard: 3 ft (.91 m), allows receiver to be worn around the neck

Operating Temperature: -10° C to +50° C

Battery Type: 2 x AA, alkaline (BAT 001) or NiMH (BAT 026)

Battery Life: Alkaline: 60 hours, NiMH: 30 hours/charge

Battery Drain: 25 mA, nominal

Charging Contacts: For use only with CHG 3512

Carrier Frequency: Channel 1: 2.3 MHz, Channel 2: 2.8 MHz

Channel 3: 3.3 MHz, Channel 4: 3.8 MHz

De-Emphasis: 50 uS

FM Deviation: ±50 kHz

Signal-to-Noise Ratio: 60dB min.

Squelch: Receiver squelches (mutes) at 40 dB S/N ratio

Frequency Response: 25 Hz to 16 KHz, +1 dB, -3 dB, electrical response

Total Harmonic Distortion: Less than 1%, electrical response

Controls: ON/OFF/VOLUME: combination thumbwheel knob

Channel Selector: four-position rotary switch

Indicators: Red LED “ON” indicator, flashes to indicate Low battery

Audio Output Jacks: 3.5 mm stereo mini phone jack Accepts 3.5 mm mono or

stereo phone plug

Audio Output Power: 15 mW max at 32 Ω

Acoustic Output: 125 dB SSPL90 with HED 002; 110 dB SSPL90 w/ EAR 013

Sensitivity: Better than 1 nW/cm2for 40 dB signal-to-noise ratio

Approvals: CE, FCC, RoHS, WEEE

Warranty: 5 years on receiver, 90 days on accessories

Compatible Headphones/ Mono or stereo, 8-32 ohms, 3.5 mm mini phone plug,

Earphones: HED 021, HED 026, EAR 013, EAR 014, EAR 022, NKL 001

NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

10321 West 70th St., Eden Prairie, MN 55344 U.S.A.

800.843.3544 | 952.943.2252 | FAX: 952.943.2174

www.williamssound.com

SYSTEM SPECIFICATIONS

OUR

-C

HANNEL

NFRARED

ECEIVER

, M

ODEL

WIR RX22-4

Andere Handbücher für SoundPlus WIR RX22-4

Inhaltsverzeichnis

Andere Williams Sound Empfänger Handbücher

Williams Sound

Williams Sound One 2 One R1-216 Bedienungsanleitung

Williams Sound

Williams Sound DLR 360 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Bedienungsanleitung

Williams Sound

Williams Sound Hearing Helper PFM 350 RCH Bedienungsanleitung

Williams Sound

Williams Sound PPA VP 37 Leitfaden

Williams Sound

Williams Sound Personal PA PPA R7 Bedienungsanleitung

Williams Sound

Williams Sound Portable FM Listening System TGS 173 Leitfaden

Williams Sound

Williams Sound SoundPlus Infrared Receiver WIR RX238 Bedienungsanleitung

Williams Sound

Williams Sound Digi-Wave DLT-100 Bedienungsanleitung

Williams Sound

Williams Sound PPA R37 Bedienungsanleitung

Williams Sound

Williams Sound PPA R35-8 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Infrared Receiver WIR RX3 Bedienungsanleitung

Williams Sound

Williams Sound WIR 125 Leitfaden

Williams Sound

Williams Sound Whisper R863 Bedienungsanleitung

Williams Sound

Williams Sound PPA R37 Montageanleitung

Williams Sound

Williams Sound Whisper R863 Montageanleitung

Williams Sound

Williams Sound TGS R7 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Infrared Receiver WIR RX12-4 Bedienungsanleitung

Williams Sound

Williams Sound PPA VP Bedienungsanleitung

Williams Sound

Williams Sound PPA T21 Bedienungsanleitung

Williams Sound

Williams Sound WIR RX1 Bedienungsanleitung

Williams Sound

Williams Sound PPA R38 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus WIR RX22-4 Bedienungsanleitung

Williams Sound

Williams Sound WIR SYS ADV Fehlerbehebungshandbuch

Beliebte Empfänger Handbücher anderer Marken

Garmin

Garmin GA 23 Bedienungsanleitung

Aiphone

Aiphone PS-12F Bedienungsanleitung

IMES

IMES TCS-01CA-PMI Bedienungsanleitung

BWI Eagle

BWI Eagle AIR-EAGLE SR Handbuch

AMIMON

AMIMON AMN12310 WHDI Bedienungsanleitung

Dual

Dual DMCPA79BT Betriebsanleitung

Sound Associates

Sound Associates SA652P Bedienungsanleitung

Sherwood

Sherwood NewCastle R-772 Bedienungsanleitung

Audio

Audio A10-RX Series Bedienungsanleitung

AllSee

AllSee PushShare PSRV1.1 Bedienungsanleitung

DEMAG

DEMAG DRC-DR D2 Bedienungsanleitung

Teleco

Teleco TVRCL868A02 Bedienungsanleitung

Bosch

Bosch RF3222E Bedienungsanleitung

Kramer

Kramer 631R Bedienungsanleitung

Xpress

Xpress xmc10 Bedienungsanleitung

JVC

JVC KD-MR1BTS Bedienungsanleitung

Omega Engineering

Omega Engineering UWTC-REC3 Bedienungsanleitung

e-survey

e-survey E300 Pro Bedienungsanleitung