Argos Capella 249/6674 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width -123.5cm

Depth - 39cm

Height - 74.4cm

Capella - 4 + 4 Drawer Chest

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 6 - 28/03/14

Important - Please read these instructions fully before starting assembly

249/6674

247/6058

268/2433

ALR2994

03/08/11 - Drawer assembly changed to Knock-in Pegs.

Drawer Sides and Drawer Back changed to take Knock-in Pegs.

Upright corrected to D1041A.

25/10/11 - Changed Step 7 to say to use the 1st hole and the 3rd hole of the runner.

25/10/11 - Recreated the AI to meet the set standards and corrected the mistakes.

Changed Step 9 to say to use the 1st hole from the front of the runner, as requested.

246/7081

Issue 5 - 16/05/12 - New Argos code added

Issue 6 - 28/03/14 - Drawer sizes increased

16 drawer wedges added.

5 plastinails added.

Old cat codes removed and new ones added.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 41kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Left Side (D1039A)

(744 x 390mm)

Left Hand Drawer Front (D1044A)

(599 x 157mm) x 4

Back (X832A)

(1229 x 646mm)

Rail (D1043A)

(1205 x 103mm) x 2

Right Side (D1040A)

(744 x 390mm)

Right Hand Drawer Front (D1045A)

(599 x 157mm) x 4

Upright (D1041A)

(621 x 368mm)

Support (D1046A)

(300 x 85mm)

3Top (D1042A)

(1205 x 369mm)

Drawer Back (W564 - 124)

(564 x 124mm) x 8

Drawer Base (T575 - 367)

(575 x 367mm) x 8

Left Drawer Side (W370-124LH)

(370 x 124mm) x 8

Right Drawer Side (W370-124RH)

(370 x 124mm) x 8

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 8

Metal dowel (F901) x 26

D E

Large locking

nut (F900) x 10

G H I

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Small locking

nut (F3) x 16

Nail (F51) x 22

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Drawer runner (F1004) x 16

Handle (F930) x 8

25mm Screw (F50) x 16 9mm Screw (F74) x 16 9mm Screw (F73) x 32

45mm Screw (F65) x 3

Knock-in Peg (F171GY) x 32

Plastic Nail (F91) x 5

Wedgefix (F639) x 32

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 4

Prepare the 4 left

hand drawer fronts

and 4 right hand

drawer fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front and .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

x 8 x 8

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

910

Step 3

x 8

Attach the drawer

sides to the drawer

fronts

Push the left drawer sides

. and right drawer sides

. onto the back of the

drawer fronts and .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Note: The locking nuts can be on either surface of the drawer sides.

Make sure that the small groove is on the inside, as shown.

96 7

Note: The right drawer

front has a shallow

identification mark.

Assembly Instructions

Step 4

Attach the handle

Attach a handle to

each drawer front

and using 2 screw .

Step 6

x 8

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

fronts and .

Step 5

Fit the drawer back

Fit the drawer back .

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

9 10

x 8

9 10

Fit the wedgefixes

Turn the large drawer

assemblies over and

slide 4 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

Step 7

6 7

and

6 7

and

Profiled

front edge

Profiled

front edge

Profiled

front edge

Assembly Instructions

Step 8

Profiled

front edge

Back edge

Prepare the left side

a: Place 4 runners on

the left side . Slide

back the top of the

runner and use the 1st

hole from the front to fit

the 1st screw .

b: Slide the runner back

the other way and use

the 3rd hole from the

back to fit the 2nd screw

c: Screw 4 metal

dowels into the left

side .

Assembly Instructions

Step 9

Prepare the right side

a: Place 4 runners on

the right side . Slide

back the top of the

runner and use the 1st

hole from the front to fit

the 1st screw .

b: Slide the runner back

the other way and use

the 3rd hole from the

back to fit the 2nd screw

. .

c: Screw 4 metal

dowels into the right

side .

Profiled

front edge

Back edge

Profiled

front edge

Profiled

front edge

Profiled

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

Prepare the upright

a: Place 4 runners on

the upright . Slide

back the top of the

runner and use the 1st

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the upright .

Insert 2 large locking

nuts as shown.

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Turn the upright over.

c: Repeat the

instructions above to fit 4

runners onto the other

side of the upright

using screws .

Turn the upright over

c: I

Finished

front edge

Finished

front edge

Profiled

front edge

Assembly Instructions

Prepare the top

Tap 4 wooden dowels

into the top as

shown.

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the top .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Screw 2 metal dowels

into the top .

10mm

Join the upright and

top

Push the top onto

the upright as

shown.

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the upright .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 12

Finished

front edge

plain chipboard surface

Finished

front edge

Finished

front edge

Step 11

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 033 3042 Series Bedienungsanleitung

Argos

Argos Twister CD/DVD tower Bedienungsanleitung

Argos

Argos SWIVEL Bedienungsanleitung

Argos

Argos Alicia 171/5875 Bedienungsanleitung

Argos

Argos Woburn 186/2807 Bedienungsanleitung

Argos

Argos Malibu Bedienungsanleitung

Argos

Argos Slim Media Storage With Cupboard 143/9618 Bedienungsanleitung

Argos

Argos TC NEW PAOLO 3 SEAT POWERED Bedienungsanleitung

Argos

Argos New Sywell 187/2354 Bedienungsanleitung

Argos

Argos 932/7722 Bedienungsanleitung

Argos

Argos 458/2373 Bedienungsanleitung

Argos

Argos Wooden Filer Bedienungsanleitung

Argos

Argos New Penton 246/4943 Bedienungsanleitung

Argos

Argos Lydiard Gloss 2008952 Bedienungsanleitung

Argos

Argos Calgary 476/7978 Bedienungsanleitung

Argos

Argos Murano 332/6138 Datenblatt

Argos

Argos 609/2256 Bedienungsanleitung

Argos

Argos Canterbury 3 DR Robe Bedienungsanleitung

Argos

Argos 245/7424 Bedienungsanleitung

Argos

Argos Normandy 2 Door Tall Robe 357/1505 Bedienungsanleitung

Argos

Argos Eden 414/1594 Bedienungsanleitung

Argos

Argos Summerton 137/6300 Bedienungsanleitung

Argos

Argos hygena 617/5599 Bedienungsanleitung

Argos

Argos New Hallingford 4+4 Drawer Chest Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung