Argos New Sywell 282/4150 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 70.5cm

Depth - 50cm

Height - 172cm

New Sywell - 2 Door Robe

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 5 - 21/07/14

Important - Please read these instructions fully before starting assembly

ALR3010

282/4150

267/7606

266/2965

281/8960

266/3768

Issue 2 - 07/04/14

Add 4 plastinails

Remove old cat codes and add new

Issue 3 - 28/04/14 - Amended codes

Issue 4 - 02/05/14 - White cat code changed from 248/8242 to 281/8960

Issue 5 - 21/07/14 - Replaced code 274/6977 with 266/3768

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 40.5kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Top (D2559A)

(674 x 494mm)

Left Side (D2560A)

(1711 x 496mm)

Base (D2562A)

(674 x 494mm)

Right Side (D2561A)

(1711 x 496mm)

Door (D2563A)

(1650 x 333mm) x 2

Rail (D2597A)

(674 x 125mm)

Back (X1682-700)

(1682 x 700mm)

Hanging Rail (FHR666)

(666mm long)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

A B C

D E F

G H

Rule

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

J K L

Bracket (F327) x 1 Hinge plate

(F523) x 6 Hinge (F522) x 6

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Step

ladder

Ruler - Use this ruler to help correctly identify the screws

13mm Screw (F79) x 1 13mm Screw (F63) x 16

Electric drill

(only use

when drilling

into walls)

Large locking

nut (F900) x 10

Wooden dowel (F22) x 10 Metal dowel (F901) x 10

25mm Screw (F95) x 4

Rail Holder

(F891) x 2

Nail (F51) x 32

Handle (F315) x 2

Shelf stud (F110) x 2

Plastic Nail (F91) x 4

Finished

front edge

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Prepare the left side

Screw 5 metal dowels

into the left side .

Note: Tighten the metal

dowels up fully against

the panels.

Fit 3 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the left side . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Step 1

Step 2

Finished

front edge

Prepare the right side

Screw 5 metal dowels

into the right side .

Fit 3 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the right side .

Make sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Assembly Instructions

Step 3

Step 4

10mm

Prepare the top

Tap 4 wooden dowels

into the top .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the top .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Finished

front edge

plain

chipboard

surface

Finished

front edge

Prepare the base

Tap 4 wooden dowels

into the base .

Insert 4 large locking

nuts into the base .

Finished

top edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 5

Fit the top and base

to the right side

Push the top and

base onto the right

side .

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the top and base.

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

3 4

Step 6

plain

chipboard

surface

Prepare the rail

Tap 2 wooden dowels

into the rail .

Insert 2 large locking

nuts into the rail .

Step 7

Plain chipboard

surface

Fit the rail

Push the rail onto the

right side .

Use a screwdriver to

tighten the large locking

nut fitted to the rail .

Finished

top edge

Note: Support the

rail until the left

side has been fitted

in the next step.

Finished

front edge

Assembly Instructions

Step 8

Step 9

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 5 large

locking nuts fitted to

the top , base and

rail .

3 4

Fit the back and

plastic nails

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back ,

coloured surface facing

down, onto the unit as

shown.

Nail around the

outside edges of the

back .

Note: Nails should be

spaced about 150mm

apart.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Warning: The

unit is heavy.

Lift with care.

Tap 2 plastic nails

into the bottom edge of

each of the sides and

. .

Stand the unit up

for the next stage.

Fit the hanging rail

and shelf studs

Push the hanging rail

into the rail holders

fitted to the side panels.

Push the 2 shelf studs

up into the holes in the

top to act as door

buffers.

Assembly Instructions

Step 10

Step 11

Prepare the 2 doors

Push fit 3 hinges into

each of the 2 doors .

Secure each hinge with

2 screws .

Note: Before securing

with the screws, make

sure that the hinges are

positioned at 90 degrees

with the edge of the

door.

x 2

Assembly Instructions

Step 12

Fit doors and handles

Note: The easiest way to

attach each door is

to fit the top hinge first,

then align and fit the

other hinges.

a: Push the hinge

onto the front part of the

hinge plate .

The recess at the bottom

of screw B goes into the

slot in the hinge plate.

b: Keep the hinge

FLAT against the hinge

plate as you slide it

across as far as it will go.

Tighten screw A.

c: The hinge must be

flat against the hinge

plate prior to any

adjustment.

d: The hinge must

NOT be AT AN ANGLE

to the hinge plate

when assembled.

This would indicate that

the recess at the bottom

of screw B had not

located in the slot in the

hinge plate and the hinge

would not be secure.

Remove the hinge from

the hinge plate and then

re-assemble being

careful to follow

instructions a-c.

e: Attach a handle to

each door using 2

screws .

a: b:

c: d:

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 620/4721 Bedienungsanleitung

Argos

Argos Sit N' Sleep Bed Bedienungsanleitung

Argos

Argos 906/4023 Bedienungsanleitung

Argos

Argos WOW RATTAN EFFECT MINI CORNER 6174954 Bedienungsanleitung

Argos

Argos hygena 385/9715 Datenblatt

Argos

Argos Monk’s Bench Style Linen Bin 832/5299 Bedienungsanleitung

Argos

Argos 609/2263 Bedienungsanleitung

Argos

Argos Hygena Large Fabric Ottoman Bedienungsanleitung

Argos

Argos 837/9221 Bedienungsanleitung

Argos

Argos Venetia 630/3505 Bedienungsanleitung

Argos

Argos Puerto Rico 368/9277 Bedienungsanleitung

Argos

Argos Lydiard Gloss 2008952 Bedienungsanleitung

Argos

Argos Vegas 600/6479 Bedienungsanleitung

Argos

Argos hygena 464/3597 Bedienungsanleitung

Argos

Argos Single Metal Futon Bedienungsanleitung

Argos

Argos New Sywell 282/7920 Bedienungsanleitung

Argos

Argos Penton 483/0616 Bedienungsanleitung

Argos

Argos Sywell 615/8482 Bedienungsanleitung

Argos

Argos Pacific 6 Seater Patio Set 651/1531 Bedienungsanleitung

Argos

Argos 603/1822 Bedienungsanleitung

Argos

Argos HOME 466/3175 Bedienungsanleitung

Argos

Argos Athina 500 Tall Cupboard Bedienungsanleitung

Argos

Argos Wow Lima 600/6503 Bedienungsanleitung

Argos

Argos Camden 305/0772 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung