Argos Designer 2 Tone Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 113.5cm

Depth - 40cm

Height - 61cm

Designer 2 Tone - TV Unit

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 2 - 02/07/14

Important - Please read these instructions fully before starting assembly

ALR3049

249/8593

Issue 2 - 02/07/14 - The Small Upright now has edge tape on the back edge.The relevant steps no longer refer to“Finished front edge”.

Step 25 amended to now show the shelf studs being screwed up into the shelf.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 29.5kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Flyover Top (D2968A)

(900 x 396mm)

Left Side (D2970A)

(398 x 395mm)

Small Upright (D2974A)

(146 x 280mm)

Fixed Shelf (D2976A)

(218 x 329mm)

Base (D2977A)

(1133 x 396mm)

Right Side (D2973A)

(559 x 395mm)

Top (D2969A)

(900 x 396mm)

Loose Shelf (D2975A)

(492 x 390mm) x 2

4Left Upright (D2971A)

(398 x 395mm)

Right Upright (D2972A)

(398 x 395mm)

Drawer Front (D2978A)

(355 x 194mm) x 2

Drawer Base (T337-367)

(337 x 367mm) x 2

Back (X826-424)

(826 x 424mm)

Drawer Back (W326-124)

(326 x 124mm) x 2

Left Drawer Side (W370-124LH)

(370 x 124mm) x 2

Right Drawer Side (W370-124RH)

(370 x 124mm) x 2

10 11

14 15 16

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

A B

Metal dowel (F901) x 14

D E

Large locking

nut (F900) x 10

H I

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Small locking

nut (F3) x 4

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

25mm Screw (F50) x 9

40mm Screw (F910) x 8

Drawer runner (F1004) x 4

9mm Screw (F74) x 4

Knock-in Peg (F171GY) x 8

Nail (F51) x 179mm Screw (F73) x 8

Shelf stud (F110) x 8

Wedgefix (F639) x 4

Handle (F930) x 2 Feet (F854) x 5

Shelf stud (F372) x 4

Mini Block (F25) x 2

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 2

13 14

Step 2

Prepare the 2 drawer

fronts

Screw 2 metal dowels

into each of the drawer

fronts .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and the right

drawer side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 3

Attach the drawer

sides to the drawer

fronts

Push the left drawer sides

. and right drawer sides

. onto the back of the

drawer fronts .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Assembly Instructions

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 6

13 14

Attach the handles

Attach a handle to

each of the drawer fronts

. using 2 screws .

Note: Do not

overtighten the screws.

13 14

Step 7

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

x 2

Finished

front edge

Finished

front edge

Assembly Instructions

Step 8

Prepare the top

Screw 6 metal dowels

into the top .

Finished

front edge

Insert 2 large locking

nuts into the

right upright .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 9

Step 10

Finished

front edge

Fit the right upright to

the top

Push the right upright

onto the top .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the right upright .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Assembly Instructions

Step 11

Step 12

Finished

front edge

Finished

front edge

Prepare the left

upright

Note: Do not use the

through holes to fit the

runners.

a: Place 2 runners on

the left upright as

shown. Slide back the

top of runner and use the

2nd hole from the front

to fit the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left upright .

Insert 2 large locking

nuts into the left

upright .

Finished

front edge

Finished

front edge

Fit the left upright

Push the left upright

onto the top .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the left upright .

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 13

Step 14

Fit the left side

Push the left side

onto the top .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the left side .

Prepare the left side

a: Place 2 runners on

the left side as

shown. Slide back the

top of runner and use the

2nd hole from the front

to fit the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left side .

Insert 2 large locking

nuts into the left side

. .

Finished

front edge

Assembly Instructions

Step 15

Step 16

Finished

front edge

Fit the base

Attach the base to

the assembly using 6

screws .

plain chipboard surface

Prepare the base

Screw the 5 feet onto

the base using

screws .

Finished

front edge

plain chipboard surface

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 248/6622D Bedienungsanleitung

Argos

Argos Tolga 483/8364 Bedienungsanleitung

Argos

Argos 166/6890 Bedienungsanleitung

Argos

Argos Mia 3 Drawer Chest Bedienungsanleitung

Argos

Argos 875/4059 Bedienungsanleitung

Argos

Argos Montana 395/7370 Bedienungsanleitung

Argos

Argos Newport Bedienungsanleitung

Argos

Argos Habitat Maine 2 Shelf Small Bookcase... Bedienungsanleitung

Argos

Argos 737/8876 Bedienungsanleitung

Argos

Argos 228/7591 Bedienungsanleitung

Argos

Argos 389/5690 Bedienungsanleitung

Argos

Argos New Hallingford 4+4 Drawer Chest Bedienungsanleitung

Argos

Argos 459/4598 Bedienungsanleitung

Argos

Argos 875/4334 Bedienungsanleitung

Argos

Argos Mendoza 228/2723 Bedienungsanleitung

Argos

Argos Kensington Installationsanleitung

Argos

Argos Stirling 343/9049 Bedienungsanleitung

Argos

Argos Merrick 183/8587 Bedienungsanleitung

Argos

Argos 487/8317 Bedienungsanleitung

Argos

Argos 875/4860 Bedienungsanleitung

Argos

Argos Normandy 428/2611 Bedienungsanleitung

Argos

Argos 149113 Bedienungsanleitung

Argos

Argos Napoli 600/6259 Bedienungsanleitung

Argos

Argos Shelby 322/0296 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung