Amprobe SM-CAL1 Bedienungsanleitung

SM-CAL1

Sound Meter

Calibrator

Users Manual

Mode d’emploi

Bedienungshandbuch

Manuale d’Uso

Manual de uso

Användarhandbok

•

99 Washington Street

Melrose, MA 02176

Phone 781-665-1400

Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

English

SM-CAL1

Sound Meter Calibrator

Users Manual

SMCAL1_Rev001

➊Low battery indicator

➋Power and output level select switch.

➌Battery cover

➍Sound-Level Calibrator.

➎1/2” adapter.

POWER 94 114 OFF

SM-CAL1

POWER 94 114 OFF

SM-CAL1

Sound Meter Calibrator

CONTENTS

Symbols.................................................................................................................5

Unpacking and Inspection...................................................................................5

Introduction..........................................................................................................5

Operation ............................................................................................................5

Speciﬁcations........................................................................................................6

Maintenance and Repair ....................................................................................6

Battery Replacement ...........................................................................................7

SYMBOLS

Refer to the manual Complies with EU

directives

Conforms to relevant

Australian standards. Do not dispose of this

product as unsorted

municipal waste.

Warning and Precautions

When using Sound-Level Calibrator, ambient noise level should > 10dB

below the sound level being measured.

UNPACKING AND INSPECTION

Your shipping carton should include:

1 SM-CAL1 sound generator

1 1/2” adaptor

1 9 volt battery

1 Manual

If any of the items are damaged or missing, return the complete package to

the place of purchase for an exchange.

INTRODUCTION

The SM-CAL1 generates a ﬁxed sound level signals for calibration of sound

level meters. The Amprobe SM-CAL1 will work with any sound meter.

OPERATION

Turn on sound level meter and conﬁgure for 94 dB or 114 dB operation.

Plug the 1/2 adapter into the SM-CAL1 Sound level calibrator.

Insert any sound meter microphone into the Sound-Level Calibrator.

Turn on power switch and set sound level to 94 dB or 114 dB.

Observe the sound level meter for proper operation.

•

SPECIFICATIONS

General

Battery: 9V, 006P or IEC 6F22 or NEDA 1604.

Low Battery Indicator: LED will not be on when switched ON.

Battery Life: Approx 20 hours. (Alkaline battery)

Enviromental: Indoor operation; Altitude up to 2000

meters; Atmospheric Pressure: 1013

mbar.

Temperature and Humidity

Operation: 0 to 40°C (32 to 104°F), 10 to 70% RH.

Storage: -10 to 60°C (14 to 140°F), 10 to 90% RH.

Dimension: 48 x 125 mm (1.9 x 4.9 in.)

Weight: 285g ( 0.6 lb.) including battery

-EMC: EN61326-1 This product complies with requirements of the

following European Community Directives: 89/336/EEC (Electromagnetic

Compatibility) and 73/23/EEC (Low Voltage) as amended by 93/68/EEC (CE

Marking). However, electrical noise or intense electromagnetic fields in the

vicinity of the equipment may disturb the measurement circuit. Measuring

instruments will also respond to unwanted signals that may be present within

the measurement circuit. Users should exercise care and take appropriate

precautions to avoid misleading results when making measurements in the

presence of electronic interference.

Electrical (Sound)

Standard: ANSI S1.40-1984 and IEC942 1988 Class2.

Output Sound Level: 94dB and 114dB re 20 uPa under

reference.

Accuracy: ± 0.5 dB.

Output Frequency: 1 kHz ± 4 %.

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the operation of the meter, the

following steps should be performed in order to isolate the cause of the

problem.

Check the battery. Replace the battery immediately when the LED does

not come ON.

Review the operating instructions for possible mistakes in operating

procedure.

Except for the replacement of the battery, repair of the generator should be

performed only by a Factory Authorized Service Center or by other qualiﬁed

instrument service personnel. The front panel and case can be cleaned with

a mild solution of detergent and water. Apply sparingly with a soft cloth and

allow to dry completely before using. Do not use aromatic hydrocarbons or

chlorinated solvents for cleaning.

BATTERY REPLACEMENT

Turn off the meter and unscrew the switch cap. Replace the battery with a

NEDA type 1604 or equivalent 9V alkaline battery. Replace the cover.

Remove battery when the SM-CAL1 is not used for extended period.

Battery Replacement

POWER 94 114 OFF

SM-CAL1

POWER 94 114 OFF

Back to Amprobe SM-CAL1 Sound Calibrator

Visit us at www.TestEquipmentDepot.com

Andere Handbücher für SM-CAL1

Inhaltsverzeichnis

Andere Amprobe Prüfgeräte Handbücher

Amprobe

Amprobe BAT-200 Bedienungsanleitung

Amprobe

Amprobe ACD-14 TRMS-PLUS Bedienungsanleitung

Amprobe

Amprobe VPC-10 Bedienungsanleitung

Amprobe

Amprobe BAT-500 Bedienungsanleitung

Amprobe

Amprobe AT-2004-A Bedienungsanleitung

Amprobe

Amprobe UAT-600-EUR Series Bedienungsanleitung

Amprobe

Amprobe AM-42 Bedienungsanleitung

Amprobe

Amprobe PY-1A Bedienungsanleitung

Amprobe

Amprobe LT-10 Bedienungsanleitung

Amprobe

Amprobe ST-102B Bedienungsanleitung

Amprobe

Amprobe gp-2a Bedienungsanleitung

Amprobe

Amprobe PRM-4 Bedienungsanleitung

Amprobe

Amprobe DMIII Bedienungsanleitung

Amprobe

Amprobe ROBIN KMP7010 Bedienungsanleitung

Amprobe

Amprobe LAN-1 Bedienungsanleitung

Amprobe

Amprobe SM-CAL1 Bedienungsanleitung

Amprobe

Amprobe Telaris Series Bedienungsanleitung

Amprobe

Amprobe BAT-250 Bedienungsanleitung

Amprobe

Amprobe A-5000 Bedienungsanleitung

Amprobe

Amprobe CT238A Bedienungsanleitung

Amprobe

Amprobe BT-120 Bedienungsanleitung

Amprobe

Amprobe AT-2032 Bedienungsanleitung

Amprobe

Amprobe INSP-3 Bedienungsanleitung

Amprobe

Amprobe AMB-55 Bedienungsanleitung

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung

Rohde & Schwarz

Rohde & Schwarz RTA4000 Bedienungsanleitung