Blodgett BTT-16E Bedienungsanleitung

BTT-16E

ROUND ELECTRIC TABLETOP BRAISING PAN

INSTALLATION – OPERATION –MAINTENANCE

BLODGETT OVEN COMPANY

www.blodgett.com

44 Lakeside Avenue, Burlington, Vermont 05401 USA Telephone (800) 331-5842, (802) 860-3700 Fax: (802) 864-0183

S00065 Rev B (2/05)

IMPORTANT NOTES FOR INSTALLATION AND OPERATION

It is recommended that this manual be read thoroughly and that all instructions be

followed carefully.

This is the safety alert symbol. It is used to alert you to potential

personal injury hazards. Obey all safety messages that follow this

symbol to avoid possible injury or death.

WARNING: Improper installation, operation, adjustment, alteration,

service or maintenance can cause property damage, injury or death.

Read the installation, operating and maintenance instructions

thoroughly before installing, operating or servicing this equipment.

NOTICE: Contact the factory, the factory representative or local service

company to perform maintenance and repairs.

Do not attempt to operate this unit in the event of a power failure.

Adequate clearances must be maintained for servicing and proper operation.

This manual should be retained for future reference.

TABLE OF CONTENTS

DESCRIPTION PAGE

Important Notes for Installation and Operation ............................................................... 2

1.0 Service Connections ................................................................................................ 4

2.0 Installation ................................................................................................................ 5

3.0 Cleaning Instructions ................................................................................................. 6

4.0 Operation Instructions .............................................................................................. 7

5.0 Troubleshooting ....................................................................................................... 8

1.0 SERVICE CONNECTIONS

0.75 [19]

MIN CLEARANCE

POUR PATH 16 [406]

8.75[222]

43.25 [1099]

9 [229]

3.88 [98]

6.38 [162]

21 [533]

29 [737]

14.63 [371]

29.25 [743]

3.63 [92]

1.25 [32]

12.50 [318]

29.25 [743]

10 [254]

2.25 [57]

14.50 [368]

4X WELD NUTS

5/16-18 UNC

FRONT OF APPLIANCE

MOUNTING PATTERN

REAR FLANGED FOOT DETAIL

7/16" [11mm] HOLES

ON 2.25 [57] B.C.

2 EQUALLY SPACED

10.5 [267]

20.5 [521]

Ø26 [660] ID

22.88 [581]

38.75 [984]

59.25 [1505]

7.25 [183]

Dimensions are in inches [mm].

Shown with optional stand.

ELECTRICAL CONNECTION: to be specified on data plate.

DRAIN: 1 1/2"- 11 1/2 NPT

2.0 INSTALLATION

1. Position appliance on counter allowing sufficient rear clearance from wall to tilt freely

and completely without obstruction.

2. Mark four corner locations of appliance base, as shown below.

3. Remove appliance from counter and locate position of four holes as per above

drawing. Drill four 7/16" diameter holes.

4. Apply a continuous bead of Silastic or other equivalent sealant along the complete

perimeter edge of the appliance base.

5. Use 5/16-18 Hex Cap Screws with suitable flat washer to bolt down. Screw length

must be 1-1/4 long plus counter top thickness.

6. Wipe off excess sealant.

7. A Control Box with power supply equivalent to Electrical Rating of appliance should

be located conveniently nearby.

8. A waterproof electrical connection for power supply to console housing must be

provided.

9. Ground appliance to terminal provided inside console housing.

10. Turn power ON and check for proper operation.

29-1/4 [743]

12-1

2 [318]

[

254

]

1-1/4 [31]

2-1/4 [57]

14-1/2 [368]

IN [MM]

FRONT OF APPLIANCE

3.0 CLEANING INSTRUCTIONS

NOTICE: As a safety precaution disconnect the power supply during

cleaning and servicing.

The Electric Counter Tilting Skillet should be cleaned after each use.

Soak cooking surface with water and a mild soap to remove any food stuck to surface.

Wash entire unit surface with mild detergent and water. Rinse entire unit and dry. All

accessories such as cover should also be cleaned as instructed above.

WARNING: Do not get water in electrical components.

WARNING: It is not recommended to use cleaning agents that are

corrosive.

Use of cleaning agents that contain, chloride, acids or salts or other

corrosive substances may cause pitting and corrosion when used

over a period of time. This will reduce the life of the appliance.

Should pitting or corrosion occur this is not covered by warranty.

Follow the recommended cleaning instructions: Use a mild

detergent, warm water and rinse thoroughly.

Never spray water into electrical controls.

4.0 OPERATION INSTRUCTIONS

1. Ensure that unit has been electrically connected and that circuit breakers are on.

2. Place power switch in “ON” position.

3. Set the thermostat dial to high (#10).

4. Preheat the unit and allow it to cycle thus equalizing heat across the entire surface.

5. Cooking should be done at varius temperature settings on the dial as determined by

the user.

6. Water will boil faster with use of the optional cover.

7. At end of cooking, return thermostat to “OFF” position, turn power switch “OFF”, and

remove food. Put a small amount of water in the pan and allow to soak for ease of

cleaning.

THERMOSTAT SETTINGS

Simmering 1 - 4 (200EF)

Sautéing 5 - 6 (225 - 275EF)

Searing 7 - 8 (300 - 350EF)

Pan Frying 8 - 9 (325 - 375EF)

Grilling 9 - 10 (350 - 425EF)

CAUTION: When tilting pan to remove contents take care not to tilt

too far too fast as contents are hot and may splash on the operator

causing injury.

5.0 TROUBLESHOOTING

Unit will not operate:

1. Power supply not “ON”.

2. Defective thermostat or elements.

Hot spot on pan bottom.

1. Element not operating. Check for defective element or wire termination.

Pan difficult to operate:

1. Dirt in oilite bearings causing it to bind.

Andere Handbücher für BTT-16E

Inhaltsverzeichnis

Andere Blodgett Küchengerät Handbücher

Blodgett

Blodgett BLT-30E Bedienungsanleitung

Blodgett

Blodgett BLT-30E Bedienungsanleitung

Blodgett

Blodgett BCS-8E Bedienungsanleitung

Blodgett

Blodgett SB-10E-6-6K Bedienungsanleitung

Blodgett

Blodgett BCH-30E Bedienungsanleitung

Blodgett

Blodgett SN-5G Bedienungsanleitung

Blodgett

Blodgett SB-10E-6K Bedienungsanleitung

Blodgett

Blodgett SB-10SC Betriebsanleitung

Blodgett

Blodgett SN-3E Betriebsanleitung

Blodgett

Blodgett SB-10G-6-6K Bedienungsanleitung

Blodgett

Blodgett SB-10G Bedienungsanleitung

Blodgett

Blodgett SN-5G Bedienungsanleitung

Blodgett

Blodgett SN-5G Bedienungsanleitung

Blodgett

Blodgett BTT-12E Bedienungsanleitung

Blodgett

Blodgett E-SB Series Betriebsanleitung

Blodgett

Blodgett BTT-16E Bedienungsanleitung

Blodgett

Blodgett BLP-30E Betriebsanleitung

Blodgett

Blodgett BCH-30E Betriebsanleitung

Blodgett

Blodgett SC-10GH Bedienungsanleitung

Blodgett

Blodgett BLG-30E Bedienungsanleitung

Blodgett

Blodgett BLT-30E Betriebsanleitung

Blodgett

Blodgett BTT-12E Bedienungsanleitung

Blodgett

Blodgett 1048 Anwendungshandbuch

Blodgett

Blodgett SC-10G Bedienungsanleitung

Beliebte Küchengerät Handbücher anderer Marken

Tayama

Tayama TYG-35AF Bedienungsanleitung

AEG

AEG 43172V-MN Bedienungsanleitung

REBER

REBER Professional 40 Benutzerhandbuch

North American

North American BB12482G / TR-F-04-B-NCT-1 Bedienungsanleitung

Presto

Presto fountain popper Bedienungsanleitung

Westmark

Westmark 1035 2260 Bedienungsanleitung

Zanussi

Zanussi ZCG64396XA Bedienungsanleitung

HOFFEN

HOFFEN SM-9302M Bedienungsanleitung

Philips

Philips HD3133 Bedienungsanleitung

Ronco

Ronco Beef Jerky Bedienungsanleitung

Hendi

Hendi 470411 Bedienungsanleitung

Livoo

Livoo MEN386 Bedienungsanleitung

croydon

croydon WR-10313-700 Bedienungsanleitung

Chefman

Chefman RJ43-SQ Series Bedienungsanleitung

Vacmaster

Vacmaster VP680 Bedienungsanleitung

Jetmaster

Jetmaster 900HG Bedienungsanleitung

Küppersbusch

Küppersbusch EEH 610.0 Kurzanleitung zur Einrichtung

HURAKAN

HURAKAN HKN-F10 Bedienungsanleitung