Argos Aurora 147/1360 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 100cm

Depth - 49.5cm

Height - 43.5cm

Aurora - Coffee Table

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800

Issue 4 - 26/05/15

Important - Please read these instructions fully before starting assembly

ALR2939

147/1360

166/6553

417/9009

Issue 2 - 05/02/14 - Drawer Base changed to T919-347.

Drawer Back was showing ’x 4’. This has now been amended.

Note added on the last page to remove protective film from panels.

Issue 3 - 13/03/15 - W509LH changed to W350-115LLH and W509RH changed to W350-115LRH.

Issue 4 - 26/05/15 - Added new Argos code to front page - 417/9009

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 26kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Left Side (D2638A)

(420 x 459mm)

Back (D2641A)

(985 x 192mm)

Rail (D2643A)

(959 x 95mm) x 3

32 Right Side (D2639A)

(420 x 459mm)

Horizontal (D2640A)

(959 x 456mm)

Drawer Front (D2642A)

(985 x 192mm)

Top (D2644A)

(999 x 495mm)

Drawer Back (W908-115)

(908 x 115mm)

9 10 11

Drawer Base (T919-347)

(919 x 347mm)

Left Drawer Side

(W350-115LLH)

(350 x 115mm)

Right Drawer Side

(W350-115LRH)

(350 x 115mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 10

Metal dowel (F901) x 16

Large locking

nut (F900) x 14

E F

G H I

Small locking

nut (F3) x 2

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

J K

Door Plate (F259) x 1

25mm Screw (F50) x 2 13mm Screw (F52) x 8

13mm Screw (F63) x 6

Door Push (F258) x 1

Feet (F854) x 2

Knock-in Peg (F171) x 4

MR Runner (F160) x 1

L Runner (F161) x 1

L Runner (F159) x 1

R Runner (F162) x 1

350mm long

Wedgefix (F639) x 6

Mini block (F25) x 4

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Step 1

Step 2

Prepare the drawer

front

Screw 2 metal dowels

into the holes shown on

the back of the drawer

front .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Groove

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Note: The locking nuts can be on either surface of the drawer sides.

Make sure that the groove is on the inside, as shown.

Assembly Instructions

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

9 10

Step 6

Fit the 6 wedgefixes

Turn the drawer

assembly over.

Slide the wedgefixes

into the small grooves on

the drawer assembly, as

shown.

Once in place, tighten up

the screws.

M d

Assembly Instructions

Step 7

Fit the runners to the

drawer

Turn the drawer

assembly over.

Fit runner , marked

with ‘R’, to the bottom

edge of the right drawer

side , as shown,

making sure that it is

pushed up against the

back of the drawer front

. . Use a bradawl to

mark the fixing positions,

then secure with 2

screws .

Fit runner , marked

‘L’, to the bottom edge

of the left drawer side

using the same method.

M d

M c

Runners must be

pushed up against

the drawer front

M c

Prepare the horizontal

Tap 2 wooden dowels

into the horizontal .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the

horizontal .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 8

Finished

front edge

plain chipboard surface

10mm

Finished

front edge

Finished

front edge

Assembly Instructions

Step 9

Finished

front edge

M a

Finished front edge

M a

Finished front edge

1st

screw

2nd

screw

3rd

screw

Prepare the left side

a: Tap a wooden dowel

. into the left side .

Screw 5 metal dowels

into the left side .

b: Insert 2 large locking

nuts into the left side

. .

Fit the runner to the

left side .

The 1st screw uses

the 2nd hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

c: Fit a screw into

the 2nd hole in at the top

of the runner .

Gently tap 2 mini blocks

. into the left side ,

orientated as shown.

M a

Finished

front edge

M a

Assembly Instructions

Step 10

Prepare the right side

a: Tap a wooden dowel

. into the right side .

Screw 5 metal dowels

into the right side .

b: Insert 2 large locking

nuts into the right

side .

Fit the runner to the

right side .

The 1st screw uses

the 2nd hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

c: Fit a screw into

the 2nd hole in at the top

of the runner .

Gently tap 2 mini blocks

. into the right side ,

orientated as shown.

M b

Finished front edge

H1st

screw

2nd

screw

H3rd

screw

M b

Finished

front edge

Finished

front edge

M b

Finished front edge

Finished

front edge

M b

Finished

front edge

Finished

front edge

Assembly Instructions

Step 11

Join the right side and

horizontal

Push the horizontal

onto the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the horizontal .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

plain chipboard surface

Step 12

Prepare 1 of the rails

Tap 2 wooden dowels

into a rail .

Insert 2 large locking

nuts into a rail .

x 1

x 2

Step 13

Prepare the other 2

rails

Tap 2 wooden dowels

into each rail .

Insert 2 large locking

nuts into each rail .

Screw a foot onto

each rail between the

2 pre-drilled holes using

screws .

Dieses Handbuch passt für folgende Modelle

Andere Argos Inneneinrichtung Handbücher

Argos

Argos SAN DIEGO 408/8365 Bedienungsanleitung

Argos

Argos 626/9728 Bedienungsanleitung

Argos

Argos Savannah 602/5326 Bedienungsanleitung

Argos

Argos Evelyn 340/3790 Bedienungsanleitung

Argos

Argos Nordic 1663886 Bedienungsanleitung

Argos

Argos Habitat DUO CLIC CLAC 3553657 Bedienungsanleitung

Argos

Argos 609/6269 Bedienungsanleitung

Argos

Argos Wow Pine Kitchen Trolley 424/6963 Bedienungsanleitung

Argos

Argos Mix and Match 709/0439 Bedienungsanleitung

Argos

Argos Carmen 239/2091 Bedienungsanleitung

Argos

Argos Caspian 343/8521 Bedienungsanleitung

Argos

Argos Normandy 2 Door Tall Robe 357/1505 Bedienungsanleitung

Argos

Argos 147/7584 Bedienungsanleitung

Argos

Argos RONDA 8 SEATER CORNER DINING SET 7473441 Bedienungsanleitung

Argos

Argos Hygena Bedienungsanleitung

Argos

Argos Caspian 355/9424 Bedienungsanleitung

Argos

Argos Aspley 481/9651 Bedienungsanleitung

Argos

Argos 609/2555 Bedienungsanleitung

Argos

Argos 274/9668 Bedienungsanleitung

Argos

Argos 457/2156 Handbuch

Argos

Argos Malibu 617/1225 Bedienungsanleitung

Argos

Argos Verona 609/5026 Bedienungsanleitung

Argos

Argos Puerto Rico 641/7697 Bedienungsanleitung

Argos

Argos HOME Crystal II 3ft Frame Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung