Argos Atlas 152/9432 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 50cm

Depth - 59.5cm

Height - 212.5cm

Atlas - Single Robe Carcass

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 2 - 05/02/14

Important - Please read these instructions fully before starting assembly

ALR2954

152/9432

157/9107

157/2537

Issue 2 - 05/02/14 - The holes for the front feet have come forward by 32mm to improve stability.

Note added at Step 14 to emphasise the unit must be fixed to a wall and must be level and square.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 34kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Universal End (D2396A)

(2074 x 591mm) x 2

Top/Base (D2399A)

(500 x 592mm) x 2

Fixed Shelf (D2401A)

(468 x 590mm)

Back (X2100-494)

(2100 x 494mm)

Hanging Rail (FHR460)

(460mm long) x 2

4 5

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 2

Metal dowel (F901) x 4

D E

Large locking

nut (F900) x 4

G H I

Nail (F51) x 33

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

see malibu fitment mk2 for large number of panels and fittings

Rail Holder

(F891) x 4

Allen Key (F36) x 1 50mm Screw (F49) x 12

19mm Screw (F461) x 2

25mm Screw (F50) x 4

13mm Screw (F63) x 16

13mm Screw (F79) x 1

Bracket (F327) x 1

Feet (F854) x 4

Tools required

Rule

Scissors

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

Square

mm 10 20 30 40 50 60 70 80 90 100

Handle (F323) x 1 Hinge (F328) x 4

Finished

front edge

Prepare the left end

Refer to step 1 and, if

you have chosen to fit 1

hanging rail or, an

internal chest or, a

shelf pack, screw 2

metal dowels into the

left end .

Note: Tighten the metal

dowels up fully against

the panels.

Note: If you have

purchased a shelf pack,

do not fit the rail holder.

To fit the rail holder ,

screw through its top

hole with screw and

into the shallow mark

hole drilled in the left end

. . Make sure that it is

fitted straight, in line with

the panel edges and

then fit another screw

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Are you fitting 1 or 2

Hanging Rails or, an

Internal Chest or, a

Shelf Pack?

Step 1

Step 2

The fixed shelf will

need to go here if

you are fitting the

following:-

Only 1 Hanging Rail

An Internal Chest

A Shelf Pack

Follow Steps

2 and 3.

Only follow Steps 2 and 3 if you are only fitting

1 hanging rail or, an internal chest or, a shelf pack.

If you are fitting 2 hanging rails, follow Step 4 and 5.

The fixed shelf

will need to go

here if you are

fitting the

following:-

2 Hanging Rails

Follow Steps

4 and 5.

Note: If you have purchased a shelf pack,

do not fit the rail holder.

Assembly Instructions

Step 3

Step 4

Prepare the right end

Refer to step 1 and, if

you have chosen to fit 1

hanging rail or, an

internal chest or, a

shelf pack, screw 2

metal dowels into the

right end .

Note: Tighten the metal

dowels up fully against

the panels.

To fit the rail holder ,

screw through its top

hole with screw and

into the shallow mark

hole drilled in the right

end . Make sure that

it is fitted straight, in line

with the panel edges and

then fit another screw

using the lower hole.

Finished

front edge

Finished

front edge

Prepare the left end

Refer to step 1 and, if

you have chosen to fit 2

hanging rails, screw 2

metal dowels into the

left end .

Note: Tighten the metal

dowels up fully against

the panels.

To fit the 2 rail holders

screw through the top

hole with screw and

into the shallow mark

hole drilled in the left end

. . Make sure that they

are fitted straight, in line

with the panel edges and

then fit another screw

using the lower hole.

Only follow Steps 4 and 5 if you are fitting 2 hanging rails.

If you are just fitting 1 rail, follow Step 2 and 3.

Note: If you have purchased a shelf pack,

do not fit the rail holder.

Only follow Steps 2 and 3 if you are only fitting

1 hanging rail or, an internal chest or, a shelf pack.

If you are fitting 2 hanging rails, follow Step 4 and 5.

Assembly Instructions

Step 5Only follow Steps 4 and 5 if you are fitting 2 hanging rails.

If you are just fitting 1 rail, follow Step 2 and 3.

Finished

front edge

Prepare the right end

Refer to step 1 and, if

you have chosen to fit 2

hanging rails, screw 2

metal dowels into the

right end .

Note: Tighten the metal

dowels up fully against

the panels.

To fit the 2 rail holders

screw through the top

hole with screw and

into the shallow mark

hole drilled in the right

end . Make sure that

they are fitted straight, in

line with the panel edges

and then fit another

screw using the lower

hole.

Step 6

Prepare the fixed shelf

Tap 2 wooden dowels

into the fixed shelf .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the fixed

shelf .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Finished

front edge

10mm

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 7

Step 8

Join the fixed shelf to

the right side

Push the fixed shelf

onto the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the fixed shelf .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

If you have fitted the

2 metal dowels in this

position, the fixed

shelf will go here.

The following diagrams will show the fixed

shelf at the top end of the unit.

You may have fitted it in the middle of the unit.

The following steps show the fixed shelf near the top of the unit.

You may have fitted it in the centre of the unit.

Fit the left side

Push the left side

onto the fixed shelf .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the fixed shelf .

Finished

front edge

Finished

front edge

Assembly Instructions

Step 9

Step 10

Fit the base

Attach the base to

the ends using 6

screws and tighten

them using the allen key

. .

Finished

front edge

Prepare the base

Screw the 4 feet into

the shallow mark holes

on the base using

screws .

Note: Use the shallow

mark holes to fit the feet.

Step 11

Fit the top

Attach the top to the

ends using 6 screws

and tighten them using

the allen key .

Unit colour on

the top surface

Assembly Instructions

Step 12

Step 13

Fit the back

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back

onto the unit.

Nail around the

outside edges of the

back .

Note: Nails should be

spaced about 150mm

apart.

Stand the unit up for

the next step.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Fit the hanging rail(s)

Push the hanging rail(s)

. into the rail holders

fitted to the side panels.

Warning: The

unit is heavy.

Lift with care.

Note: Do not fit the hanging rail(s)

if you are fitting the shelf pack.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 634/1457 Bedienungsanleitung

Argos

Argos Amersham 724/7196 Bedienungsanleitung

Argos

Argos Capella Bedienungsanleitung

Argos

Argos RETRO 213/3274 Bedienungsanleitung

Argos

Argos Habitat AVR Wooden Barstool 600/5779 Bedienungsanleitung

Argos

Argos Jarvia 143/6202 Bedienungsanleitung

Argos

Argos 482/0688D Bedienungsanleitung

Argos

Argos Camden 305/0772 Bedienungsanleitung

Argos

Argos Tolga 323/5164 Bedienungsanleitung

Argos

Argos Scandinavia 459/8305 Bedienungsanleitung

Argos

Argos HOME Bedienungsanleitung

Argos

Argos Bolitzo 780/3066 Bedienungsanleitung

Argos

Argos Brixham 617/9131 Bedienungsanleitung

Argos

Argos 459/1591 Datenblatt

Argos

Argos Finland 656/1770 Bedienungsanleitung

Argos

Argos Stirling 343/9049 Bedienungsanleitung

Argos

Argos 719/0023 Bedienungsanleitung

Argos

Argos Dalton 246/6422 Bedienungsanleitung

Argos

Argos 213/7816 Bedienungsanleitung

Argos

Argos Arvika 355/7794 Bedienungsanleitung

Argos

Argos 6001955 Bedienungsanleitung

Argos

Argos Slim Media Storage With Cupboard 143/9618 Bedienungsanleitung

Argos

Argos 832 Bedienungsanleitung

Argos

Argos TC Marston White Shake XL Blanket Box... Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung