Williams Sound WIR 135 Bedienungsanleitung
O
VERVIEW
Thank you for purchasing the WIR 135 Listening System from Williams Sound Corp. Anyone
needing auditory assistance to overcome background noise, reverberation, or distance from the
sound source can benefit from the WIR 135.
You can use the WIR 135 for listening to the TV or other audio equipment, or for hearing assis-
tance in conference rooms. You can also use your RX8 Receiver in most facilities which have
an infrared transmitter operating on 95 kHz, such as theaters, cinemas, or churches.
S
YSTEM
C
OMPONENTS
1. TX95 Transmitter 2. RX8 Receiver
•TV Microphone (MIC 084) • (2) AA Batteries
• 1m Audio Cable with dual RCA plugs (WCA 078) •Earphone
• Power Supply
S
TEP
1: S
ET
U
P
T
HE
TX95 T
RANSMITTER
The WIR TX95 Transmitter may be placed on top of a TV or shelf. Place the TX95 Transmitter where it is
clearly visible from your listening position.
Infrared light behaves like visible light, so it is blocked by solid objects. This confines the signal to the room
where the transmitter is located. The transmitter cannot be placed inside or behind anything except glass. The
maximum operating distance is approximately 30 feet (9 m).
WIR 135 Listening System Instructions
Model WIR TX95 Transmitter, WIR RX8 Receiver
Williams Sound
®
Helping People Hear
1
Receiver
Charging
Indicator
Right
Battery
Charging
Indicator
Left
Battery
Charging
Indicator
Infrared
Transmitting
Diodes
Infrared
Transmitting
Diodes
(only for WIR
RX95 Receiver)
RX95 Receiver Charging Cradle (not used in this system)
BAT AP97A
Battery
Charging Port
(not used in
this system)
BAT AP97A
Battery
Charging Port
(not used in
this system)
Ideally, the TX95 Transmitter should be at ear-level height or above. The infrared light pattern is
much like a floodlight “cone” as it leaves the transmitter, with the best reception inside the cone.
Sunlight can cause infrared interference by reducing the operating distance. Thus, the system can-
not be used outdoors and may not work properly inside if a lot of direct sunlight is present.
Closing drapes or blinds will help if sunlight is a problem.
Any number of receivers may be used with the TX95 Transmitter, but use only one transmitter
in a room at the same time. Otherwise, interference between transmitters will occur.
S
TEP
2: C
ONNECT THE
T
RANSMITTER
P
OWER
S
UPPLY
Plug the Power Supply cord into the “DC 12V” jack on the back of the TX95. Then plug the
Power Supply into an AC outlet.
S
TEP
3: C
ONNECT THE
T
RANSMITTER TO THE
A
UDIO
S
OURCE
You may also use the Audio Cable supplied to connect the TX95 Transmitter directly to TV,
VCR, or other equipment output jacks . The WIR 135 is a mono system, so the Left and Right
inputs are mixed together. The Left or Right input jack may be used with a mono sound source.
When the Audio Inputs are used, the Mic input is disabled.
If you are using the TV Microphone , plug it into the “Mic” jack on the TX95 as shown. Use
the Velcro strip supplied to attach the microphone near the loudspeaker of your TV. The micro-
phone will allow you to play the TV at lower volume for other listeners and will pick up other
important sounds like the telephone or doorbell ringing.
The TX95 has an automatic shut-off feature that turns the Transmitter off several minutes after
the audio signal is no longer present.
Williams Sound
®
Helping People Hear
2
+
-
RDC12V LM
POWER SUPPLY
TELEVISION,
VCR,
STEREO
MICROPHONE
TX95
TV, VCR, STEREO
TV Mic
- OR -
3
1
2
4
LR
S
ETTING UP THE
TX95 T
RANSMITTER
1
2
3
4
4: I
NSTALL THE
R
ECEIVER
B
ATTERIES
Open the Battery Compartment on the RX8 Receiver
and install the two AA alkaline batteries. Be sure to
insert the battery “plus” and “minus” terminals
correctly as shown in the bottom of the battery com-
partment. DO NOT force the batteries in backwards.
If you are using rechargeable, Ni-Cad batteries (BAT
026), charge the batteries for 12–14 hours before
using the receiver.
Make sure the Receiver Volume Control Switch
(shown above) is turned OFF while charging.
5: P
LUG IN THE EARPHONE OR HEADPHONE
.
Next, plug the earphone or headphone into the jack
on top of the receiver
6: U
SING THE
R
ECEIVER
Rotate the Receiver Volume Control knob to turn the
receiver on and adjust the volume to a comfortable
level. Make sure your TV or audio source is turned
on. You should be able to hear the signal from the
Transmitter in the Receiver. The infrared receiver
“eye” is located on the front of the RX8. Do not
cover it up or you will lose reception.
Be sureto turn the Receiver OFF when it is
not in use.
I
N
C
ASE OF
D
IFFICULTY
If the system does not seem to be functioning:
1. Make sure that your television is plugged in and
turned on.
2. Make sure that the TX95 Transmitter is plugged
in and correctly connected to the TV or VCR’s
audio output.
3. If you’re using the TV Mic and not getting a sig-
nal: 1) Be sure the audio cable is not plugged
into the TX95; 2) Try turning the TV volume up
slightly; 3) Try positioning the TV mic directly
over the TV speaker.
4. Make sure that the RX8 Receiver has a working
battery.
5. Make sure you are not covering the RX8’s
infrared “eye.” Remove any objects obstructing
the line between the TX95 Transmitter and the
RX8 Receiver.
6. If you’ve installed the TX95 Transmitter other
than on top of the TV, make sure that its front
panel is facing the RX8 Receiver.
7. If the system still does not function, call your
Williams Sound Dealer.
W
ARRANTY
The WIR 135 Listening System carries a five year
parts and labor warranty on the TX95 Transmitter
and RX8 Receiver. The TV microphone, earphones,
headphones, rechargeable batteries, adaptors, and AC
to DC Power Adaptor carry a 90 day warranty. Be
sure to fill out and mail the Warranty Card to register
your serial number and warranty.
Williams Sound
®
Helping People Hear
3
Volume
Control
& Switch
Earphone
Jack
Infrared
"Eye"
Sound PlusSound Plus
®®
Infrared Receiver
Williams Sound
INFRARED LISTENING SYSTEM SPECIFICATIONS
Infrared Transmitter, Model WIR TX95-01 (EURO), TX95-02 (UK)
Size, Weight, Color: 6.25” L x 3.25” W x 1.25” H (15.9 cm x 8.3 cm x 3.2 cm), 5.1oz. (140g), Gray
Power Input: 12 VDC (center is positive) on DC connector, 200 mA Class II wall transformer
TFP 032 Power Supply, 2 pin Euro plug
TFP 033 Power Supply, 3 pin UK plug
Subcarrier Frequency: 95 kHz FM, 35 kHz wide-band modulation, 50 µS pre-emphasis
Auto Power On/Off: Transmitter shuts off after several minutes when audio signal is removed
Microphone Input: 3.5 mm jack for MIC 084 Electret TV Microphone, 1.5 kΩinput impedance
Line Inputs: 2 RCA jacks for mono or stereo line-level sources (bridged to mono)
200 mV min. to 10 V rms max. input level, 5.1 kΩinput impedance
Automatic Level Control: 35 dB compression range
Infrared LEDs, Pattern: 6 IR LEDs, 45 degree cone-shaped coverage pattern to -6dB intensity,
30ft. (9m) line of sight
Warranty: 5 years*
WIR RX8 Lavalier Receiver Specifications:
Size and Weight: 3.625” L x 2.375” W x .875” H (9.2 cm x 6 cm x 2.2 cm) 4.48 oz. (127 g)
Material and Color: Shatter-resistant polypropylene, gray
Battery Type: 1.5V (AA) x 2, Alkaline (BAT 001) or Rechargeable AA Ni-Cad (BAT 026)
Battery Life: 30 hours with BAT 001, 15 hours/charge with BAT 026, 25 mA, nom. current
drain
Charging: Contacts on side for CHG 200 dual charger or CHG 1600 multi-charger
Modulation Frequency: 95 kHz FM, 50 µS de-emphasis
Frequency Response: 200 Hz to 8 kHz, ± 4 dB
Signal to Noise Ratio: 55dB
Controls: Combination volume/On-Offrotary knob
Switched Low-Cut tone control (Lo: 20 Hz / Mid: 120 Hz / Hi: 700 Hz)
Audio Output: 3.5 mm stereo mini phone jack, 250 mW maximum into 16Ω
Acoustic Output: 130 dB MAX SSPL90 with EAR 013
Compatibility: Compatible with most wide-band 95kHz IR Transmitters
Warranty: 5 years*
The RX8 Receiver can be used with a Neckloop TeleCoil Coupler (NKL 001) to magnetically couple into a hearing aid
that has a telephone pick-up coil.
*90 day warranty on accessories
Williams Sound Corp.
10399 West 70th St., Eden Prairie, MN 55344-3459
U.S.A. 800-328-6190 / 952-943-2252 / FAX: 952-943-2174
www.williamssound.com
©2000, Williams Sound Corp. MAN 105A
4
Dieses Handbuch passt für folgende Modelle
2
Andere Williams Sound Empfänger Handbücher
Williams Sound
Williams Sound Motiva PFM 360 Leitfaden
Williams Sound
Williams Sound R801 Fehlerbehebungshandbuch
Williams Sound
Williams Sound Personal PA PPA R700 Bedienungsanleitung
Williams Sound
Williams Sound One 2 One R1-216 Bedienungsanleitung
Williams Sound
Williams Sound Digi-Wave DLR-50 Bedienungsanleitung
Williams Sound
Williams Sound SoundPlus Infrared Receiver WIR RX3 Bedienungsanleitung
Williams Sound
Williams Sound R16 Bedienungsanleitung
Williams Sound
Williams Sound TGS R7 Bedienungsanleitung
Williams Sound
Williams Sound IR?RX20 Bedienungsanleitung
Williams Sound
Williams Sound SoundPlus Infrared System WIRTX900 Bedienungsanleitung
Williams Sound
Williams Sound SoundPlus WIR RX22-4 Montageanleitung
Williams Sound
Williams Sound WIR 125 Leitfaden
Williams Sound
Williams Sound PPA VP 37 Leitfaden
Williams Sound
Williams Sound Hearing Helper PFM R31 Bedienungsanleitung
Williams Sound
Williams Sound TGS 100 Bedienungsanleitung
Williams Sound
Williams Sound SoundPlus WIR RX18 Montageanleitung
Williams Sound
Williams Sound WaveCAST Bedienungsanleitung
Williams Sound
Williams Sound FM Listening System PPA 575 Bedienungsanleitung
Williams Sound
Williams Sound TGS PRO 737 Leitfaden
Williams Sound
Williams Sound Motiva PFM 360 Leitfaden
