Arctic Cat Wide Track Turbo 2006 Series Referenzhandbuch

Condition: It has come to our attention that during the assembly of some of the affected snowmobiles, Loctite,

which helps secure the driveshaft retainer to the driveshaft, may have been applied improperly or may not

have been applied at all. If either of these conditions exist, the driveshaft retainer may loosen resulting in

the possibility of damage to the chain case components.

Solution: Remove the driveshaft retainer and properly apply blue Loctite #243 to the driveshaft threads; then

tighten the driveshaft retainer to 9.0 kg-m (65 ft-lb). See speciﬁc instructions included later in this bulletin.

INOTE: Although some snowmobiles may have had Loctite properly applied, it is necessary to remove the

driveshaft retainer from all affected snowmobiles and reapply Loctite. Even if Loctite may have been properly

applied, it will still be necessary to reapply Loctite since the effectiveness of the existing Loctite will have

been lessened by the removal of the retainer. See instructions included with this bulletin for the removal of the

driveshaft retainer and the proper application of Loctite.

Parts: Not Applicable (None Needed)

Warranty: A labor allowance of 0.7 hr will be paid per affected snowmobile.

Claim: Enter BS200606 in the Complaint section.

INOTE: Please remember that when submitting a claim, make sure to always enter the current mileage of each

affected snowmobile. In order for Arctic Cat to accurately assess warranty claims, an accurate recording of

mileage on snowmobiles with warranty claims is important.

! ATTENTION

To ensure that the necessary service work is completed in a timely manner and that this issue can be resolved,

Arctic Cat is requesting that all service work be completed prior to December 12, 2006. All warranty claims

directly related to this issue will not be honored after December 12, 2006, without prior approval.

Date: December 12, 2005

Bulletin No: 2006-1-06

Product Line: Snowmobile

Subject: Loctite Application (Driveshaft)

Affected Models/VIN Range:

All 2006 Bearcat Wide Track and Wide Track Turbo Models

Service Bulletin

Printed in the U.S.A. ®™ Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 1205

Instructions - Removing Driveshaft Retainer, Related Components, and Applying Loctite

1. Using an appropriate clamping tool, carefully clamp the breather hose to prevent oil from possibly entering the air

silencer assembly.

INOTE: It is recommended to place the clamping tool near the engine side of the hose.

2. Place a protective covering on the ﬂoor to prevent the snowmobile from becoming damaged; then place the snowmobile

onto its left side.

INOTE: After placing the snowmobile onto its left side, it will be necessary to open the hood. Be sure to place a

covering under the hood to also protect it from becoming damaged.

3. For Turbo models only, remove the two springs securing the resonator to the mounting bracket.

4. Remove the three cap screws securing the front of the chain case cover.

5. Remove the top cap screw securing the reverse shifting linkage assembly to the shift pivot.

6. Remove the cap screw securing the reverse shift pivot to the chain case cover. Move the shift pivot aside. Account for

two ﬂat washers and an axle spacer noting their locations for assembly purposes.

7. Remove the remaining three cap screws securing the chain case cover; then remove the chain case cover.

8. Loosen the chain adjuster; then remove the shaft retainer from the end of the driveshaft.

9. Remove the return spring and the reverse gear.

10. Remove the nut securing the top sprocket to the driven shaft.

11. Remove the chain with top sprocket, bottom sprocket, and reverse idler assembly.

12. Using a parts-cleaning solvent, clean the oil from the threads on the drive and driven shafts.

13. Apply a liberal amount of blue Loctite #243 to the end threads of the driveshaft.

14. Install the chain with top sprocket, bottom sprocket, and reverse idler assembly.

15. Install the reverse gear and the shaft retainer with return spring. Tighten shaft retainer to 9.0 kg-m (65 ft-lb).

16. Apply a liberal amount of green Loctite #609 to the end threads of the driven shaft.

17. Install the driven shaft nut and tighten to 5.5 kg-m (40 ft-lb).

18. Adjust the chain adjuster bolt to the proper tension.

19. Install the chain case cover and related components using existing hardware.

20. Place the snowmobile in an upright position; then remove the clamping tool from the breather hose.

Printed in the U.S.A. ®™ Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 1205

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Arctic Cat Schneemobil Handbücher

Arctic Cat

Arctic Cat Bearcat 570 XT Bedienungsanleitung

Arctic Cat

Arctic Cat ZR 200 Bedienungsanleitung

Arctic Cat

Arctic Cat CFR 800 Sno Pro 2010 Bedienungsanleitung

Arctic Cat

Arctic Cat Sno Pro 120 2011 Bedienungsanleitung

Arctic Cat

Arctic Cat ZR 900 Series 2006 Bedienungsanleitung

Arctic Cat

Arctic Cat Sno Pro 120 Bedienungsanleitung

Arctic Cat

Arctic Cat BEARCAT 2015 Bedienungsanleitung

Arctic Cat

Arctic Cat S2008ACAAAUSG Bedienungsanleitung

Arctic Cat

Arctic Cat 2010 Crossfire 600 Bedienungsanleitung

Arctic Cat

Arctic Cat ZR 120 2021 Bedienungsanleitung

Arctic Cat

Arctic Cat F 800 LXR Bedienungsanleitung

Arctic Cat

Arctic Cat ZR 5000 2015 Bedienungsanleitung

Arctic Cat

Arctic Cat 120 Sno Pro 2010 Bedienungsanleitung

Arctic Cat

Arctic Cat 2007 Bedienungsanleitung

Arctic Cat

Arctic Cat 660 cc Bedienungsanleitung

Arctic Cat

Arctic Cat S2009F5DFCUSG Bedienungsanleitung

Arctic Cat

Arctic Cat Sno Pro 120 2013 Bedienungsanleitung

Arctic Cat

Arctic Cat Flex-Tec Guard 7639-394 Bedienungsanleitung

Arctic Cat

Arctic Cat XF 2-STROKE Bedienungsanleitung

Arctic Cat

Arctic Cat Bearcat 7000 XT 2017 Bedienungsanleitung

Arctic Cat

Arctic Cat Crossfire 600 Bedienungsanleitung

Arctic Cat

Arctic Cat ZR4000 2016 Bedienungsanleitung

Arctic Cat

Arctic Cat Bearcat 570 2012 Bedienungsanleitung

Arctic Cat

Arctic Cat 2015 ZR 6000 Bedienungsanleitung

Beliebte Schneemobil Handbücher anderer Marken

BRP

BRP Ski-Doo MXZ 120 2023 Bedienungsanleitung

Ski-Doo

Ski-Doo Formula Plus 1985 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Ski-Doo Alpine 74 1959 Bedienungsanleitung

Yamaha

Yamaha SnoScoot SXR2NJ Bedienungsanleitung

Yamaha

Yamaha VX500XTB Bedienungsanleitung

Yamaha

Yamaha RS VENTURE 2014 Bedienungsanleitung

Polaris

Polaris RMK Shift Bedienungsanleitung

Yamaha

Yamaha VK540EF Bedienungsanleitung

Ski-Doo

Ski-Doo 1982 Elite Bedienungsanleitung

Yamaha

Yamaha VK540EF Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo Nordic 640ER 1974 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo OLYMPIQUE 300 1974 Bedienungsanleitung

Yamaha

Yamaha SXV4NP Bedienungsanleitung

Ski-Doo

Ski-Doo MX Bedienungsanleitung

Ohlins

Ohlins PB 616 Bedienungsanleitung

Ski-Doo

Ski-Doo Blizzard 5500 1979 Bedienungsanleitung

Polaris

Polaris 600 RUSH 2013 Leitfaden

BOMBARDIER

BOMBARDIER Ski-doo MX ZX 440 Handbuch