Aries 203039 Bedienungsanleitung
ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •203039-INS-RB •PAGE 1
INSTALLATION MANUAL 203039
Parts List
1Driver / left side bar
1Passenger / right side bar
1Driver / left side front bracket
1Driver / left side rear bracket
1Passenger / rear side front bracket
1Passenger / rear side rear bracket
8Hex bolt, M8
8Flat washer, M8
8Lock washer, M8
8Clip nut, M10
16 Hex bolt, M10
16 Flat washer M10 - large
8Flat washer M10 - small
16 Lock washer, M10
8Hex nut, M10
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Socket set
Torque wrench Wrench set
Level --
Level of Difficulty
Easy
Product Photo
Front
Rear
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the last page of this manual for troubleshooting,
warranty and product registration information.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.
ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •203039-INS-RB •PAGE 2
Step 1
Starting on the driver side, locate
the two mounting locations along
the bottom edge of the vehicle.
Make sure to use one bracket with
one cradle facing left and one facing
right for each side of the vehicle. The
cradles will face inward.
Note: The front brackets are
shorter than the rear brackets.
Step 4
Place the driver-side side bar onto the
brackets and secure with four M8 bolts,
lock washers and flat washers.
Snug the hardware,
but do not fully tighten.
Note: The mounting holes in the board
that are closest to the end of the board
should face the front of the vehicle
Step 2
Starting at the front driver-side mounting
location, remove tape and insert two M10 clip
nuts into the rectangular hole. Align them over
the adjacent round holes.
Place a bracket onto the vehicle and secure
the top portion with two M10 hex bolts, lock
washers and flat washers.
Snug the hardware,
but do not fully tighten.
Step 3
Secure the front mounting bracket to the
vehicle by inserting two M10 hex bolts and
flat washers from the bottom side of the
bracket and two M10 lock washers, small
flat washers and hex nuts on the top side.
Snug the hardware,
but do not fully tighten.
Repeat steps two and three
to install the rear bracket.
ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •203039-INS-RB •PAGE 3
Step 5
At this time, adjust the
side bar to the desired location.
With the side bar in position, it is recommended
to tighten all brackets to the vehicle first,
followed by the side bar connections.
For recommended torque specifications,
refer to the table on page one.
Repeat steps one through five
on the passenger side of the vehicle.
Step 6
Congratulations on the installation
of your new ARIES 3" round side bars.
With the side bars installed,
periodic inspections should be
performed to ensure all mounting
hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
second page of this instruction manual.
Andere Aries Autozubehör Handbücher
Aries
Aries S223005 Bedienungsanleitung
Aries
Aries 2074140 Bedienungsanleitung
Aries
Aries S224046 Bedienungsanleitung
Aries
Aries B35-2000 Bedienungsanleitung
Aries
Aries Pro Series Bedienungsanleitung
Aries
Aries 203015 Bedienungsanleitung
Aries
Aries 4499 Bedienungsanleitung
Aries
Aries 2074111 Bedienungsanleitung
Aries
Aries 4092 Bedienungsanleitung
Aries
Aries 2162001 Bedienungsanleitung
Aries
Aries 204032 Bedienungsanleitung
Aries
Aries 1500302 Bedienungsanleitung
Aries
Aries 203046 Bedienungsanleitung
Aries
Aries 1110315 Bedienungsanleitung
Aries
Aries P3067 Bedienungsanleitung
Aries
Aries 2074110 Bedienungsanleitung
Aries
Aries S225044-2 Bedienungsanleitung
Aries
Aries S224045 Bedienungsanleitung
Aries
Aries 2081205 Bedienungsanleitung
Aries
Aries S223015 Bedienungsanleitung
