Altronix Trove T1RAL13F8P8 Bedienungsanleitung
Rev. T1RAL13F8P8032019
T1RAL13F8P8
Fully assembled kit includes:
- Trove1R rack enclosure with Altronix backplane (TAL1R)
- (1) eFlow4NB - Power Supply/Charger
- (1) eFlow6NB - Power Supply/Charger
- (1) ACM8 - Fused Access Power Controller
- (1) PD8UL - Fused Power Distribution Module
Installation Guide
All registered trademarks are property of their respective owners. More than just power.™
Installing Company: _____________________ Service Rep. Name: __________________________________________
Address: ________________________________________________________ Phone #: _________________________
Access & Power Integration
- 2 - T1RAL13F8P8
Overview:
Altronix T1RAL13F8P8 Trove Rack kit is pre-assembled and consist of Trove1AL1R enclosure/backplane with factory installed Altronix
power supply/chargers and sub-assemblies.
Configuration Chart:
Altronix
Model
Number
120VAC
60Hz
Input
Current
(A)
Power
Supply
Boards’
Input
Fuse
Rating
Power
Supply
Boards’
Battery
Fuse
Rating
Nominal DC
Output Voltage Maximum Supply
Current for Main
and Aux. Outputs
on Power Supply
board and ACM8
Access Power
Controller’s outputs
Fail-Safe/
Fail-Secure
or Dry
Form “C”
Outputs
Additional
Fuse
Protected
Outputs
Current Per
ACM8 Output
ACM8 Board
Input Fuse Rating
ACM8 Board
Output Fuse Rating
PD8UL Board
Input Fuse Rating
PD8UL Board
Output Fuse Rating
[DC] [Aux]
Output
Range
(VDC)
Output
Range
(VDC)
T1RAL13F8P8 75A/
250V
10A/
32V
Power Supply 1 (24VDC)
8 8 2.5A 15A/
32V
3.5A/
250V –3.5A/
250V
20.19-
26.4
20.19-
26.4 24VDC @ 5.7A
Power Supply 2 (12VDC)
10.0-
13.2
10.1-
13.2 12VDC @ 4A
Specifications:
Agency Listings:
• CE European Conformity.
Mechanical:
• Black enclosure with ample knockouts for convenient access.
• Includes: tamper switch, cam lock and mounting hardware.
• Modular 2U standard EIA 19” drawer with
extendable slides up to 48”.
• Dimensions (H x W x D): 3.25” x 19.0” x 26.5”
(82.6mm x 482.6mm x 673.1mm).
Included Accessories:
• One (1) tamper switch (Altronix Model TS112 or equivalent).
• Cam lock.
Available Accessories (not included):
• RE2: Rack Mount Battery Enclosure
accommodates up to four (4) 12VDC/7AH batteries.
• WM5, WM25, WM100: Magnetic Cable Tie Mounts
(5, 25, 100 counts).
T1RAL13F8P8 - 3 -
Assembling and Attaching Z Bracket Wire Management Accessory (included):
Altronix Trove Rack enclosures include Z Bracket, a convenient and reliable wire management accessory.
1. Carefully unpack Z Bracket. Do not discard hardware (included) (Fig. 1, pg. 3).
2. Attach arms to each other using bolts and lock nuts (Fig. 1a, pg. 3).
3. Attach the hinge brackets to the ends of arms using bolts and nuts positioning them as shown on Fig. 1b, pg. 3.
4. Make sure that all nuts are tightened.
Fig. 2
Fig. 2a
5. Attach the hinge bracket on the longer side of Z Bracket to the adjustable rail using bolts and lock nuts (included) (Fig. 2, 2a, pg. 3).
6. Attach the hinge bracket on the shorter side of Z Bracket to the rear of the rack enclosure using bolts (included).
Hardware (included):
Ten (10) bolts and eight (8) lock nuts
Two (2)
Fig. 1
Fig. 1b
Fig. 1a
- 4 - T1RAL13F8P8
Installation Instructions for T1RAL13F8P8:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having
jurisdiction. Product is intended for indoor use only.
1. Remove backplane from enclosure prior to installing into rack cabinet (do not discard hardware).
2. In order to mount included UL Listed tamper switch (Altronix Model TS112 or equivalent) turn the enclosure upside down.
Punch out the knockout in designated location, on the back of the unit, from outside of the drawer (Fig. 3, pg. 3).
Insert the tamper switch into the knockout from outside of the drawer with the button facing outwards and spaded connectors inside
the drawer. Connect tamper switch wiring to the Access Control Panel input or the appropriate UL Listed reporting device.
To activate alarm signal open the rack drawer.
3. Slide the Trove rack enclosure into an open 2U location in the rack cabinet.
4. Utilizing proper fasteners attach front ears to the rack rails.
5. Attach the rear of the adjustable slides to the rear rails of the rack cabinet with the proper fasteners.
6. Make sure that all internal cofigurations (wiring, voltage selection, switch settings, etc.) are complete before mounting backplane back
into enclosure.
7. Refer to the eFlow Power Supply/Charger Installation Guide for eFlow4NB and eFlow6NB, and corresponding sub-assembly
Installation Guides for ACM8(CB) and PD8UL for further instructions.
Fig. 3
Tamper Switch mounting location
Back of the drawer,
viewed from outside.
T1RAL13F8P8 - 5 -
T1RAL13F8P8 Configuration
Fig. 4
AC
L G N
DCAC1 1 min
enable
2 hr.
disable
OFF - 24V
ON - 12V
ON
TRIGGER EOL
SUPERVISED
--- BAT + --- DC +
NC C NO
AC FAIL
NC C NO
BAT FAIL
+ AUX ---
NO GND
RESET
Altronix - eFlow4NB
12VDC
AC
L G N
DCAC1 1 min
enable
2 hr.
disable
OFF - 24V
ON - 12V
ON
TRIGGER EOL
SUPERVISED
--- BAT + --- DC +
NC C NO
AC FAIL
NC C NO
BAT FAIL
+ AUX ---
NO GND
RESET
Altronix - eFlow6NB
24VDC
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
IN GND IN GND IN GND IN GNDIN GND IN GND IN GND IN GND
1 2 3 4 5 6 7 8
INPUT
TRIGGER
10A 250V
+INP- T + RET-
NO C NC
FACP INTERFACE
Power Control
- + - +
F1 F2 F3 F4 F5 F6 F7 F8
MAIN
TRG
FACP
1 2 3 4
1 2 3 4
ON
ON
1 2 3 4
1 2 3 4
ON
ON
Altronix - ACM8
N
COMMON POWER OUTPUTS
P
FUSED POWER OUTPUTS
1 2 3 4 5 6 7 8
D1
INPUT
P N
R1 LED
Altronix - PD8UL
To IEC connector
To LED lenses
- 6 - T1RAL13F8P8
Notes:
T1RAL13F8P8 - 7 -
TAL1R Dimensions:
18.5” x 15.25” x 0.3125” (469.9mm x 387.4mm x 7.9mm)
15.25” (387.4mm)
18.5” (469.9mm)
- 8 - T1RAL13F8P8
Trove1R Enclosure Dimensions (H x W x D):
3.25” x 19.0” x 26.5” (82.6mm x 482.6mm x 673.1mm). Shown with Z Bracket attached.
0.1”
2.5mm
1.5”
38.1mm
11.175” (283.8mm)
2.4”
61mm
4.57”
116.1mm
3.25”
82.3mm
26.5”
673.1mm
19” (482.6mm)
R 1.27” (32.3mm)
1” (25.4mm)
0.55” (14mm)
3.62”
92mm
Altronix is not responsible for any typographical errors.
140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056
IIT1RAL13F8P8 A14U
MEMBER
Inhaltsverzeichnis
Andere Altronix Gehäuse Handbücher
Altronix
Altronix Trove T1RSH3F8 Bedienungsanleitung
Altronix
Altronix TROVE Trove2KH2 Bedienungsanleitung
Altronix
Altronix Trove Series Bedienungsanleitung
Altronix
Altronix TROVE T2MK3F4D Bedienungsanleitung
Altronix
Altronix Trove2M2 Bedienungs- und Wartungsanleitung
Altronix
Altronix Trove 1AL1R Bedienungsanleitung
Altronix
Altronix Trove2M2R Bedienungsanleitung
Altronix
Altronix Trove2AG2 Bedienungsanleitung
Altronix
Altronix TROVE Trove3WC Series Bedienungsanleitung
Altronix
Altronix TROVE Trove2KS2 Bedienungsanleitung
Altronix
Altronix Trove T1SAK34 Bedienungsanleitung
Altronix
Altronix Trove2 Bedienungsanleitung
Altronix
Altronix TROVE T1RAG3F8 Bedienungsanleitung
Altronix
Altronix Trove Series Bedienungsanleitung
Altronix
Altronix Trove T3MK75F16 Bedienungsanleitung
Altronix
Altronix Trove1HW1R Bedienungsanleitung
Altronix
Altronix RE2 Bedienungsanleitung
Altronix
Altronix Trove Trove2KA2 Bedienungsanleitung
Altronix
Altronix Trove T1RSH3F8 Bedienungsanleitung
Altronix
Altronix Trove1V1R Bedienungsanleitung
